Preview

Enzyme Specificity Using Beta-Galactosidase and Alpha-Galactosidase Lab

Satisfactory Essays
Open Document
Open Document
375 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Enzyme Specificity Using Beta-Galactosidase and Alpha-Galactosidase Lab
Enzyme Specificity Using Beta-galactosidase and Alpha-galactosidase

Introduction: In order to survive, organisms need reactions to occur at a certain time and place. Enzymes make these reactions happen. Enzymes are highly specific causing only one enzyme to catalyze one reaction. “Induced fit” explains why enzymes act this certain way. An enzyme will surround a certain substrate and form to it for the reaction to occur in the active site. If it doesn’t form to it, the reaction will not occur. The first enzyme being used, beta-galactosidase, is an active ingredient in Lactaid. Lactaid helps break down lactose. The second enzyme being used, alpha-galactosidase, is an active ingredient in Beano which catalyzes the breaking down of melibiose. Melibiose and lactose are both disaccharides composed of two simple sugars galactose and glucose. So, can Lactaid break down melibiose as well as lactose (the substrate it is specific to) or Beano break down lactose as well as melibiose (the substrate it is specific to)? How specific are the two? If a reaction is catalyzed, the tertiary structure of the enzyme fit the substrate and bound to the substrate. If the structure doesn’t fit, the reaction will not be catalyzed. (Preszler, 2011)

Method: Label 10 fermentation tubes (1-10). Next measure 4mL of your desired sugar, 2mL of your desired enzyme, and 10mL of yeast (or water when needed in replace of yeast) and pour into a beaker and give it a swirl. Then pour the solution into the corresponding fermentation tube. Tip the tube until the closed arm is full of solution and place in the water bath. Record the amount of carbon dioxide produced every five minutes for twenty five minutes. (If the carbon dioxide amount is going beyond the calibration, record the position and reset.)

Treatment | Sugar/Control | Enzyme/Control | Yeast | One | Lactose | Enzyme A | Yeast | Two | Melibiose | Enzyme A | Yeast | Three | Lactose | Enzyme B | Yeast | Four | Melibiose | Enzyme B



Cited: Preszler, R. (2011) Enzyme Specificity In: Biology 1011 Laboratory Exercises. Edited by C. Belk, F. Maragi, P. Schoff and S. Stevenson. Cengage Learning.

You May Also Find These Documents Helpful

  • Satisfactory Essays

    Complete the following questions and submit your report. This document contains 4 pages. The total lab is worth 20 points.…

    • 704 Words
    • 8 Pages
    Satisfactory Essays
  • Satisfactory Essays

    1408 Bio Lab05 Report2

    • 923 Words
    • 5 Pages

    Answer the questions and report your data in this fillable PDF using the observations and results…

    • 923 Words
    • 5 Pages
    Satisfactory Essays
  • Good Essays

    Natural enzymes are proteins that catalyze biological reactions by lowering the activation energy of the reaction without being altered during the process. The enzyme used in this experiment was the β-galactosidase purified from E. coli. This enzyme hydrolyzes lactose and turns it into galactose and glucose. Since it is difficult to assay the activity of β-galactosidase, we will be using the artificial substrate, o-nitrophenyl-β-galactoside (ONPG) instead of lactose. ONPG is an analog of lactose and an advantage of using ONPG is that it is easy to determine the amount of ONPG cleaved by using spectrometric assay (1). The β-galactosidase hydrolyzes ONPG and yields a yellow solution that contains o-nitrophenol and galactose. The solution becomes more yellow as the more ONPG is being degraded. Using spectrophotometry, the absorbance of the solution can be determined at a wavelength of 420nm. The assays will help determine the Km, Vmax, and Kcat of the enzyme. In our assays, Na2CO3 is used to stop the reactions by changing the solution pH to basic and as a result the enzyme will become inactive.…

