Preview

JGD-B2 Double Arch Rubber Joint,allflex rubber joint

Good Essays
Open Document
Open Document
391 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
JGD-B2 Double Arch Rubber Joint,allflex rubber joint
The Liangda flexible expansion joint JGD-B2 are double arch designed with integral rubber flanges for tough, demanding industrial applications, as found in: Chemical/Petrochemical Plants, Industrial Process Piping Systems, Marine Services, Power Generation Plants, Pulp/Paper Plants, Steel Mills, Water/Wastewater and Pollution Control Systems. Installed next to mechanical equipment or between the anchor points of a piping system to: (1) Absorb Pipe Movement/Stress (2) Reduce System Noise (3) Isolate Mechanical Vibration (4) Compensate Alignment/Offset (5) Eliminate Electrolysis,(6) Protect Against Start-Up Surge Forces.
The Liangda Double Arch joint rubber JGD-B2 is a twin sphere design with more length, the supply range is from 500mm to 1000mm, and design pressure can be 1.0MPa/1.6MPa/2.5MPa. Compared to Rubber Expansion Joint(JGD-1, JGD-2, JGD-3), mechanical and acoustical performance can be almost double by changing to the most commonly specified twin sphere construction. Twin sphere designs are more flexible and allow greater movement.
Features and Benefits:
1, Versatile hand-built construction. Made in China
2, Bellows to Absorb directional movement
3, Absorb vibration, noise and shock
4, Bellows Compensates for misalignment
5, More compensation capability
6, Embedded steel reinforce ring enable the pressure resistance
7, Solid galvanized steel floating flanges speed the installation time
8, Integral rubber flange design, prevent pulling out
9, High tensile aircraft cable is embedded in the raised face rubber ends to prevent pull out and avoids the sharp cutting edge of solid steel rings
10, No gaskets required; DIN PN10/16 drilling standard, other flange drilling available, including ANSI 150lb/300 lb, BS, and JIS
Note:
1. rubber expansion JGD-B2 Supply range is from DN500 to DN1000.
2. Control units must be used when piping is not properly anchored.
3. The rated pressure 2.5MPa products will only be sold with control units.
4. JGD-B2

You May Also Find These Documents Helpful

  • Satisfactory Essays

    NT 1310 Unit 8 Lab 1

    • 595 Words
    • 2 Pages

    Fiber cladding (which is usually 125um after fiber coating stripped off) but tight enough to hold the fiber in a fixed position without any further moving.…

    • 595 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    NT1310 Unit 9 Lab 1

    • 1254 Words
    • 4 Pages

    * A strain relief system that ensures the strength member of the cable will carry the tensile load.…

    • 1254 Words
    • 4 Pages
    Good Essays
  • Good Essays

    pt1420 unit 3

    • 395 Words
    • 2 Pages

    Unshielded Twisted-Pair- A cable with multiple pairs of twisted insulated copper conductors bound in a single sheath.…

    • 395 Words
    • 2 Pages
    Good Essays
  • Satisfactory Essays

    NT1310 Unit 3 Exercise 1

    • 401 Words
    • 2 Pages

    A strong string inside an optical cable used to strip the cable by pulling it so you don’t have to use a bladed tool.…

    • 401 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Rip Cord- String built into fiber-optic cable that is used to split the outer jacket of the cable…

    • 311 Words
    • 1 Page
    Satisfactory Essays
  • Satisfactory Essays

    NETW 310 iLab week 2

    • 335 Words
    • 2 Pages

    7. How is the outer insulation covering each wire cut through during the termination procedure?…

    • 335 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Unshielded Twisted – Pair: It’s a type of cable that consists of several conducting cores twisted together in pairs with no surrounding shield.…

    • 425 Words
    • 2 Pages
    Good Essays
  • Powerful Essays

    Adams, D. (2009, June). STRUCTUREmag - Structural Engineering Magazine, Tradeshow: Intermountain Healthcare Medical Center. Retrieved June 4, 2013, from http://www.structuremag.org/article.aspx?articleid=925…

    • 1169 Words
    • 5 Pages
    Powerful Essays
  • Better Essays

    19. Wire­pulling lubricant is used to allow cables to slide easily over surfaces during a pull.…

    • 670 Words
    • 1 Page
    Better Essays
  • Good Essays

    Senior Science

    • 8826 Words
    • 36 Pages

    * Common examples are knee, hip and shoulder joints; the latter two are ball and socket type joints [more information on ball and socket joints is provided in 9.3 Medical Technology - Bionics, subsection 3].…

    • 8826 Words
    • 36 Pages
    Good Essays
  • Good Essays

    n. No downward pressure on rest, makes for lighter arrow shafts, allows for less stiff arrows, which equals faster speeds…

    • 535 Words
    • 3 Pages
    Good Essays
  • Good Essays

    In the history of the ancient Greek civilization, there were many powerful and contributing men and women. Only one could be called the “Greatest Greek” and that man’s name is Pericles. Pericles was a wise and powerful leader of the city of Athens. He was a great supporter of the concept of democracy. Pericles guided Athens almost through the entire Peloponnesian War. Pericles promoted the arts and literature. This was a main reason Athens held the reputation of being the educational and cultural centre of the ancient Greek world.…

    • 527 Words
    • 3 Pages
    Good Essays
  • Better Essays

    Imperialism In Germany

    • 1237 Words
    • 5 Pages

    Through much of the nineteenth century nationalism was used as tool in political propaganda. Nationalism is the extreme patriotism or love for one’s country. In the past few centuries nationalism has been used a justification for many wars and genocides. Nationalism has also been used to fuel the desire for imperialism. Imperialism is when one country takes over another.…

    • 1237 Words
    • 5 Pages
    Better Essays
  • Good Essays

    Space Shuttle Columbia

    • 973 Words
    • 4 Pages

    The structural integrity of the joints is extremely important because any of the gases that leak from the segments will erode the gas tight path and begin to melt the outside of the booster.…

    • 973 Words
    • 4 Pages
    Good Essays
  • Satisfactory Essays

    Appendix: Conversion Factors

    • 19215 Words
    • 77 Pages

    Finite Life Fatigue Strengths of Selected Plain Carbon Steels 1004 Decimal Equivalents of Wire and Sheet-Metal Gauges 1005 Dimensions of Square and Hexagonal Bolts 1007 Dimensions of Hexagonal Cap Screws and Heavy Hexagonal…

    • 19215 Words
    • 77 Pages
    Satisfactory Essays

Related Topics