Preview

Does Electricity Move Better Through Thick Wires or Thin Ones

Good Essays
Open Document
Open Document
448 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Does Electricity Move Better Through Thick Wires or Thin Ones
My research is to determine if electricity moves better through thick wires or through thin wires. For this experiment I used two size D batteries, two flashlight bulbs, one 6.5 inch thin steel wool piece, one 6.5 inch thick steel wool piece, two 2 inch pieces of straw, and some electrical tape. Steel wool is a material made from thin fibers of steel made into a pad. (http://www.wisegeek.com/l-what-is-steel-wool.htm) There are many uses for steel wool. It can be used for sanding furniture, removing paint finishes; it can be used as a scouring pad for pots and pans and as rodent control. (http://wisegeek.com/what-are the-different-uses-for-steel-wool.htm) For this experiment it was used as a conductor of electricity. (http://ehow.com/list_6545332_electrical-properties-steel.html) The batteries were used to provide power for the light bulbs. The steel wool pieces were used for transferring the electricity used to power the light bulbs. Each of the steel wool pieces were taped to the negative side of the batteries. The other ends of the steel wool wires were taped to the base of the light bulbs. The light bulbs were then lit by placing the bulbs on the positive side of the batteries. I did this experiment five times for each steel wool piece. I set a timer for one minute and turned the light off in my room to see which light bulb would be brighter. After the first minute was over the light bulb with the thin wire was brighter than the light bulb with the thick wire. During the second minute the light bulb with the thick wire ended up being brighter. In the third minute the bulb with the thin wire was brighter than before. The light shining from bulb with the thick wires stayed the same. After the fourth minute was over the bulb with the thin wires became dull. The bulb with the thick wires did not change. Lastly after the fifth minute both bulbs stayed the same. After comparing this data I think that electricity works better through thick

You May Also Find These Documents Helpful

  • Satisfactory Essays

    ECT122 W1 ILab 2

    • 302 Words
    • 2 Pages

    A conductor is made of materials that have little opposition to the flow of charge. A conductor is made of metals like copper, silver, aluminum or gold. These types of metals allows for the easy flow of electrons. Wires are made of these materials.…

    • 302 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    In part 3 of the lab 20 drops of HCl were added to a test tube with a small zinc piece. It was then heated with a lit wooden splint in the opening. Also in part 3 of the experiment a small piece of steel wool was added to a test tube with 10 mL of 0.6M copper sulfate.…

    • 857 Words
    • 4 Pages
    Good Essays
  • Good Essays

    Reprocudtive Health Bill

    • 1286 Words
    • 6 Pages

    Many coins in the pile will make the most electricity. If there are more coins in the pile, then the more electricity it can produce, because the more electrons you have, the more electricity you will get. Batteries are expensive, but you can make one for exactly 24 cents! In this experiment, you will make your own voltaic pile using pennies and nickels. In the data, we will see if the number of pennies and nickels will affect the number of voltage and current.…

    • 1286 Words
    • 6 Pages
    Good Essays
  • Good Essays

    Synthesis Lab

    • 435 Words
    • 2 Pages

    At the beginning of the lab, a micro test tube with and without glass wool was weighed on an analytical balance. A watch glass, crucible, and lid were also weighed. The masses of all the materials needed for the lab were recorded in the data tables of the laboratory notebook. An unknown vial was obtained from the teacher and set to zero on the balance. About 0.6 grams of the unknown was measured into the micro test tube. The analytical balance was set to zero again and then the test tube with the unknown was measured and recorded.…

    • 435 Words
    • 2 Pages
    Good Essays
  • Good Essays

    U3L5AssessmentTemplate 2

    • 444 Words
    • 3 Pages

    If I use __Large___ gauge of wire and ___Copper____ as the material, with a voltage of __100__ Volts and ___100___ number of winds, then this will produce the strongest electromagnet.…

    • 444 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    The more perpendicular the wires are to each other the induced current will be less.…

    • 439 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    Electropes Chapter 9

    • 691 Words
    • 3 Pages

    If a conductor touches the sphere of the electroscope, the charged metal leaves will fall, and its charge will be lost as electrons pass through the conductor to or from your body. The leaves on the leaf electroscope will remain raised if the material being tested is an insulator. This is because insulators do not allow electrons to flow, which results in the leaves of the electroscope being kept raised. Because conductors allow electrons to flow, the electrons can ground to or from your body, resulting in the leaves being…

    • 691 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    In “Pittsburgh Sheep” we measured the temperature of the 10 milliliters of Solution 2. Then we dropped a ball of steel wool into the test tube and measured the temperature again. We stored the test tubes on the test tube rack to observe the next day.…