    • 463 Words
    • 2 Pages
    Good Essays
  • Good Essays

    Catalase Lab Report

    • 563 Words
    • 3 Pages

    Next, 50ml of distilled water will be measured using a graduated cylinder. The 50g of catalase and the 50ml of distilled water will be put into a blender and blended until liquefied. The catalase solution will then be introduced to a Buchner funnel filtration system to separate the catalase extract from any solid particles left over from the blending process. This step will be repeated until all of the catalases have been blended and filtered. Next, 5 ml of hydrogen peroxide will be measured out using a graduated cylinder. It will then be poured into a small Erlenmeyer flask. This will be repeated five times, representing the five trials for each catalase treatment. Once the Erlenmeyer flask has been given 5ml of hydrogen peroxide, 10ml of the S. oleracea catalase will be measured out and poured into the Hydrogen peroxide filled flask. When the catalase and Hydrogen peroxide meet a reaction will occur and the hydrogen peroxide will be broken down into water and oxygen. The oxygen released from the reaction will be recorded by the Gas Pressure sensor. This step will be repeated five times for each necessary trial, then the next catalase extract will be…

    • 563 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Microbiology Final Exam

    • 1002 Words
    • 8 Pages

    During replication, each parent DNA strand serves as a ________ for synthesis of new DNA strands.…

    • 1002 Words
    • 8 Pages
    Good Essays
  • Satisfactory Essays

    Franco lab report enzyme

    • 1154 Words
    • 10 Pages

    4. Describe what is measured as an indicator of sucrase activity and why this is an indicator of sucrase activity.…

    • 1154 Words
    • 10 Pages
    Satisfactory Essays
  • Good Essays

    lab report 5

    • 1078 Words
    • 8 Pages

    What substance is not present in tube S2 for the production of the brown-colored substance?…

    • 1078 Words
    • 8 Pages
    Good Essays
  • Better Essays

    Grt1 Task2

    • 1003 Words
    • 5 Pages

    The role of an enzyme is to catalyze a chemical reaction. Usually an enzyme increases the rate of speed of a reaction. Enzymes break down molecules in our body faster than they would normally break down without enzymes. Enzymes work at specific temperatures and pH levels. (Wolfe, 2000). For example, a stomach enzyme works better in a more acidic environment, whereas intestinal enzymes work better in a more alkaline environment. The shape of an enzyme is important to its function. Enzymes function like a lock and key. The substrate binds to the active site of the enzyme like a key into a lock. The enzyme breaks the bonds of the substrate and releases it without being consumed in the process. Substrates can also function as inhibitors, competing for the active site. (Wolfe, 2000). Sometimes one enzyme will work on one particular substrate, in other circumstances, such as with fructose, two or more enzymes work to break down a substrate so that it can be used by the body. Fructose is first broken down into fructose 1 phosphate by the enzyme fructokinase. Then fructose 1 phosphate is further broken down into dihydroxyacetone phosphate (DHAP) and glyceraldehyde by the enzyme aldolase b. (Hudon-Miller, 2012). At this point, DHAP and glyceraldehyde enter the glycolysis cycle where they can be further processed into ATP, the body’s main source of energy.…

    • 1003 Words
    • 5 Pages
    Better Essays
  • Satisfactory Essays

    A catalyst is a substance that has the capacity to speed up chemical reactions without itself being…

    • 5107 Words
    • 28 Pages
    Satisfactory Essays
  • Good Essays

    In this method, samples are taken from the fermentation vessel, stained with methylene blue, and then counted manually under a microscope using a hemocytometer. While this method is well known and documented, it is, at best, an estimate based upon a very small sample count. The hemocytometer, when viewed under a microscope, presents a grid of measurement areas as seen below. = Grid Cell Counted =…

