Preview

Hardness in Groundwater

Powerful Essays
Open Document
Open Document
9299 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Hardness in Groundwater
WATER STEWARDSHIP INFORMATION SERIES
Hardness in Groundwater
February 2007
What is water hardness?
Water hardness is primarily the amount of calcium and magnesium, and to a lesser extent, iron in the water. Water hardness is measured by adding up the concentrations of calcium, magnesium and converting this value to an equivalent concentration of calcium carbonate (CaCO
3
) in milligrams per litre (mg/L) of water. The Guidelines for Canadian Drinking Water Quality Hardness divide hardness into the following categories:
Hardness Category
Equivalent Concentration of CaCO
3
Soft
< 60 mg/L
Medium hard
60 mg/L to < 120 mg/L
Hard
120 to < 180 mg/L
Very hard
180 mg/L or greater
The optimum range of hardness in drinking water is from 80 to 100 mg/L. Water with hardness greater than 200 mg/L is considered poor in most regions of the province and water with hardness greater than 500 mg/L is normally considered unacceptable for domestic purposes. On average, water in British Columbia has been found to range in hardness from less than 10 mg/L to 180 mg/L. Groundwater tends to be harder than surface water and can range to greater than 1000 mg/L.
What are the known sources of water hardness?
Water hardness in most groundwater is naturally occurring from weathering of limestone, sedimentary rock and calcium bearing minerals. Hardness can also occur locally in groundwater from chemical and mining industry effluent or excessive application of lime to the soil in agricultural areas.
What are the environmental health concerns?
Hard water is mainly an aesthetic concern because of the unpleasant taste that a high concentration of calcium and other ions give to water. It also reduces the ability of soap to produce a lather, and causes scale formation in pipes and on plumbing fixtures. Soft water can cause pipe corrosion and may increase the solubility of heavy metals such as copper, zinc, lead and cadmium in water. In
some



References: magnesium in drinking-water: public health significance (WHO, 2009) moderately hard; 120–180 mg/l, hard; and more than 180 mg/l, very hard (McGowan, 2000) ates (National Research Council, 1977). HARDNESS IN DRINKING-WATER drinking 2 litres of water per day (Neri et al., 1985). 2.2 Food the order of 50% (Ong, Grandjean & Heaney, 2009). For calcium and magnesium, the typical contribution from water is 5–20% (WHO, 1973; National Research Council, 1977; Neri & Johansen, 1978). Because of dietary habits in most countries, many people fail to obtain the

You May Also Find These Documents Helpful

  • Satisfactory Essays

    Be sure to review this important presentation before attempting this assignment (you may be prompted for your FLVS User Name and Passcode to begin):…

    • 384 Words
    • 2 Pages
    Satisfactory Essays
  • Better Essays

    Titration Lab Report

    • 1876 Words
    • 8 Pages

    Primarily, hard water consists of magnesium and calcium. Therefore the ratio of magnesium to calcium ions was inferred to be 50/50. The average molar mass of the molar mass of Magnesium (24.305 g/mol) and the molar mass of Calcium (40.078 g/mol) was calculated to be 32.192 g/mol. This calculated average molar mass was used as the molar mass of the metal that was present in the sample. The concentration of metal that was present in the TAP water was solved by the following calculations:…

    • 1876 Words
    • 8 Pages
    Better Essays
  • Satisfactory Essays

    Penny Lab

    • 346 Words
    • 2 Pages

    In this experiment we confirmed the hypothesis that soap affects water by lowering surface tension thus lowering the amount that can fit on a penny.…

    • 346 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Biology Homework # 1

    • 1380 Words
    • 6 Pages

    13. What does the pH scale measure? What is the range on the scale? What values…

    • 1380 Words
    • 6 Pages
    Good Essays
  • Good Essays

    Labpaq Scientific Method

    • 1167 Words
    • 5 Pages

    | Before crushing: hard, sharp edges, all different shapes, abt .25 inch, cloudy color.After crushing: breaks into different sized shards, some smaller crystals, Wet: Salt mostly dissolves although layer of tiny granules is visible at bottom of water bubble.…

