Preview

nt1210 lab 7.1-3

Satisfactory Essays
Open Document
Open Document
420 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
nt1210 lab 7.1-3
1. It’s impractical for an organization to own the entirety of a WAN because it would be to maintain the entirety, it’s to maintain the entirety of a LAN because it’s easier to maintain and
2. Attenuation

1. The quality of UTP cables can vary from telephone-grade wire to extremely high-speed cable. They more prevalent in school networks. Coaxial can support great cable lengths between network devices. Coaxial cable has been popular in school networks, especially linear bus networks.
2. It’s because the signal still has to be able to be picked up by the AP it would have to depend on the router to pick up the signal

1. Security, and access

2. Cost, and speed

3. The advantage of partial mesh topology over a full mesh is that it is less expensive and more feasible to create

Circuit classification
Total Bandwidth (Mbps)
Features and Summary
T1
1.544
24 DS0 channels
E1
2.048
30 64Kbps channels + 2 64Kbps D
E3
34.4
32 channels
T3
44.736
672 channels

1. PPP is the directional movement of data between nodes, you use it to move data to specific places.
2. WAN transmits signals while the LAN is able to transmit direct electrical pulses.

1. Cloud computing would be the best option, by using it the all parties can communicate. With this Headquarters would be able to place the order to Manufacturing to start the order. With that the manufacturing can place any supply orders need to Foundry to create the ordered product. Also this can allow the Shipping Site A to notify Shipping Site B of the status on the product allowing Shipping B to also communicate with Shipping Site C. features & benefits Service Level Agreement across the complete network Managed Security which allows management of all content in and out of the network, which in effect outsources all your security to.

Cloud Computing: can offer a wide range of "Infrastructure as a Service" Cloud computing services within the network all

You May Also Find These Documents Helpful

  • Satisfactory Essays

    NT 1310 Unit 8 Lab 1

    • 595 Words
    • 2 Pages

    The most critical part, the Cable and Fiber Preparation where the fiber is mounted, is the ferrule. The Ferrule is a long, thin cylinder with the fiber mounted in the center hole. The center hole is sized to match fiber's cladding diameter which is usually 125um. When fiber connector ferrules are made from several types of materials including ceramic(Zirconia), stainless steel and plastic. The ferrule's job is to center and align the fiber and protects it from mechanical damage. The end of fiber is at the end of the ferrule, where the fiber end is polished smooth either flat or with a curvature. The ferrule is mounted in the connector body and then the connector body is attached to the fiber optic cable structure. Finally, a strain-relief rubber boot protects the connector-cable junction.…

    • 595 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Nt1210 Lab 3.1.3

    • 427 Words
    • 2 Pages

    Two chains are required to transmit power from the engine to the tire. A #35 duplex chain transmits power from the crankshaft of the engine to the main shaft. A #35 single strand chain transmits power from the output sprocket to the tire. To calculate the length of the chain necessary to last for 10^7 cycles of the main shaft, equations (5) is used:…

    • 427 Words
    • 2 Pages
    Good Essays
  • Good Essays

    Nt1310 Unit 4

    • 313 Words
    • 2 Pages

    1) Block B in Fig. 6-31 weighs 603 N. The coefficient of static friction between block and table is 0.32; angle θ is 33°; assume that the cord between B and the knot is horizontal. Find the maximum weight of block A for which the system will be stationary.…

    • 313 Words
    • 2 Pages
    Good Essays
  • Good Essays

    NT1310 Unit 9 Lab 1

    • 1254 Words
    • 4 Pages

    The new structure has been given a grant to make its network state of the art by making it a fiber optic network. The topics of discussion that will be mentioned in this paper are the hardware that will be necessary for the inside and outside of the building and how we would expand the fiber to an adjacent building if it is built. Another topic to be discussed will be describing the safety procedures that will be following during the installation.…

