Top-Rated Free Essay
Preview

89521039 ATPLessentials Mass And Balance

Good Essays
1055 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
89521039 ATPLessentials Mass And Balance
Mass refers to the quantity of matter in a body as measured by its inertia

Holiday Charter

Mass & Balance 1

• Mass of individual Pax may be determined from a verbal statement

Other

by or on behalf of the pax if < 6 seats available

• Considerable amout of pax or baggage exceeding the standard

Infant (0y ...2y)

masses: Operator should use individual masses or add an adequate mass increment
• Weighing machine for pax: Capacity ≧150kg; graduations of 500g
• Max weight of cabin crew in 19-seat AC on Holiday Charter = 75kg
• Baggage = Personal belongings
• Standard mass for baggage (15kg) may be used if >20 seats
• If no carry-on baggage is carried: Subtract 6kg from standard masses 35kg; 1seat

Child (2y ...12y)

♂ 83kg

♀ 69kg

Adult

84kg

or avg. of 76kg

Limitations
Structural

Performance

Other

Limiting in “Hot & High” conditions

Regulated TOM = Lower of both structural and performance limited TOM

= MRM
• Maximum certified Ramp (or Taxi) Mass
• Mass an AC may be loaded prior to engine start
• Fixed value listed in AC Flight Manual

Definitions

Ramp Mass - RM

Taxi Fuel

Takeoff Mass - TOM

= MTOM
• = max. permissible total AC mass @ start of TO run
• May not be exceeded on any TO
• Normally the limiting factor on TL on long distance flights Traffic Load
(TL)
Useful Load (UL)

• Trip Fuel (TF)

Operating Mass - OM

Takeoff
(useable)
fuel (TOF)

• Usable TOM: Consider MLM + Fuel burn

Takeoff
(useable)
fuel (TOF)

Landing Mass - LM

• If exceeded, undercarriage could collapse on LDG

• Contingency
• Alternate
• Final reserve
• Passengers
• Cargo

Traffic
Load
(TL)

= MLM

Zero Fuel Mass - ZFM

= MZFM



• Structural limit due to max permissible bending moment

AC mass with no USEABLE fuel

If AC < max. structural LM but
> max. performance limited LM:

• Tire temperature limits could be exceeded
• Runway may be too short
• No go-around possible
•Structural fatigue increased

•Limited by strength of runway
•Amount of fuel to jettison: To a safe level at or below regulated
Landing Mass

@ wing root (on AC without central tank)

• Imposes fuel dumping from the inner wing tank first
• Regulatory limitation
• Calculated for a LF of +2.5g
• Fixed value stated in AC Operating Manual
•Limiting factor on TL on short legs with minimum fuel

• Operator must establish

TL by actual weighing or in accordance with standard masses specified in JAR-OPS
Part J

Dry Operating Mass - DOM
Standard Masses:

Crew

• Flight Crew = 85kg
• Cabin Crew = 75kg
• Incl hand baggage allowance Responsibility for determination lies with the operator!

Aircraft must be weighed:



Includes fixed equipment needed to carry out a specific flight
AC mass ready for a specific type or operation • Crew baggage

Operating • Catering
• Removable pax equipment
Items
• Potable water
• Lavatory liquids

Weighing



Specific equipment integral to the particular aircraft configuration

• On initial entry into service
• If the mass and balance records have not been adjusted for alterations

Basic Empty Mass - BEM




or modifiactions

• Whenever the cumulative changes to the dry operating mass exceed plus or minus 0.5% of the maximum landing mass

• If the cumulative change in CG position exceeds 0.5% of the MAC
• If individual masses are used the mass of an aeroplane must be


determined prior to initial entry into service and thereafter at intervals of
4y if no modifications have taken place.
Where an operator uses "fleet masses" and provided that changes have been correctly documented, this interval is 9y for each aeroplane.

• It is not required to drain all engine tank oil or fuel tanks
• Must take place in an enclosed, non-air conditioned hangar
• With a minimum of three points of support
• Aeroplane has to be clean and equipment complete for weighing

Unusable fuel +
Full Operating Fluids
Furnishings



= Weighed Mass
Determined by manufacturer
Found in the latest version of the weighing schedule as corrected to allow for modifications Is amended to take account of changes due to modifications of the AC

Calculation of Max. Masses for TO & LDG

Standard Empty Mass

Systems
Power Plants
Aeroplane Structure

Limiting Structural TOM = (minimum of:
Payload (=TL) = (

TF
TOF
MTOM
+MLM +MZFM
--------------------------------------...
...
... )
- || -

) - DOM - TOF

Mass & Balance 2
The Datum is the point on the aeroplane designated by the manufacturers from which all
CG measurements and calcuations are made.
Its position is given in the aeroplane Flight or Loading
Manual.
It is located at a convenient point which may not physically be on the aeroplane. The datum is a fixed vertical plane from which all the arm distances are measured

CG in %MAC is the location of CG in relation to the Mean
Aerodynamic Chord of the wing.
Loads must be adequately secured in order to avoid
0%
unplanned CG movement and aircraft damage.

