Preview

How Can A Solar Panel Generate Enough Elecricity To Move A Rollercoaster Made Of A Toy Vehicle?

Good Essays
Open Document
Open Document
1124 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
How Can A Solar Panel Generate Enough Elecricity To Move A Rollercoaster Made Of A Toy Vehicle?
Chapter 1
INTRODUCTION
Situation Analysis This study mainly focuses on how can a solar panel generate enough elecricity to move a rollercoaster made of a toy vehicle. Solar panel is a large, flat piece of equipment that uses the sun’s light or heat to create electricity. It is called as a solar panel because most of the time, the most powerful source of that is available throughout the world which is the Sun. It is a collection of some solar cells summed up together. The more light that hits a specific cell, the more electricity it gives or produces. It is also called Sol by the scientists.
Solar panel produces electricity by converting the energy of the sun into high temperature heat.

Solar panel is known to be “eco-friendly” sincei
…show more content…
This study clarified the following questions :
1. Can a solar panel generate enough elecricity to move a rollercoaster made of a toy vehicle?
2. Does the figure of the toy vehicle affect the speed and movement on the tracks of the homemade rollercoaster?
3. Can the solar panel powered rollercoaster run a whole lap of the tracks made?
4. Is this experiment viable during nighttime?
5. During what time of the day does this solar powered vehicle move the most?
6. If there’s a shadow will it continue to run or will it stop?
7. Is the toy vehicle compatible with the solar panel?
8. Can the solar panel run 2 toy vehicles at the same time?
9. Where is the perfect place to put the solar panel?
10. If there are 2 solar panels will it run faster?

Paradigm of the
…show more content…
If we made our own solar panel it will cost us more expenses, time-consuming as well, and it might fail during the end of our experiment. If the homemade tracks are very lengthy the toy vehicle might not complete a whole lap of the given tracks and also if the height of the tracks are too high the toy vehicle might collapse or it might stop moving. If the solar panel is not compatible with our toy vehicle it might not run that easily at all.

Alternative Hyphothesis Our study is less expensive, eco-friendly and much more efficient of getting power throughout the day. If we bought a solar panel that is already made it will cost a bit less, more time will be saved, and it may work in the end since we are sure that the solar panel is working. If we make the tracks medium short then it would be easier for the toy vehicle to complete a lap as well as the height of the tracks should be not too high in order to run the toy vehicle in a way that it will not fall or struggle upon reaching the ramp. It would be easier for us to operate this homemade rollercoaster if we use sunlight as a source of energy to run the toy

You May Also Find These Documents Helpful

  • Satisfactory Essays

    1. How did the revolutions of the motor compare when the solar cell was held to an incandescent light source vs. the sun as a light source?…

    • 553 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    help 3.06

    • 473 Words
    • 2 Pages

    Select one type of Fossil Fuel (Coal, Petroleum or Natural Gas) and one type of Renewable Energy Resource (Solar power, Wind power, Hydropower, Geothermal power, or Biomass).…

    • 473 Words
    • 2 Pages
    Good Essays
  • Good Essays

    The Scrambler

    • 523 Words
    • 3 Pages

    For our car we decided to make it a rubber band car since that would give it the most mechanical and potential energy. The rubber bands were to act as our potential energy since it stored all the energy as we pulled it back to wind it up. The whole car then would be running on mechanical energy. As the rubber bands unwind, it turns the rear axle of the car which then drives the rear tires to move the car. Miranda made sure to get the car to only go forward by figuring out the right amount over rubber bands and how tight to make them. Another way to not make sure the car went a different direction was to make sure the bands released and didn’t get twisted back up. If they did that would result in a car that went backwards. The tighter we got them the father the car would go. It turned out to be about 4 bands that were tied together. The car was able to go because of the force that was being built up with the bands as they tightened. The back wheels were also put on tight so the car went straight and the axle was secured with glue to the rotating piece of wood. The only force acting on the car were the bands and with the cement ground there was no friction, so the car had a smooth ride. The speed did slow down however after the initial take off but we wanted it to go slower as it approached the wall for the safety of the egg. Overall our project went really well.…

    • 523 Words
    • 3 Pages
    Good Essays
  • Good Essays

    In 1971, a husband and wife, Aden and Marjorie Meinel, patented an idea to produce solar panels in the Mojave Desert. The solar panels they proposed were to stretch through the Mojave Desert for 5,000 miles and would collect 1,000,000 megawatts of electrical power. The electrical energy would then be stored in a manufacturing facility locally so that the solar energy could be converted and used by millions of people. The Meinel’s proposal was dismissed in the 1970’s, but recently, solar panel plants have begun to sprout in the Mojave Desert. There are currently fourteen pending solar projects that have been proposed to be built in the Mojave Desert. There are also currently already four solar plants built there.…