    • 820 Words
    • 4 Pages
    Good Essays
  • Powerful Essays

    Yeast are able to metabolize some foods, but not others. In order for an organism to make use of a potential source of food, it must be capable of transporting the food into its cells. It must also have the proper enzymes capable of breaking the food’s chemical bonds in a useful way. Sugars are vital to all living organisms. Yeast are capable of using some, but not all sugars as a food source. Yeasts reproduce rapidly through fission or budding and grow especially well in substances containing sugar.…

    • 1136 Words
    • 5 Pages
    Powerful Essays
  • Better Essays

    Enzymes: Lab Report

    • 2612 Words
    • 11 Pages

    Enzymes work by combining with reacting molecules at the active site. Each enzyme is specific to only one kind of molecule and can only bind to its specific molecule. The active site is a groove in the enzyme where the molecule will bind to; this is formed by the enzyme folding into a specific shape. When the enzyme is done and the molecules are then in the transitional state, which means the bonds are unstable and ready to be broken, the enzyme remains unchanged and can continue to bind to other molecules (Russel et al., 2010).…

    • 2612 Words
    • 11 Pages
    Better Essays
  • Powerful Essays

    We started setting up our experiment by measuring different molar solutions (0M, 0.25M, 0.5M, 0.75M and 1M) of sugar and putting them into separate bottles, along with one bag (12g) of yeast and 300ml of water. We then attached a tube going from the top of each bottle to separate test tubes which were entirely full of water and were placed upside down in a tub of water, stopping the tube from emptying and…

    • 1723 Words
    • 7 Pages
    Powerful Essays
  • Good Essays

    Lab Report

    • 542 Words
    • 3 Pages

    For unit 7.3 the experiment needed 2 microfuge tubes one labeled "L" for lactose and the other labeled "M" for maltose. The experiment also called for a total of 3 clean plastic pipettes. With one pipette add milk up to the 0.5 line of the lactose tube. With the second clean pipette add maltose solution up to the 0.5 line of the maltose tube. With the third clean pipette, add lactase solution to each tube, until the level of mixture in each tube comes up to the 1.0 line of the tube. Place both tubes in the 40 degrees celsius water bath and incubate them for 10 minutes. The other thing needed is glucose strips. After the tubes have been incubated for 10 minutes, place a glucose strip in each tube for one second. Let it sit for thirty seconds, then compare to the chart provided. For unit 7.4 the experiment called for two microfuge tubes. One labeled "control" and label another one "EDTA". Add 1.25 mL of EDTA to the EDTA tube, add 1.25mL of distilled water to the control tube. Add 3 drops of milk to each tube, invert the tube and let sit for 1 minute. Then add 3 drops of lactase solution to each tube. Then place both tubes in the 40 degrees celsius water bath and leave them for 10 minutes. After the 10 minutes are up, place the glucose strip in each tube and let the strips sit for 30 seconds. Then compare to the charts provided.…

    • 542 Words
    • 3 Pages
    Good Essays
  • Good Essays

    The bonding of an enzyme to its substrate forms an enzyme-substrate complex. The catalytic action of the enzyme converts its substrate into the product or products of the reaction. Each reaction is extremely specific, distinguishing between closely related compounds, including isomers. For example, the enzyme sucrase will only act on sucrose and will not bind to any other disaccharide. The molecular recognition of enzymes is due to the fact that they are proteins, which are defined as being macromolecules with unique three-dimensional conformations. Therefore, the specificity of enzymes is a consequence of its shape which results from its amino acid sequence. The enzyme binds to the substrate at a region known as the active site, a groove on the surface of the protein. The active site of an enzyme is formed by a few of the enzyme’s amino acids while the rest of the protein molecules determine the configuration of the active site. The specificity of the enzyme is attributed to the shape of the active site and the shape of the substrate. When the substrate enters the active site interactions between its chemical groups and the amino acids of the protein cause the enzyme to change shape slightly in order to fit more tightly around the substrate. This induced fit brings chemical groups of the active site into positions that enhance their ability to catalyze the reaction. The substrate is held in the active site…

    • 617 Words
    • 3 Pages
    Good Essays