Preview

Distillation Of Hexane Lab Report

Good Essays
Open Document
Open Document
270 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Distillation Of Hexane Lab Report
In experiment 5, distillation method was used to divide hexane and toluene from a mixture (50:50) of hexane and toluene. Hexane was separated from toluene and was observed from the gas chromatography, it showed that hexane increased from 0.0.873 to 0.886 moles. Once the mixture of toluene and hexane hit 70 degrees in the experiment, the distillate was used for the gas chromatography. Hexane was higher in the distillate stage. The first drop of condensation appeared at 79°C. The volume of the distillate was 0.88ml and 0.98ml for the residue volume. The initial mixture had a volume ratio of 48.7% for toluene and 51.3% for hexane. The ratio for volume was determined for the distillate and residue. The distillate percent volume ratio for hexane

You May Also Find These Documents Helpful

  • Powerful Essays

    Objective: The main goal of this lab is to learn how separation of binary liquid mixtures is performed. Especially when the two liquids have boiling points varying by about 30° C. Hexane can be separated from toluene in this experiment because of the difference in their boiling points. Since toluene has a higher boiling point, it will left at the bottom while the hexane starts to boil out and collect in the Hickman still. GC measurements help us in determining how accurate our data is by making a graph of the amount of hexane and toluene in each fraction. Also this lab gives experience with semi-micro distillation in order for experiments in the future that might need this purification setup.…

    • 1041 Words
    • 5 Pages
    Powerful Essays
  • Good Essays

    Distillation Lab Report

    • 418 Words
    • 2 Pages

    Conclusion: During this lab I learn how to do simple and fractional distillation. Although the group I worked with only did simple distillation, I carefully observed how the group that did the fractional distillation. We collected all the results, to have a more precise range on what the results were. One way to produce an error in this process would have been if our procedures were done wrong or reversed or if we placed the compounds in a improper…

    • 418 Words
    • 2 Pages
    Good Essays
  • Good Essays

    The goal of this experiment was to separate Toluene and Hexane by distillation and gas chromatography based on their difference in boiling points. The boiling point of hexane is 69 degrees Celsius and the boiling point of toluene is 110 degrees Celsius. Three fractions were collected for both simple and fractional distillation. The first fraction was hexane since it had the lower boiling point. The second fraction was a mixture of toluene and hexane. The third fraction was toluene since it had the high boiling point of 110 degrees Celsius. Gas chromatography was also preformed on each of the fractions from simple and fractional distillation. In the gas chromatography process, the compounds are carried through a stationary phase, and pushed…

    • 395 Words
    • 2 Pages
    Good Essays
  • Powerful Essays

    The basic purpose of this experiment is to carry out the dehydration of an alcohol and isolate the reaction products by distillation. Gas Chromatography will be utilized to analyze the reaction mixture.…

    • 896 Words
    • 4 Pages
    Powerful Essays
  • Good Essays

    During the reflux period, there have not been any signs of errors; the reflux distillation process occurred smoothly. Once reflux distillation was completed, the mixture was cooled to room temperature, then extracted thrice by a separatory funnel. Before any extractions proceeded though, the mixture already had two distinct layers – a top dark brown layer, and a bottom light yellow layer. This mixture was extracted with 9M sulfuric acid, and the aqueous layer, containing butanol, sulfuric acid, and water, was removed and discarded. The organic layer, consisting of the n-butyl bromide, went through a second extraction with water. This resulted in an organic layer of n-butyl bromide and water and an aqueous layer of water and a little amount of alcohol, which was discarded. The organic layer was then dried by extracting it with sodium bicarbonate; this is an extra step for drying the alkyl halide. The resulting organic layer contained the crude n-butyl bromide, and the drying procedure was completed by adding anhydrous calcium chloride until the solution turned clear. The drying agent was used to absorb any excess water and thus, resulted in a clear solution of n-butyl…

    • 768 Words
    • 4 Pages
    Good Essays
  • Better Essays

    DIals Alder

    • 733 Words
    • 3 Pages

    To a 100 mL flask, 22 mL of Diclopentadiene was added and arranged for fractional distillation into an ice-cooled receiver. In order for the diene to distill, heat was applied to the dimer with a microburner. Into a 50 ml round bottom flask boiling chips were added before starting the distillation . Within about 5 mins while reaching a steady boiling point…

    • 733 Words
    • 3 Pages
    Better Essays
  • Good Essays

    The experiment started by gathering the supplies for distillation. In the vial, 2mL of 2-methylcyclohexanol and 1mL of phosphoric acid is added. The solvents are thoroughly mixed and a few boiling chips is added to help with the…