    • 285 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    There were a few errors present within this lab. Originally, we were going to test the conductivity of each substance as a solid as well as the conductivity of each substance dissolved in water, however, the conductivity testers did not work on the solid substances. This hindered our ability to determine whether a substance was a metal. Another error within our experiment was that not all of the tests…

    • 143 Words
    • 1 Page
    Satisfactory Essays
  • Good Essays

    The whole point of our preliminary experiment was to see after doing it, what improvements could be made for the main experiment. The results we gathered show that there must have been some sort of error as there was a different resistance for the same material.…

    • 1097 Words
    • 5 Pages
    Good Essays
  • Good Essays

    2.2.4 HUMAN BODY SYSTEMS

    • 633 Words
    • 3 Pages

    Electricity in a copper wire is faster than nerve impulse, this could be because an atom is bigger than an electron, and since electrons are smaller they can get through faster. In the wire there is just electrons flowing but in the nerve membrane there are proteins opening and closing which makes the nerve impulses move slower.…

    • 633 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Physics of a Light Bulb

    • 891 Words
    • 4 Pages

    Ohm’s law states, via the equation V=I*R, that the voltage found across a piece of material is proportional to the current. If the temperature remains constant therefore the resistance is found to remain constant. Stefan-Boltzmann law states that when the temperature if above an average of 1000K, then the relationship of voltage and current should be found to be consistent with the formula AT4. The experimental data found in this, Physics of a Light Bulb, experiment both correlates and verifies the Stefan-Boltzmann law. The voltage and current were found to be proportional to one another, verifying Ohm’s law. In addition, the fact that radiation away from the light bulb is indeed proportional to the fourth power of temperature was observed and again verified through a linear fit graph. The percent error found between the two experimental B values was found to be an average 6%. This showing proving that the experiment was decently accurate.…

    • 891 Words
    • 4 Pages
    Good Essays
  • Good Essays

    2. There were many combinations that showed if it was positive or negative charges. The positive combinations were the glass and fur (3.108 nC), clear plastic and fur (45.07 nC), glass and silk (1.979 nC), clear plastic and silk (19.60 nC), glass and green cloth (2.914 nC), clear plastic and green cloth (31.09 nC) materials. The negative combinations were the yellow plastic and fur (-81.57 nC), yellow plastic and silk (-75.49 nC), and yellow plastic and green cloth (90.30 nC) materials. The results are positive when the electrons flow from the glass and clear plastic because these materials have more electrons than the other materials, thus the electrons would flow from high concentration to low concentration. When the combinations are negative, that means that the electrons would flow into…

    • 636 Words
    • 3 Pages
    Good Essays
  • Better Essays

    Shape memory alloys

    • 1194 Words
    • 5 Pages

    The goal of the experiment was to heat the shape memory alloy to see if the metal will revert back to its original shape. In order to do so I needed a hair dryer with a low and high setting, and a shape memory paperclip. How I went to test this was I took the paper clip, straightened it out, and then heated the paper clip with the blow dryer. In order to obtain accurate results, I needed to do four trials with the blow dryer on the high setting, and one trial with the blow dryer on a low setting. To begin the experiment I first took the shape memory paper clip and I straightened it out. Next I took the blow dryer and put it on high. After that I took the blow dryer and heated the shape memory paper clip. Last I took down observations of what I noted. What I took notice too was the paper clip reverted to its original paper clip shape within seconds of being heated. I repeated this process a second time and noticed that it did the exact same as the first trial with no signs of deformation from straightening the paper clip. Once again I repeated the process for a third trial. This trial proved to be the same as the first two, with reverting to its original shape within seconds. On the fourth, and last, trial the results were no different the previous three trials. The paper clip showed no signs of deformation from any of the four trials and the paper clip reacted the same to the heat all four times as well. For my fifth trial I was instructed to heat the paper clip at a low setting. With the blow dryer on a different setting this created different results. After straightening out the paper clip I heated it with a low setting. The observations I made were the paper clip took a longer time to revert to its original shape. I also took note that the paper clip did not quite make it back to its original shape. The results taught me how the shape memory alloy reacts to different temperatures.…

    • 1194 Words
    • 5 Pages
    Better Essays
  • Powerful Essays

    Background Students had been taught ‘Electrochemistry’ as outlined in the IB Chemistry syllabus. Investigation Design an experiment that allows you to investigate a variable affecting the rate of electroplating. Your research question must be focussed and specific and must enable you to carry out your experiment safely and within the allocated time. Safety Show your research question to your teacher. Complete a safety hazard assessment before writing a full plan (a + b). Ensure your teacher approves this. Experiment If your plan is safe you will be allowed to complete your experiment, though you must give your teacher notice of any non-standard apparatus you will require, one lesson in advance of your experiment. Assessment Your teacher may take this opportunity to assess almost all of the skills, so work hard and remember to check the criteria.…

    • 2264 Words
    • 10 Pages
    Powerful Essays