Preview

Dvd to the World

Good Essays
Open Document
Open Document
7809 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Dvd to the World
XDCA8100DLB

User’s Guide

In-Dash 7 Inch TFT TV/DVD/VCD/CD/WMA/MP3/SD Player with FM/AM Receiver Bluetooth enabled
Thank you for purchasing Xcruiser XDCA8100DLB. Please read this manual thoroughly and retain it for future reference. To downlaod this User’s Guide in Russian, Arabic and Persian, please visit our website: www.xcruiser.net

XDCA8100DLB ver. 4.0

© COPYRIGHT 2011 UNICOM INTERNATIONAL GENERAL TRADING L.L.C

Contents

PRECAUTIONS FRONT PANEL TOUCHING CONTROL OPERATION SYSTEM MENU SETUP OPERATION REMOTE CONTROL BASIC OPERATION RADIO OPERATION BLUETOOTH OPERATION TV OPERATION DVD/VCD/CD OPERATION SYSTEM SETUP MP3 OPERATION INSTALLATION CABLE CONNECTION TROUBLESHOOTING SPECIFICATIONS

3 5 6 7 8 10 13 14 15 18 20 23 29 30 33 34 36

Note: Due to continuous product improvement, specifications and design are subject to change without prior notice. 2-en

XDCA8100DLB

Precautions
Notes on Installation
The unit is designed for 12VDC, negative ground operation system only. Before installingthe unit, make sure your vehicle is connected to DC 12V negative ground system. Be sure to connect the color coded leads according to the diagram. Incorrect connections may cause the unit to malfunction or damage the vehicle’s electrical system. Be sure to connect the speaker (-) leads to the speaker (-) terminal. Never connect the left and right channel speaker cables each other or to the vehicle body. Make sure all the connections are before completely correct turning on your unit. When replacing the fuse(s), the replacement must be of the same amperage as shown on the fuse holder. Do not block vents or radiator panels. Blocking them will cause heat to build up inside and may result in fire. After completing the installation and beginning to play the unit (including replacing the battery), please remove the guard against theft front-panel at first, and then press RESET button on the base with pointed object (such as ballpoint pen) to set the unit

You May Also Find These Documents Helpful