CG (MAC) =

Center of Gravity (CG)
•= the point of a body through which the sum of the forces of all masses is considered to act
•= the point where all the aircraft mass is considered to be concentrated Changing tailplane incident angle does not change CG position! Total MAC

MAC
50%

25%

75%

100%

CG

LE

CG location is calculated/measured along the longitudinal axis

Distance: Leading Edge (LE) - CG

range is between front and rear CG
[ CG safelimits
]
and includes both limits

A location in the aeroplane, identified by a number designating its distance from the datum =
A Station

Standard CG Calculation Walkthrough
1.Calculate Moment = Arm * Force for all stations
2.Add up all moments => Total Moment (taking out weight = negative Moment!)
3.Add up all forces (weights) => Total Weight
4.Calculate CG position with Arm = Total Moment / Total Weight

Weight
•Acts in a direction parallel to the gravity vector
•On ground or in level, non accelerated flight vertically through
CG

Units
•If the actual fuel density is not known, conversion from volume to mass can be done by using std. fuel density according to the
OM
•1US.gal. = 3.785l
= 0.833Imp.gal.
= 6lbs AVGAS
•1kg = 2.2lb

Moment
• All moments turning clockwise arund datum are positive;
• If all moments given are positive, the datum must be at the nose or in front of the AC

=

Arm
= Moment Arm
= Balance Arm
= Horizontal distance from Datum to CG

*

Force use N or kg consistently! Other
•Once the mass and balance documentation has been signed prior to flight, acceptable last minute changes to the load must be documented
•Index Method: In Mass and balance calculations the index is the moment divided by a constant

!!!

s dea or
F
e ac p
S
re o M

rI u Yo

You May Also Find These Documents Helpful

  • Satisfactory Essays

    Basic disks enable you to create simple volumes and then extend or shrink them as needed.…

    • 518 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    Molar Mass Lab

    • 423 Words
    • 2 Pages

    The purpose of the practical that we completed was to determine the molar mass of carbon dioxide (CO2) by experimental means and to observe the reaction of hydrochloric acid and sodium carbonate. Using the balanced equation:…

    • 423 Words
    • 2 Pages
    Good Essays
  • Satisfactory Essays

    Physiology Unit 9

    • 508 Words
    • 3 Pages

    Larynx- Voice box. The epiglottis helps to prevent food from entering the larynx during swallowing. Short passageway.…

    • 508 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    9/22/2011 Basic Chemistry Why are we studying chemistry? • Biology has chemistry at its foundation Elements • All matter composed of basic substances called elements • Living organisms require about twenty of the known elements Together, carbon, hydrogen, nitrogen and oxygen make up 95% of the elements found in the body. Atoms • All elements made of tiny particles called atoms • Made up of: – Nucleus • contains protons (+ charge) and neutrons (no charge) – Outside the nucleus • Contains electrons (extremely small, - charge) – In an atom, # of protons =…

    • 1207 Words
    • 12 Pages
    Good Essays
  • Good Essays

    physiology 209

    • 1019 Words
    • 5 Pages

    we will use it to attack 1-bromobutane (our alkyl halide) to form 1butyl-3-methylimidazolium bromide. We will refer to this molecule…

    • 1019 Words
    • 5 Pages
    Good Essays
  • Good Essays

    Molar Mass Lab

    • 709 Words
    • 3 Pages

    There are several ways to find the molar mass of a substance. One way, if the substance is a gas, is to use the Ideal Gas Equation to find molar mass. The standard equation reads PV=nRT where “n” is the number of moles present, “P” is the pressure (which is obtained by reading the barometric pressure of the room with the class barometer), “V” is the volume of the gas, “R” is the universal constant, and “T” is the temperature of the gas. The experiment’s objective is to calculate the experimental value of molar mass of a volatile liquid through the process of heating (to form a gas, and thus use the ideal gas law to calculate the molar mass), and compare the results to the accepted value for the analysis of accuracy. This can be achieved by substituting the mass of the substance over the molar mass of the substance for “n”: m/M=n. The liquid heated to a gas is methanol, which has an accepted value for molar mass of 32.05g/mol.…

