Top-Rated Free Essay
Preview

Jet Engine

Good Essays
480 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Jet Engine
A jet engine, like a rocket engine, is a reaction engine. It works by throwing mass in one direction and taking advantage of the reaction in the opposite direction. In the case of a jet engine, the engine burns fuel (like kerosene) with air from the atmosphere. The burning fuel heats and expands the air, and this hot air shoots out of the exhaust-end of the engine to create thrust.
Most modern jet engines use a turbine to improve the efficiency of the engine and allow the engine to work at low speeds. One part of the turbine sucks in air and compresses it before the fuel is injected. The back portion of the turbine acts like a windmill, extracting energy from the exhaust gases and using the energy to spin the compressor portion. See How Jet Engines Work for details.
A modern turbine engine is extremely efficient, and there is still a lot of oxygen available in the exhaust stream. The idea behind an afterburner is to inject fuel directly into the exhaust stream and burn it using this remaining oxygen. This heats and expands the exhaust gases further, and can increase the thrust of a jet engine by 50% or more.
The big advantage of an afterburner is that you can significantly increase the thrust of the engine without adding much weight or complexity to the engine. An afterburner is nothing but a set of fuel injectors, a tube and flame holder that the fuel burns in, and an adjustable nozzle. A jet engine with an afterburner needs an adjustable nozzle so that it can work both with the afterburners on and off.
The disadvantage of an afterburner is that it uses a lot of fuel for the power it generates. Therefore most planes use afterburners sparingly. For example, a military jet would use its afterburners when taking off from the short runway on an aircraft carrier, or during a high-speed maneuver in a dogfight.
The following pictures, taken at the Virginia Air and Space Museum, show you some of the details of an afterburner-equipped engine. This particular engine comes from an F-4. Here is the main part of the engine:
This includes the compressor, combustion chamber and exhaust turbine. At the exhaust end of the engine, you can see a ring of injectors for the afterburner, as shown here: Here's a close-up of one of the injectors: Attached to the end of the engine would be a tube and adjustable nozzle, as shown here: This tube is about 8 feet long (2.7 meters). The engine itself is about 12 feet long (4 meters).
Here are several interesting links:
NT/5 TurboJet -- picture of small afterburner about halfway through the article
Pratt and Whitney afterburner definition
F-16 Evolution nice afterburner picture toward the end of the article
Turbojet and turbofan systems

You May Also Find These Documents Helpful

  • Good Essays

    A turbocharger is defined as a centrifugal blower driven by exhaust gas turbines and used to supercharge an engine. (Merriam-Webster Dictionary) Turbochargers compress the air flow into the engine. One of the advantages of the air being compressed is that more air is being squeezed into the cylinder, more air in the cylinder means that more fuel can be added. It achieves the boost by using the exhaust flow from the exhaust to spin a turbine, which spins an air pump. The turbine spins at speeds up to 150,000 RPM, that’s about 30 times faster than most engines can go. The typical boost provided by a turbocharger is 6 to 8 psi. (http://auto.howstuffworks.com/turbo2.htm)…

    • 624 Words
    • 3 Pages
    Good Essays
  • Better Essays

    Combustion A chemical process between fuel and oxygen with the evolution of light either as a glow or flame and heat. Some of the heat energy is radiated back into the fuel, releasing more fuel to allow the combustion process to continue.…

    • 998 Words
    • 4 Pages
    Better Essays
  • Better Essays

    Physics of Airplanes

    • 1550 Words
    • 7 Pages

    In the earlier days, airplanes gained thrust only by a single propeller. Nowadays huge turbofans are attached to the wings or the tail of the aircraft instead. Of course propelled airplanes are still used, most modern planes have jet engines.…

    • 1550 Words
    • 7 Pages
    Better Essays
  • Good Essays

    Combustion reaction, is a reaction in which oxygen reacts with another element or compound (generally a hydrocarbon) to produce energyg in the form of heat and light. There are two types of combustion reaction: complete and incomplete combustion reaction. In complete combustion, the reactant burns in oxygen, producing a limited number of products. When a hydrocarbon burns in oxygen, the reaction will primarily yield carbon dioxide and water. Incomplete combustion will occur when there is not enough oxygen to allow the fuel to react completely to produce carbon dioxide and water. It also happens when the combustion is quenched by a heat sink, such as a solid surface or flame trap. In this lab, biodiesel was…

