Preview

Paper on Pic Based Water Level Indicator with Automatic on /Off Motor Control

Good Essays
Open Document
Open Document
828 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Paper on Pic Based Water Level Indicator with Automatic on /Off Motor Control
ACET

akshaya COLLEGE OF ENGINEERING AND TECHNOLOGY
Kinathukadavu - Coimbatore -642109

SECURITY BREACH ALARM
USING PIC 16F877A

SUBMITTED BY,
R.Balaji,
S.Vijay,
L.C.Darius christo,
B.Karthikeyan.

ABSTRACT If a person entering to the monitored area, after sensing the person LDR checks the light intensity of the monitored area, whether it is bright or dark. Depending on the LDR output, the buzzer will beep to indicate the crossing of a person.
By interfacing buzzer and LDR with PIC16F877A when a person crosses the continuously emitted light ray on LDR, alarm will hear for person inside the home.
The project is mainly based on the security problems, the is one of the efficient method to overcome the security based problems.

COMPONENTS USED:
· PIC controller kit PIC16F877A · Computer · Rs232 cable

· Power cords

· LDR

· Buzzer

· Connecting wires

SOFTWARES USED:

· MPLAB IDE 8.50 · ISIS proteus

BLOCK DIAGRAM:

DESCRIPTION OF COMPONENTS:

LDR: LDR’s or Light Dependent Resistors are very useful especially in light/dark sensor circuits. These help in automatically switching ON /OFF the street lights and etc., normally the resistance of an LDR is very high, sometimes as very high as 1000000 ohms, but when they are illuminated with light,

You May Also Find These Documents Helpful

  • Good Essays

    The security controls for this or any project should be a high priority and should be understood by every individual involved in the project. To determine this we will use the questions…

    • 775 Words
    • 4 Pages
    Good Essays
  • Good Essays

    transmits less light than a solution of lower concentration. The device monitors the light received…

    • 476 Words
    • 2 Pages
    Good Essays
  • Better Essays

    Nt1310 Unit 1 Assignment 1

    • 7711 Words
    • 31 Pages

    The system stores all the necessary information about the user. A new user is first registered to the system and the corresponding information is burned in the RFID tag. This RFID tag will then be accessible through the system. When a registered user comes to the entry point and puts his/her tag into the reader, the system checks whether he/she is a registered user or an imposter. If the user is registered, then the tab information is matched with the user information stored in system. The door is opened after the successful authentication and is closed automatically after a specific time interval. The check-in information is also stored in the database with the corresponding date and time. A log is also generated by the system according to the check-in information. Finally, this check-in information is stored in a central server along with the basic information of the…

    • 7711 Words
    • 31 Pages
    Better Essays
  • Good Essays

    *Line waiting- This little button usually will flash/beep or even both when there is a call waiting.…

    • 2522 Words
    • 11 Pages
    Good Essays
  • Good Essays

    The Virginia Plan, drafted by James Madison and proposed at the Constitutional Convention by Edmund Randolph, was to install a national government with a bicameral legislature and was to be comprised by representative that held seats, in the new congress, in proportion to each states population. After the delegates at convention accepted the Virginia Plan as a basis to build on the national government, debate quickly arose against the share of distributed legislative power the northern states would have over the southern states to make national policy. This was due to the northern states having much larger populations than those of the south, but since the southern states had amassed a large number of slaves, it was believed that the southern representation in congress should also include the slave population. The northern states were opposed to this idea given that slaves were generally…

    • 469 Words
    • 2 Pages
    Good Essays
  • Good Essays

    Physics Isa

    • 5705 Words
    • 23 Pages

    * Special resistors, such as thermistors and light-dependent resistors (LDRs): Thermistors change resistance as temperatures change. Most thermistors have a negative temperature coefficient, meaning their resistance falls as temperature increases. Thermistors are used in temperature-sensing circuits. Light-dependent resistors (LDRs) change resistance as light levels change. The light levels are detected by a photo-sensitive plate on the resistor. Most LDRs have a negative light coefficient, meaning that their resistance falls as the amount of light falling on them increases. LDRs are used in light-detection circuits.…

    • 5705 Words
    • 23 Pages
    Good Essays
  • Good Essays

    With the use of computers and networks, there is also a large focus on security. Whenever there is sensitive data being stored and transferred through computer networks, there is the risk of unauthorized individuals gaining access to this information. To lower these chances, we have several different pieces of software and also require multiple passwords that are unique to each authorized individual and a requirement to change the passwords…