    • 355 Words
    • 2 Pages
    Good Essays
  • Satisfactory Essays

    Lab Report

    • 321 Words
    • 2 Pages

    First, we planned out how we'll build the rollercoaster (how much Potential Energy we'll need to last the whole track).…

    • 321 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Force and Lever Arm

    • 749 Words
    • 3 Pages

    4. What kind of wheels did you use on each axle? What is the effect of using large or small wheels?…

    • 749 Words
    • 3 Pages
    Good Essays
  • Good Essays

    for this project is materials. Some needed are solar panels, which are provided, wheels, gears, axles and…

    • 2087 Words
    • 9 Pages
    Good Essays
  • Satisfactory Essays

    Balloon Powered Car

    • 468 Words
    • 2 Pages

    Balloon powered car racer is driven by air coming from a deflating balloon. As an alternative of using electricity, these cars make use of the Law of Action and Reaction (Newton’s Third Law of Motion). The car is propelled forward, as a result of the air coming from an inflated balloon.…

    • 468 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    In this lab, we are building and testing a rubber band powered vehicle to work towards energy efficiency. After designing a base structure for the rubber band powered vehicle, we will build it and test it on the floor in school hallway. We will test the distance it traveled in the amount of time that it took for it to get there. Also the capabilities of re-use after many uses of the vehicle.…

    • 1144 Words
    • 5 Pages
    Good Essays
  • Good Essays

    Roller Coast

    • 3283 Words
    • 14 Pages

    Roller coasters have no engines. Instead, the car is pulled to the top of the first hill and released, at which point it rolls freely along the track without any external mechanical assistance for the remainder of the ride. The law of conservation of energy states that energy can neither be created nor destroyed, thus, the purpose of the ascent of the first hill is to build up potential energy that will then be converted to kinetic energy as the ride progresses. The initial hill, or the lift hill, is the tallest in the entire ride. As the…

    • 3283 Words
    • 14 Pages
    Good Essays
  • Better Essays

    bad letter report

    • 852 Words
    • 4 Pages

    which is then transformed into the propulsive energy (kinetic energy that moves a vehicle). A solar cell…

    • 852 Words
    • 4 Pages
    Better Essays
  • Satisfactory Essays

    .Potential energy and kinetic is what makes the roller coaster ascends up the hill and it descends Roller coasters the change of ds down the hill. Potential and kinetic energy is what makes the roller coaster move. What some people may not realize is that the roller coaster has no engine. When you’re going down hill they use different types of wheels to keep the ride smooth. A roller coaster is not pulled by cable. The 3 types of wheels are running wheels which guides the roller coaster, Friction wheel which controls the motion of the car. The last set keeps the coaster even.In some new roller coasters they have built a catipult launch. The first part of a roller coaster is chains and motors.…

    • 295 Words
    • 2 Pages
    Satisfactory Essays
  • Powerful Essays

    Solar Energy Pros and Cons

    • 2001 Words
    • 9 Pages

    Hogan, Jenny. (2003, June). Solar power set for take-off: the latest technology for converting sunlight into electricity could make solar panels cheap and efficient enough to become a widespread source of domestic power. New Scientist 178(2398), 14(2).…

    • 2001 Words
    • 9 Pages
    Powerful Essays
  • Good Essays

    Roller coaster are driven almost entirely by basic inertial, gravitational, and centripetal forces. Newton’s 1st law of motion states that an object in motion will remain in motion in a straight line except when acted by an outside force Inertia states that an object at rest stays at rest, and an object moving at constant velocity will remain at constant velocity unless acted upon an outside unbalanced force. Gravity is basically saying what goes up must come back down and as you see in a roller coaster it does not keep going up it comes back down gravity acts upon it. The first hill has the largest amount of gravitational potential energy. When a roller coaster is at the bottom of the first hill, the kinetic energy is at it’s biggest. By…

    • 226 Words
    • 1 Page
    Good Essays
  • Good Essays

    Physics, Roller Coasters

    • 552 Words
    • 3 Pages

    [1]The rollercoaster car gains gravitational potential energy (GPE) as it travels to the top. Once over the top, the car gains speed as GPE is transferred to kinetic energy (KE). As it travels to the top of another loop, KE is transferred to GPE. Not all the energy is transferred to or from GPE – some is transferred to the surroundings as heat and sound. All moving objects have kinetic energy, KE. The kinetic energy an object has depends on the mass and speed. If the mass doubles, the KE doubles and if the speed doubles, the KE quadruples. Normally energy is lost through sound and heat (friction, air resistance).…

    • 552 Words
    • 3 Pages
    Good Essays

Related Topics