Preview

NETW410 Week 5 Lab Report

Satisfactory Essays
Open Document
Open Document
297 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
NETW410 Week 5 Lab Report
Name
NETW410, Professor
Date
Lab 5: Network Addressing Design

Lab Report

1. Provide an IP addressing plan for the existing campus and the new campus. (70 points)

The internal network will use private ip addresses, while the external network will use a public ip addressing scheme. The modems for all sites will use static public ip addresses. This will help to keep the ip address the same at each site and to make it possible to for the sites to connect to one another. All of the computers attached to the network will be using dynamic ip addresses in which will be automatically obtained based on availability. Any networked printers should have dhcp reservations created within the network to hold that ip address and prevent any other devices from obtaining this same ip address. Instructor’s computers will have their own separate vlan to prevent students from accessing sensitive information. The wireless access points will have ip ranges assigned to each type of network, the guest network and student network will be on their own respective vlans. Each device on both of these vlans will automatically obtain an ip address. The internal servers will also be on separate vlans, and will be assigned static private ips. This will make the resources easily accessible. The student portal is being used on the internet through an external website; this will use a public ip address in which will be statically provided by the host.

Public IPs
Student portal web site statically assigned by company: http://www.website.com (62.135.187.62)
Modems- statically assigned by provider, ex: 72.165.187.62

Private IPs
Instructor’s computers-dynamic ips: 10.41.40.xxx – 10.41.50.xxx
Student wireless network-dynamic ips: 10.71.40.xxx-10.71.80.xxx
Guest wireless network-dynamic ips: 10.71.102.xxx-10.71.108.xxx
Internal servers-static assigned- 10.90.200.xxx-10.90.240.xxx

You May Also Find These Documents Helpful

  • Satisfactory Essays

    Nt1310 Unit 6 Lab Report

    • 700 Words
    • 3 Pages

    1. The compass was placed on the lab table with no magnets nearby to identify what direction was north relative to the classroom.…

    • 700 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    Nt1310 Unit 1 Lab Report

    • 609 Words
    • 3 Pages

    Visualize your radioactively labeled target sequence. If you used a radiolabeled 32P probe, then you would visualize by autoradiograph.…

    • 609 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    Adjust cell suspension volume with media so that between 15 to 100 L of cells are used for each well/dish. This small plating volume ensures that there is even cell distribution and that growth factors, drugs, or substrates in the medium are not diluted.…

    • 237 Words
    • 1 Page
    Satisfactory Essays
  • Satisfactory Essays

    Nt1310 Unit 3 Lab Report

    • 665 Words
    • 3 Pages

    The ping pong balls stack on top of one another with no space between them.…

    • 665 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    Nt1310 Unit 5 Lab Report

    • 490 Words
    • 2 Pages

    From figure 48, The same process repeats to remove the defected products. Until the defect sensor is turned off, the products will be detected as defective and simultaneously the input (0.02) should be turned on and off to visualize every shift in the conveyor belt.…

    • 490 Words
    • 2 Pages
    Good Essays
  • Good Essays

    Nt1310 Unit 1 Lab Report

    • 2556 Words
    • 11 Pages

    Lab #11 Software Defined Radio (SDR) I. Experimental Procedure Equipment List Universal Software Radio Peripheral (USRP) with Flex900 Radio Spectrum analyzer (Agilent E4411 or equivalent) PC with Matlab/Simulink R2011B CAT 6 Ethernet cable SMA(male)-to-BNC Adapter (for spectrum analyzer) 915 MHz Antenna (qty 2) A. INSTRUMENT CONNECTIONS: Connect the antenna to the SMA connector labeled RF1 port on the front of the USRP. Connect another antenna to the spectrum analyzer. Power the USRP with a 6v/3A power adapter. B. CONFIGURE PC: a. Connect the CAT6 cable between the PC and the GB Ethernet port of the USRP. b. Manually set the PC’s Ethernet port IP address under the same subnet mask as the…

    • 2556 Words
    • 11 Pages
    Good Essays
  • Satisfactory Essays

    NETW410 Week 3 Lab Report

    • 532 Words
    • 2 Pages

    4. Does this network require an access layer? What devices would operate at the access layer? Draw a diagram of these devices at the access layer. Label all of the devices. (10 points)…

    • 532 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Nt1310 Unit 7 Lab Report

    • 493 Words
    • 2 Pages

    Change the weight. Let W+AB be the new (trained) weight and WAB being the initial weights. Notice that it is the output of the connecting neuron (neuron A). Update all the weights in the output layer in this way.…

    • 493 Words
    • 2 Pages
    Good Essays
  • Powerful Essays

    Nt1310 Unit 4 Lab Report

    • 5478 Words
    • 22 Pages

    have been used to be bombarded by the α-particles. If the thin foil of light atoms like aluminium etc. is used, what difference would be observed from the above results?…

    • 5478 Words
    • 22 Pages
    Powerful Essays
  • Satisfactory Essays

    Nt1310 Unit 8 Lab Report

    • 261 Words
    • 2 Pages

    On the right in Figure 27 shown the power density spectral of noise measurements at low frequencies, from 1 Hz to 14 Hz and used commercial resistance of 1 kΩ to compare 2 different current generators. The curves in red color correspond KEITHLEY 2400 series and the curves in black color correspond to the ADRET current generator. The KEITHLEY generator slightly lower noise than ADRET generator. However, theoretically the differential measure with correct polarization can suppress this kind of noise origin from the current generator.…

    • 261 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Nt1310 Unit 2 Lab Report

    • 822 Words
    • 4 Pages

    How is the resulting volume different from the one you created in Exercise 2.1? Explain why.…

    • 822 Words
    • 4 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Write a paragraph (a minimum of five college-level sentences) below that summarizes what was accomplished in this lab, what you learned by performing it, how it relates to this week’s TCOs and other course material, and just as importantly, how you feel it will benefit you in your academic and professional career. (8 points) ok since this was the same as last week switch router setup, it was entering the same commands basically but seem shorter. So I learned a switch set up is a much longer process, maybe because a switch is hardware based. It relates to this week’s TCO’S by understanding addressing, theory of how switches and bridges are basically the same. As with that this is good to know for a future job so that you can determine where and when you need to use a switch or a bridge to accomplish your network goals.…

    • 786 Words
    • 4 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Lab work—If either party has had previous sexual relationships, each should be tested for HIV and other sexually transmitted diseases. Undiagnosed sexually transmitted diseases can lead to infertility in both men and women. Testing for hepatitis is also advisable.…

    • 81 Words
    • 1 Page
    Satisfactory Essays
  • Good Essays

    Nt1310 Unit 3 Lab Report

    • 880 Words
    • 4 Pages

    For most of the questions I found the divisors or made generalizations based on other information I gained via other numbers divisors or I used logic to figure out simple rules to apply to the numbers.…

    • 880 Words
    • 4 Pages
    Good Essays
  • Satisfactory Essays

    Why Bother?

    • 722 Words
    • 3 Pages

    | A Web site that allows anyone to add or edit content is called a ________.…

    • 722 Words
    • 3 Pages
    Satisfactory Essays

Related Topics