Preview

Labview

Powerful Essays
Open Document
Open Document
56372 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Labview
LabVIEW® Tutorial Manual

January 1996 Edition Part Number 320998A-01

© Copyright 1993, 1996 National Instruments Corporation. All Rights Reserved.

Internet Support

GPIB: gpib.support@natinst.com DAQ: daq.support@natinst.com VXI: vxi.support@natinst.com LabVIEW: lv.support@natinst.com LabWindows: lw.support@natinst.com HiQ: hiq.support@natinst.com E-mail: info@natinst.com FTP Site: ftp.natinst.com Web Address: http://www.natinst.com
Bulletin Board Support

BBS United States: (512) 794-5422 or (800) 327-3077 BBS United Kingdom: 01635 551422 BBS France: 1 48 65 15 59
FaxBack Support

(512) 418-1111 or (800) 329-7177
Telephone Support (U.S.)

Tel: (512) 795-8248 Fax: (512) 794-5678 or (800) 328-2203
International Offices

Australia 03 9 879 9422, Austria 0662 45 79 90 0, Belgium 02 757 00 20, Canada (Ontario) 519 622 9310, Canada (Québec) 514 694 8521, Denmark 45 76 26 00, Finland 90 527 2321, France 1 48 14 24 24, Germany 089 741 31 30, Hong Kong 2645 3186, Italy 02 48301892, Japan 03 5472 2970, Korea 02 596 7456, Mexico 95 800 010 0793, Netherlands 0348 433466, Norway 32 84 84 00, Singapore 2265886, Spain 91 640 0085, Sweden 08 730 49 70, Switzerland 056 200 51 51, Taiwan 02 377 1200, U.K. 01635 523545
National Instruments Corporate Headquarters

6504 Bridge Point Parkway Austin, TX 78730-5039 Tel: (512) 794-0100

Important Information

Warranty
The media on which you receive National Instruments software are warranted not to fail to execute programming instructions, due to defects in materials and workmanship, for a period of 90 days from date of shipment, as evidenced by receipts or other documentation. National Instruments will, at its option, repair or replace software media that do not execute programming instructions if National Instruments receives notice of such defects during the warranty period. National Instruments does not warrant that the operation of the software shall be uninterrupted or error free. A Return Material

You May Also Find These Documents Helpful

  • Satisfactory Essays

    LAB 6

    • 5674 Words
    • 23 Pages

    CHM130 Lab 6 Exploring Density Name A. Data Tables Place your completed Data Tables here Part IIIa (3 points) Volume of water in graduated cylinder (mL)10 mlMass of rubber stopper (g)11.15Volume of water and rubber stopper (mL)16.5 Part IIIb (6 points) Volume of water in graduated cylinder (mL)20Mass of iron nail (g)3.66Volume of water and iron nail (mL)20.5 Part IV (20 points) Type of Aluminum FoilMass (g)Length (cm)Width (cm)Volume (cm3)Thickness (cm)Regular.63g15 cm 10.02 cm.21 cm3.0014 cm Heavy Duty.97g15 cm10.01 cm .36 cm3.0024 cm B. Follow Up Questions Show all work for questions involving calculations. Part I Use the concepts/vocabulary of density to explain why the liquids formed layers in Part I of the procedure. (8 pts) The liquids formed layers because they all had different densities. The liquids with light density were towards the top of the layers. What was the control used during the liquid portion of Part I of this experiment (8 pts) (Hint What did you do the same with each liquid to ensure a fair comparison) The control used during the portion of part I was the amount of liquid used. Rank the following in terms of relative density (9 pts) Isopropyl alcohol (rubbing alcohol) lowest relative density Liquid dishwashing detergent- intermediate relative density Dark corn syrup-high relative density Vegetable oil-second lowest relative density (intermediate) Glycerin-second highest relative density Rubber stopper- second highest relative density Cork stopper- low relative density (ended up with the alcohol Wood- low relative density (ended at the top with the rubber alchohol. Lead- highest relative density Part II (7 pts each) In Part II, what happened to the cans of soda when you placed them in water Use the concepts/vocabulary of volume and mass to explain the final positions of the cans in the sink full of water. The diet soda floated in the water while the regular soda sank. The regular soda had a higher relative…

    • 5674 Words
    • 23 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Lab 2

    • 310 Words
    • 2 Pages

    Question 1: What is the name of the computer you are working from? The Name of the computer is W2K8xx…