    • 674 Words
    • 3 Pages
    Good Essays
  • Good Essays

    The first step in an internal combustion engine is to acquire all the attributes to create combustion in a chamber. The necessary air flows through the air filter (usually a conical shaped, micro filament, located in either the front right or left of the engine bay). After the air is sucked into the filter it passes through some tubing until it reaches the mass air sensor. The mass air sensor does exactly what it says, senses the amount of air flow and converts it into a signal or number which then is used to determine the amount of fuel to be delivered. The air and fuel must be at a regulated ratio for maximum gas mileage and power efficiency. Next the air goes through the throttle body, this mechanism regulates the amount of air let into the lower half of the engine, and this is attached to the accelerator (gas pedal) by a cable. The further the gas pedal is depressed, the greater amount of air that is let into the engine, which results in faster acceleration.…

    • 943 Words
    • 4 Pages
    Good Essays
  • Satisfactory Essays

    C1 Revision Notes

    • 397 Words
    • 2 Pages

    Complete combustion is when hydrocarbons combusts with a sufficient amount of oxygen to produce CO2 and H20.…

    • 397 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Airframe Systems

    • 1868 Words
    • 8 Pages

    An aircraft powered by a piston engine usually tends to have a pneumatic air supply system. This allows the function of different systems on the aircraft that are essential to the flight of the aircraft.…

    • 1868 Words
    • 8 Pages
    Good Essays
  • Good Essays

    World War 2

    • 703 Words
    • 3 Pages

    Aircraft were used for reconnaissance, as fighters, bombers and ground-support, and each role was advanced considerably. Innovation included airlift (the capability to quickly move limited high-priority supplies, equipment and personnel);[359] and of strategic bombing (the bombing of civilian areas to destroy industry and morale).[360] Anti-aircraft weaponry also advanced, including defences such as radar and surface-to-air artillery, such as the German 88 mm gun. The use of the jet aircraft was pioneered and, though late introduction meant it had little impact, it led to jets becoming standard in worldwide air forces.[361]…

    • 703 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Chemistry

    • 536 Words
    • 3 Pages

    • Combustion reactions of alkanes consist only of C and H (hydrocarbon) • require O2(g) as a reactant • produce CO2(g) and H2O(g) and a large amount of energy!!…

    • 536 Words
    • 3 Pages
    Good Essays
  • Good Essays

    + 12H2O (KGB, 2017). Combustion is an exothermic chemical reduction oxidation (redox) reaction occurring between a fuel and an oxidising agent (Thoughtco, 2017). An exothermic reaction is a reaction that releases energy…

    • 1468 Words
    • 6 Pages
    Good Essays
  • Good Essays

    This means that both special effects need a fuel that acts as a base for the reaction. This includes materials such as wood, oil, natural gases, gunpowder and trinitrotoluene (TNT). Although for the combustion reaction to take place there has to be an oxidiser, this usually is Oxygen (O2). An oxidiser is a chemical substance that adds Oxygen to complete a reaction (Daily, 2015). The oxidiser is usually found in the surrounding air, this also concludes to the fact that if you add Oxygen by fanning a flame it will become brighter.…

    • 537 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Fossil fuels hold chemical energy; they give off light and heat energy when they burn. The heat energy is used to heat water, the water turns into steam which has kinetic energy. The turbine is moved by the steam which is kinetic mechanical energy. The generator is powered by the movement of the turbine which produces electrical…

    • 503 Words
    • 3 Pages
    Good Essays
  • Better Essays

    AIRCRAFT FUEL SYSTEM

    • 1040 Words
    • 4 Pages

    As everyone knows, an internal combustion engine needs fuel to operate. Fuel is delivered to the engine by means of the fuel system. The fuel system must be self-contained and efficient so that it will properly energize the engine and will take up as little space as possible necessary to its mechanical functioning. An internal combustion engines fuel system is, literally, the heart of the engine.…

    • 1040 Words
    • 4 Pages
    Better Essays
  • Good Essays

    How Cars Work

    • 676 Words
    • 3 Pages

    There is such a thing as an external combustion engine. A steam engine in old-fashioned trains and steam boats is the best example of an external combustion engine. The fuel (coal, wood, oil, whatever) in a steam engine burns outside the engine to create steam, and the steam creates motion inside the engine. Internal combustion is a lot more efficient (takes less fuel per mile) than external combustion, plus an internal combustion engine is a lot smaller than an equivalent external combustion engine. This explains why we don't see any cars from Ford and GM using steam engines.…

    • 676 Words
    • 3 Pages
    Good Essays
  • Powerful Essays

    Catalytic Converter

    • 3258 Words
    • 14 Pages

    As the name suggests, it basically converts harmful gases into harmless gases, which are environment friendly, with the help of a catalyst. Engine exhausts having harmful gases like CO, NOx & HC which are converted into harmless gases like CO2, N2 & H2O respectively with the use of catalytic converter.…

    • 3258 Words
    • 14 Pages
    Powerful Essays