    • 791 Words
    • 4 Pages
    Good Essays
  • Powerful Essays

    Buisness and Admin

    • 3809 Words
    • 16 Pages

    Allows you to track and record telephone calls so the person can always look back on who's called in and who they have called out and how long the telephone calls was.…

    • 3809 Words
    • 16 Pages
    Powerful Essays
  • Satisfactory Essays

    My true passion in life has always been cooking. Being born to a father who had an unconditional love for his family and an affinity for cooking made me feel that being in the kitchen was where I always wanted to be. I always admired my father’s love and commitment not only to us but to his craft and even though he was a carpenter by trade; deep down inside he was a chef at heart. He always took the time to explain the “who, what, where and why” of what he was preparing even though he was not formally trained or educated in this art. He always had a story that directly related to the dish he was preparing that would captivate me and immerse me into every single subtlety of its preparation.…

    • 558 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    cation. When the brake is applied, the green LED blinks and the piezobuzzer beeps for around one second if the brake system is intact. If the brake fails, the red LED glows and the buzzer stops beeping. The circuit will work only in vehicles with negative grounding. It also gives an indication of brake switch failure. In hydraulic brake systems of vehicles, a brake switch is mounted on the brake cylinder to operate the rear brake lamps. The brake switch is fluidoperated and doesn’t function if the fluid pressure drops due to leakage. The fluid leakage cannot be detected easily unless there is a severe pressure drop in the brake pedal. This circuit senses the chance of a brake failure by…

    • 584 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Water Level Indicator

    • 308 Words
    • 2 Pages

    ere is a simple, versatile circuit which indicates the level of water in a tank. This circuit produces alarm when water level is below the lowest level L1 and also when water just touches the highest level L12. The circuit is designed to display 12 different levels. However, these display levels can be increased or decreased depending upon the level resolution required. This can be done by increasing or decreasing the number of level detector metal strips (L1 through L12) and their associated components. In the circuit, diodes D1, D2 and D13 form half-wave rectifiers. The rectified output is filtered using capacitors C1 through C3 respectively. Initially, when water level is below strip L1, the mains supply frequency oscillations are not transferred to diode D1. Thus its output is low and LED1 does not glow. Also, since base voltage of transister T1 is low, it is in cut-off state and its collector voltage is high, which enables melody generating IC1 (UM66) and alarm is sounded. When water just touches level detector strip L1, the supply frequency oscillations are transferred to diode D1. It rectifies the supply voltage and a positive DC voltage develops across capacitor C1, which lights up LED1. At the same time base voltage for transistor T1 becomes high, which makes it forward biased and its collector voltage falls to near-ground potential. This disables IC1 (UM66) and alarm is inhibited. Depending upon quantity of water present in the tank, corresponding level indicating LEDs glow. It thus displays intermediate water levels in the tank in bar-graph style. When water in the tank just touches the highest level detector strip L12, the DC voltage is developed across capacitor C2. This enables melody generating IC1 (UM66) and alarm is again sounded.…

    • 308 Words
    • 2 Pages
    Good Essays
  • Satisfactory Essays

    Water Alarm

    • 557 Words
    • 3 Pages

     Our main requirements for the indicator are as follows: o Low Power consumption o Compact, with less Electronic complexity o Simplified result o Economical  So the recommended solutions for the above mentioned…

    • 557 Words
    • 3 Pages
    Satisfactory Essays
  • Powerful Essays

    water level indicator

    • 2033 Words
    • 9 Pages

    This is to certify that project report entitled “Water Level Indicator & Automatic Motor Starter” presented by Sanjay Kumar Singh, Rajesh ydav student of 6th semester BE in Electronics & Communication Engineering is the bona-fide presentation of his work done by him under my supervision and guidance. He has submitted this project report towards partial fulfillment for the award of degree of Bachelor of Engineering of the Rajiv Gandhi Proudyogiki Vishwavidyalaya during the academic year 2010-11. It is further certified that this work has not been submitted elsewhere for the award of any degree.…

    • 2033 Words
    • 9 Pages
    Powerful Essays
  • Good Essays

    Mobile Controled Robot

    • 758 Words
    • 4 Pages

    called ‘Dual Tone Multiple frequency’ (DTMF) tone. The robot receives these tones via the receiver mobile phone which is on board. The received tone is processed by the microcontroller with the help of DTMF decoder…

    • 758 Words
    • 4 Pages
    Good Essays