    • 310 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Lab 7

    • 995 Words
    • 4 Pages

    d. How well does each flip (or half-life) actually eliminate half of the remaining parent isotopes?…

    • 995 Words
    • 4 Pages
    Good Essays
  • Good Essays

    Lab 5

    • 2594 Words
    • 10 Pages

    In gymnosperms, pollination is the transfer of pollen (Fig. 2) from male cones (where pollen is produced) to female cones, which house eggs. In these plants, pollen is carried from male cones to female cones by wind - gymnosperms were the first plants to evolve that did not need free water to transfer sperm to egg, and were therefore able to thrive in terrestrial habitats. Pollen grains are also protected by tough coats. After fertilization, seeds are produced with developing embryos…

    • 2594 Words
    • 10 Pages
    Good Essays
  • Satisfactory Essays

    Lab 12

    • 441 Words
    • 3 Pages

    2. Use your procedure to find g on Planet X. Show your data, graphs, and calculations that support your conclusion.…

    • 441 Words
    • 3 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Lab 3

    • 789 Words
    • 4 Pages

    To predict caloric expenditure you can plug in a measured heart rate and calculate the predicted VO2 (L/min). Then using the predicted VO2 and an estimated thermal equivalent (4.825 kcal/LO2), you can estimate the caloric expenditure. Nonetheless, each individual’s heart rate varies. These can be attributed to gender differences, physical activity and physical training. So, if the person is of the same gender and is as healthy as you are and does the same amount of exercise then it could be possible to use their regression line to estimate your own caloric expenditure however the limitations would be possibly the difference in size of the lungs for the estimation of VO2 max. Weight would be important, as it is required to calculate the predicted caloric expenditure. However if your weight can be misleading because one can simply weigh more because they are taller, not because they are bigger. Height does not play such an important role. When you are taller, your body does need to pump more blood throughout the body. This means that they will pump more blood per beat but not that they would have a higher heart rate. It is important to remember that a linear relationship exists between…

    • 789 Words
    • 4 Pages
    Satisfactory Essays
  • Good Essays

    Lab 2

    • 514 Words
    • 2 Pages

    2. Create a user account named Kim in the Sales OU by using the following command:…

    • 514 Words
    • 2 Pages
    Good Essays
  • Satisfactory Essays

    Lab 1

    • 567 Words
    • 3 Pages

    Attacker would avoid detection by covering tracks step of the hacking process where they cover up their tracks in the system they hacked into.…

    • 567 Words
    • 3 Pages
    Satisfactory Essays
  • Satisfactory Essays

    lab 2

    • 398 Words
    • 2 Pages

    1. Compare the hash values calculated for example.txt that you documented during this lab. Explain in your own words why the hash values will change when the data is modified.…

    • 398 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Lab 7

    • 928 Words
    • 3 Pages

    1. What are some common risks, threats, and vulnerabilities commonly found in the LAN-to-WAN Domain that must be mitigated through a layered security strategy?…

    • 928 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    Lab 1

    • 414 Words
    • 2 Pages

    4. Why would you use a tool like DevManView while performing a computer forensic investigation?…

    • 414 Words
    • 2 Pages
    Satisfactory Essays
  • Best Essays

    Comrad delivered the software via internet download and certain areas of the software did not function as required. Gammasonics claimed to terminate the contract for breach of terms including “failure to deliver a functioning software package, failure…

    • 2215 Words
    • 9 Pages
    Best Essays
  • Good Essays

    HARVARD MANAGEMENT UPDATE • H ARVARD BUSINESS REVIEW • HBS CASES • HBS PRESS • HBS VIDEOS AND INTERACTIVE MEDIA…

    • 2399 Words
    • 10 Pages
    Good Essays
  • Satisfactory Essays

    Scania

    • 419 Words
    • 2 Pages

          Part/Item no: Insert the Scania part number of the part/assembly. Description: The denomination on the Scania drawing shall be used. Drawing No.: Input the Scania Drawing number, if available. (The drawing number may be different than the part number.) Drawing dated: Insert the date of release of the current revision of the drawing. Drawing Change Level: Input the Scania Engineering Change Order number (ECO) (See example on next page) [5-7 digit number] Supplier Code: Input the Scania supplier code [7 digit number]…

    • 419 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Globaization on Education

    • 295 Words
    • 2 Pages

    *All price are subject to change without prior notice (new pricelist as of march 2012)…

    • 295 Words
    • 2 Pages
    Satisfactory Essays

Related Topics