    • 709 Words
    • 3 Pages
    Good Essays
  • Better Essays

    An example of how enzymes work within the body is the breakdown of fructose. Energy obtained from carbohydrates goes through a process called glycolysis. Glycolysis a series of biochemical reactions in which one glucose molecule is oxidized into two pyruvic acid molecules and a small amount of adenosine triphosphate (ATP). Generation of high energy molecules are used as cellular energy sources in aerobic and anaerobic respiration. The products formed through glycolysis usually enter into the citric acid cycle and the electron transport chain to produce more energy. Fructose enters the glycolytic pathway through the liver or skeletal muscle. For example, in the liver, fructose is phosphorylated by the enzyme fructokinase to fructose-1 phosphate. The six carbon fructose is split into three carbon molecules, glyceraldehyde and dihydroxyacetone phosphate.…

    • 1453 Words
    • 6 Pages
    Better Essays
  • Satisfactory Essays

    1. What is the coefficient for oxygen when the following equation is balanced using the lowest, whole numbered coefficients?…

    • 483 Words
    • 4 Pages
    Satisfactory Essays
  • Good Essays

    Donald, Rizzo C. "Cellular Metabolism." Fundamentals of Anatomy and Physiology. 3rd ed. New York: Delmare, 2010. 64-70. Print.…

    • 1118 Words
    • 5 Pages
    Good Essays
  • Good Essays

    The Marvelous Mitochondria

    • 1117 Words
    • 5 Pages

    According to Dr. Kravitz in his article called “The Marvelous Mitochondria” The Mitochondria was discovered in 1890 by a German cell Biologist Richard Altmann under the name of bio blasts. He first theorized that the bio blasts had metabolic and genetic self-sufficiency characteristics. Years later, it was given a name change by another German Biologist, Karl Benda, to the name of Mitochondria.…

    • 1117 Words
    • 5 Pages
    Good Essays
  • Good Essays

    The body needs an increased cardiac output during exercise because the increased consumption of oxygen and nutrients by muscle cells requires more blood supply.…

    • 341 Words
    • 2 Pages
    Good Essays
  • Good Essays

    The ATP molecule is composed of three components. At the centre is a sugar molecule, ribose (the same sugar that forms the basis of RNA). Attached to one side of this is a base (a group consisting of linked rings of carbon and nitrogen atoms); in this case the base is adenine. The other side of the sugar is attached to a string of three bonded phosphate groups. These phosphates are the key to the activity of ATP. Especially, the bond between the last phosphate and second to last phosphate is very unstable and when broken releases a very large amount of energy, which is essential to all life processes.…

    • 697 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Adenosine Triphosphate, also known as ATP, is the molecule responsible for the energy that we, and all other organisms, need to survive. It is produced primarily in the processes of aerobic and anaerobic respiration by oxidative and substrate phosphorylation.…

    • 1007 Words
    • 5 Pages
    Good Essays
  • Satisfactory Essays

    There are noted differences between air cargo and the passenger business. For example, unlike passengers, cargo shippers did not book round trips and therefore cargo flows were unpaired. Furthermore, cargo was classified according to multiple dimensions like volume and weight resulting in different pallet space requirements, while passengers were each assigned a single seat. Concerning manageability it was identified that with regard to network planning and capacity allocation, cargo carriers had more degrees of freedom and hence faced additional challenges compared to passenger airlines. However, while passengers purchased tickets for specific flights and routes, cargo airlines could transport goods flexibly with regard to time and route through their network, the only constraint being the promised time of availability at the destination. Moreover, the load could be balanced and optimized by mixing shipments with different specific weights i.e., volume-to-weight relations. In this regard, space could be sold twice, e.g. to one customer with voluminous and another with heavy-weight high-density goods.…

    • 547 Words
    • 3 Pages
    Satisfactory Essays
  • Powerful Essays

    E190 Upgrade Guide Version 1

    • 9939 Words
    • 79 Pages

    E-190 Captain Upgrade Guide (Unofficial) Version 1 By Jovan O’Bryant EMBRAER 190 CAPTAIN UPGRADE STUDY GUIDE E-190 Captain Upgrade Guide (Unofficial) VERSION 1 This guide was created with the intent of being for reference only and in JetBlue’s official training material!…

    • 9939 Words
    • 79 Pages
    Powerful Essays

Related Topics