    • 1090 Words
    • 5 Pages
    Good Essays
  • Good Essays

    O Chem

    • 729 Words
    • 3 Pages

    Distillation has been used since antiquity to separate the components of mixtures. This method has been used to manufacture different organic chemicals but the most recent application is the refining of petroleum in order to produce fuels, lubricants and petrochemicals. In this experiments, the separation of 2 distilates were carried out using the differences in boiling points and the data was used for a gas chromatography test.…

    • 729 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Background: Distillation consists of heating a liquid until it vaporizes, and then condensing the vapor and collecting it in a separate container. Distillation is used to separate mixtures of liquids that either have different boiling points, or that have one component that does not distill. There are many types of distillation, each of which has a distinct purpose. Steam distillation is used to isolate volatile substances that have high boiling points. When two immiscible liquids are distilled together, the amounts of each component in the distillate are constant. Also, the boiling point of the mixture is lower than that of either of the individual components. This is because the components do not have compatible intermolecular forces, and so the component in lesser concentration will form “bubbles”, like oil droplets in water, weakening the overall intermolecular forces in the mixture, and thus lowering the boiling point. This process allows high- boiling compounds, which can decompose before they boil if heated alone, to be distilled at temperatures below 100°C. Once the liquid mixture is heated to its boiling point, the liquid is converted to vapor. The vapors, richer in a more volatile component, are then condensed into a separate container.…

    • 635 Words
    • 3 Pages
    Good Essays
  • Good Essays

    The Simple and Fractional distillation experiment was divided into two parts. We split up the procedure in this experiment. My group did the simple distillation and we received the Fractional distillation from another group in class. In this experiment, we examined the effectiveness of fractional and simple distillation to determine which is more successful at extracting a pure sample. This experiment was very successful. We are able to determine the success of the experiment but calculating refractive index of both types of distillation.…

    • 274 Words
    • 2 Pages
    Good Essays
  • Good Essays

    There was distillation of liquid in the lower ranges of around 30°C-40°C. This indicates that there was no side reactions, as none of the side product was retrieved. Liquid distill at about 82.8°C, which indicates that 2-chloro-2-methylbutane was the only product of this reaction. The theoretical yield was calculated using 2-methyl-2-butanol as the limited reagent in the reaction, and was found to be 7.80 grams of 2-chloro-2-methylbutane. The experimental yield that was retrieved was found to be much less, at 1.84 grams.…

    • 310 Words
    • 2 Pages
    Good Essays
  • Good Essays

    Analysis via gas chromatography allowed us to determine the relative percentage of hexane and toluene at fractions near the beginning and end of our distillations. Relative percentages have been recorded in the table below, and our calculations are shown on page 5.…

    • 692 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    Arranged a fractional distillation apparatus used a 100mL round-bottomed flask for the solution and used a 50mL round- bottomed flask cooled in ice an ice bath as the receiver of the reaction. The 65% sulfuric solution was prepared in a clean 125mL Erlenmeyer flask it contained 20.0 mL of deionized water and 20mL of concentrated sulfuric acid was added carefully with some swirling in between. The diluted acid was cooled with an ice water bath to 20-25ºC. to the cooled sulfuric acid cyclohexanol was added carefully and slowly with swirling as well. The reaction mixture cooled 65% sulfuric acid was transferred to the 100mL round-bottomed flask through a glass funnel, three boiling stones were added to the mixture and the distillation started.…

    • 338 Words
    • 2 Pages
    Satisfactory Essays
  • Powerful Essays

    This process is used to concentrate alcoholic beverages and the one used in this experiment is vodka. As this experiment is to separate water from ethanol in the vodka sample, distillation process was done. However, since the group encountered difficulties and errors in preparing the set-up, the results obtained were partial; leaving the experiment itself unsuccessful. However, the results that should have been acquired showed the difference of boiling point of ethanol and water leading them to complete separation through the distillation process.…

    • 952 Words
    • 4 Pages
    Powerful Essays
  • Better Essays

    Distillation is the most common technique, it is a process wherein the liquid is separated from the solution by boiling the liquid solution and condensing the vapor in order to get the distillate. There are four kind of distillation: simple distillation, fractional distillation, vacuum distillation and steam distillation. Simple distillation is the process wherein the pure liquid is separated from the solution with different boiling points. 20mL of Vokda (Antonov) was placed in a pear-shaped distilling flask for heating until the solution boils, the maximum boiling point of it was 100°C. The pure liquid turned into a vapor and left the distilling flask. The vapor then was condensed in the condenser and turned into a distillate. The distillate was collected in a calibrated and numbered test tubes and the temperature was recorded as well. The group was able to acquire 22.50% of ethanol in the compound and got 22.50% of error in the simple distillation experiment.…

    • 1448 Words
    • 6 Pages
    Better Essays