    • 1254 Words
    • 4 Pages
    Good Essays
  • Satisfactory Essays

    Nt1310 Unit 4

    • 775 Words
    • 4 Pages

    Part III PHYSICS HSE II Time:2Hours Max:60 Scores 1. Three identical charges each +q are placed at the corners of an equilateral triangle of side d cm. Calculate the force on a +ive charge +2q at the centroid of the triangle. 2 2.If the earth is supposed to be a metallic sphere,its capacity will be nearly (a) 700pf (b) 700 microfarad (c) 700f (d) 6.4 X10^6 f 1score 3. write the relation between dielectric constant and electric susceptibility. 1score 4. A box encloses an electric dipole consisting of charge 5micro C and -5micro C and of length 10cm. What is the total electric flux through the box? 2scores 5. Find the ratio of the p.d that must be applied across the (1)parallel (2) series combination of two identical capacitors so that the energy stored in the two cases becomes the same. 2 scores 6.(a)…

    • 775 Words
    • 4 Pages
    Satisfactory Essays
  • Good Essays

    Nt1310 Unit 4 Lab

    • 370 Words
    • 2 Pages

    Read the paper “Post–Green Revolution Trends in Yield Potential of Temperate Maize in the North-Central United States” by Duvick and Cassman (In Blackboard – Seed Technology folder).…

    • 370 Words
    • 2 Pages
    Good Essays
  • Satisfactory Essays

    Nt1310 Unit 6 Lab

    • 140 Words
    • 1 Page

    1.) Test for viscosity: Since DNA molecules are long strands that anneal to each other, they can be very viscous in liquid if they're at a high enough concentration. If I notice the sample sticking together while pipetting it, I'll often know that I have a lot of DNA in the sample.…

    • 140 Words
    • 1 Page
    Satisfactory Essays
  • Satisfactory Essays

    NT1230 Lab 4

    • 56 Words
    • 1 Page

    1. What tasks can you perform in the J.Adams Properties dialog box that you could not perform in the User Accounts control panel?…

    • 56 Words
    • 1 Page
    Satisfactory Essays
  • Good Essays

    Nt1310 Lab 4.1

    • 666 Words
    • 3 Pages

    4.2.4 Explain that non-disjunction can lead to changes in chromosome number, illustrated by reference to Down…

    • 666 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    NT 1210 Lab 4

    • 667 Words
    • 3 Pages

    Complete the entries in Table 4- 1. Use your textbook and Internet research to compose your answer. The common connector for interfacing UTP wires to a computer for networking is the Registered Jack 45 ( RJ- 45) interface. This uses eight copper wires ( four twisted pairs) to complete the connection between interfaces. The pinout for these wires defines the order in which the individual wires connect to the network interface card and how the wires transition from one end of the cable to the other. A straight cable is used to connect a device to a network hub or switch. This type of cable does not change the wiring…

    • 667 Words
    • 3 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Nt1330 Unit 3

    • 273 Words
    • 2 Pages

    1. Identify and explain key trends that are occurring in computer peripheral devices? How do these trends affect business uses of computers?…

    • 273 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    NT1210 Lab 3.1 Review

    • 505 Words
    • 3 Pages

    What is the history of the TCP/IP model? Why was it created? Use your textbook and Internet research to support your answer.…

    • 505 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    It241 Appendix B

    • 1021 Words
    • 5 Pages

    0 For the wireless technology you identified, what is the standard transmission distance and transfer speed? 33' and 1 Mbps…

    • 1021 Words
    • 5 Pages
    Good Essays
  • Good Essays

    4. You have just started a new business. You need to have three to four workstations available for your…

    • 1887 Words
    • 8 Pages
    Good Essays
  • Good Essays

    Retele de Calculatoare

    • 1246 Words
    • 5 Pages

    Networks, including the internet, are one of the most essential things to businesses. Without computer networks, companies would be lost and would not have a way to communicate without these systems and this would cause businesses to operate slower (Network 1). Patch works of older networking systems are easier to find these days (Network 1). Starting relationships between many businesses, networks in many ways become synonymous with the groups and businesses they bring together (Network 1). Business employees, customers, and business partners would have available access to their information stored in network systems, could get to their network systems and share them easily among themselves (“Network” 1). Computer networks give their owners speed, ability to connect, and ultimately value to their users. They give possible solutions for business difficulties and issues that would not be possible to other businesses (Network 1). Computer networking systems are required for electronic communications. (Network 1) As time moves on, businesses’ spend a ton of money on computer systems that are used to manage various functions such as accounting, human resources, customer service, purchasing, inventory management, etc. (Network 1) In a world considered perfect, companies would be able to combine all of their computer systems together both new and old (Network 1).…

    • 1246 Words
    • 5 Pages
    Good Essays