    • 1167 Words
    • 5 Pages
    Good Essays
  • Good Essays

    Total hardness of tap water was 120 mg/l and bottle water combined had a total hardness of 50 mg/l…

    • 1060 Words
    • 5 Pages
    Good Essays
  • Good Essays

    Apes Ch 2 Checkpoints

    • 903 Words
    • 4 Pages

    Water has high surface tension. It also has capillary action, high boing point and the ability to dissolve many different substances.…

    • 903 Words
    • 4 Pages
    Good Essays
  • Powerful Essays

    pH is a measurement of how acidic or basic a solution is. Water with pH lower than 7 is considered acidic and higher than 7 is known as basic. The safe levels of pH in drinking water is 6.5 - 8.5. Pure water has a pH of 7 which means there is an equilibrium of positive hydrogen ions and negative hydroxide ions. ((When the pH of water is below 6.5, the water is soft and corrosive. This type of water can damage metal pipes and when used, it can stain clothes, have a sour taste and damage sinks. Water with a Ph greater than 8.5 is considered hard. This water does not pose a health risk, but can stain dishes and utensils))4. When Ph of water is low there can be many consequences and effects. ((Even a moderate decrease in pH of water could affect the fish…

    • 1741 Words
    • 11 Pages
    Powerful Essays
  • Satisfactory Essays

    ) 12 grams of KClO3 in 100 grams of water (3) 30 grams of NaCl in 100 grams of water…

    • 372 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Apes- Water Study Guide

    • 1340 Words
    • 6 Pages

    What is the level of DO in the water that is considered a good level?…

    • 1340 Words
    • 6 Pages
    Good Essays
  • Good Essays

    (1)Hard water is any water containing an appreciable quantity of dissolved minerals. (2) Some of the minerals come from chalk, limestone or marble, which the water may have flowed over or through. (4) Hard water contains calcium or magnesium ions. Limestone, marble or chalks are insoluble in pure water however they will dissolve slowly in acidic rain. If your water has emerged through limestone or chalk (calcium carbonate) it will be hard. (1) Soft water is gratification water in which the only cation (positively charged ion) is sodium. The minerals in water give it an idiosyncratic taste. Some natural mineral waters are highly desired for their flavour and the health benefits they may converse. (3) Extremely hard water affects plumbing such as pipes and the performance of certain cleaning agents. When the water is heated the carbonates precipitate out of solution, forming scale in pipes and kettles.…

    • 925 Words
    • 4 Pages
    Good Essays
  • Good Essays

    4. Can the surface tension of water be made stronger? (try sprinkling baby powder on the surface)…

    • 289 Words
    • 2 Pages
    Good Essays
  • Powerful Essays

    Bottled Water vs Tap Water

    • 1893 Words
    • 8 Pages

    Resetarits, Mike, resetarits@fri.org. "I Drink Tap Water." Chemical Engineering 119.13 (2012): 55. OmniFile Full Text Select (H.W. Wilson). Web. 26 Jan. 2013.…

    • 1893 Words
    • 8 Pages
    Powerful Essays
  • Satisfactory Essays

    A. Based on the analysis of your local water, how could you classify its hardness?…

    • 393 Words
    • 2 Pages
    Satisfactory Essays
  • Better Essays

    The first is that the soap lessens the surface tension of the water so that it wets what needs to be cleaned in a more efficient manner.5 The second involves the molecular structure of the soap. Soaps have a hydrophilic (water-loving) end, the carboxylic acid region, and a hydrophobic (water-fearing) region, the fatty acid chain.1 This causes the soap molecules work like a bar magnet. The water is attracted to the hydrophilic end and the oil is attracted to the hydrophobic end since it is nonpolar. The oil particles get broken apart and washed away.5 Detergents also have a hydrophilic and hydrophobic end,1 so they work in a similar…

    • 1874 Words
    • 8 Pages
    Better Essays

Related Topics