INTRODUCTION
Mixtures obtained from the biosphere, lithosphere, hydrosphere or atmosphere can be industrially separated into their constituents. Petrol for example is obtained from crude oil found in the lithosphere.
RESEARCH SKILLS
When researching this assignment you will access a variety of secondary resources including web sites and textbooks.
Please include a detailed bibliography
You should also consider both the validity and reliability of your sources.
Reliability
How consistent is the information with information from other reputable sources?
Validity
How was the information gathered? Do the findings relate to the hypothesis or problem? Do you consider the authors and publishers of the information have sufficient credentials to be trustworthy?
TASK
Prepare a short report describing the industrial separation processes used on crude oil obtained from the lithosphere. (max length – 2 pages, max file size – 2MB)
MARKING CRITERIA
In your assignment make sure you include the following points:
include details of the separation process used identify the property of the mixture that is used in the separation process
Use a table to identify the products of separation and their potential uses include a labelled diagram showing a fractionating column describe the possible and probable uses of any waste products discuss the validity of the secondary sources you used discuss the reliability of the secondary sources you used
You May Also Find These Documents Helpful
-
• Sketch a design for your separating mixtures device. Label each part of your device with the object name and briefly describe what is occurring at that point. This part of your project does not have to be typed, but remember to write legible!…
- 983 Words
- 4 Pages
Powerful Essays -
7.Use at least four (4) quality academic resources in this assignment. Note: Wikipedia and other Websites do not qualify as academic resources. Your assignment must follow these formatting requirements:…
- 469 Words
- 2 Pages
Satisfactory Essays -
C. Preview of Main Points: The massive-scale extraction of "black oil," underway for years now, seeks to suck out the remaining 170 billion barrels beneath the Boreal forest, of which huge swaths are destroyed to get to the oil underneath. Massive quantities of freshwater are used to "steam out" the viscous petrol from the tar-like sands. The Process turns the earth into toxic sludge and gives off vast amount of C02…
- 601 Words
- 3 Pages
Good Essays -
Relevant articles are assigned in the course outline that follows. They may be accessed through institutional websites and the Pace University Library.…
- 2290 Words
- 10 Pages
Powerful Essays -
Use at least five (5) quality academic resources in this assignment. Note: Wikipedia and other Websites do not quality as academic resources.…
- 256 Words
- 1 Page
Satisfactory Essays -
Using the text for this course, the University Library, the Internet, and/or other resources answer the following questions. Your response to each question should be at least 200 words in length.…
- 813 Words
- 4 Pages
Good Essays -
The initial mass of unknown # 12-Green was recorded. The first substance separated from the mixture was iron based on its unique magnetic property. A magnet was used to extract the iron from unknown # 12-Green and the mass of the iron fillings was recorded. The next substance separated from the mixture was ammonium chloride based on its unique ability to sublimate. Unknown # 12-Green was heated with a Bunsen burner in a fume hood (note the special precaution) until the ammonium chloride was entirely extracted. The mass of the mixture was obtained to determine the amount of ammonium chloride lost due to sublimation and the mass of ammonium chloride in the mixture was recorded. Next, the extraction separation technique was used to separate the two remaining substances, silicon dioxide and sodium chloride. Extraction is used to remove a substance with a greater solubility from a substance with a lower solubility. In this case, silicon dioxide is not soluble in water while sodium chloride is. Therefore, approximately 20mL of deionized water was added to the mixture. The mixture was stirred until the sodium chloride was dissolved and the silicon dioxide had settled to the bottom of the dish. The filtration separation technique was used to separate the silicon dioxide from the sodium chloride suspended in water. The silicon dioxide collected in the filter paper was placed in the oven until it was…
- 1046 Words
- 5 Pages
Better Essays -
What evidence does the report provide that the analysis is accurate and appropriate? Were data displayed in a manner that allows you to verify the researcher's conclusions? (4…
- 1079 Words
- 5 Pages
Better Essays -
3. Utilize the required readings, academic websites, and the GCU e-Library as resources for this assignment.…
- 349 Words
- 2 Pages
Satisfactory Essays -
This study guide is intended to facilitate your studying of the topics covered in class, from supplemental resources and in your textbooks.…
- 348 Words
- 2 Pages
Satisfactory Essays -
3. How would you determine the credibility of the sources of information used by the authors in the articles when investigating the problems or issues presented by your topic?…
- 862 Words
- 3 Pages
Good Essays -
Cite all of the resources used with in-text citations, using at least two sources from the Topic 3 readings. These will be included in the list of references at the end of the assignment.…
- 1156 Words
- 4 Pages
Good Essays -
Use at least three (3) quality academic resources in this assignment. Note: Wikipedia and other Websites to not qualify as academic resources.…
- 1183 Words
- 5 Pages
Powerful Essays -
When seeking out the validity, credibility, and reliability of a source there can be a vast array of sources to compare when seeking this answer. For example, when validating a source we can research the author and his or her background pertaining to the data in question. Data within a claim can be meant to sway the reader one way or the other, with this in mind, I look at who and what there is to gain from this claim.…
- 258 Words
- 2 Pages
Satisfactory Essays -
Kerogen and coal are both derived from organic matter. Organic matter is a matter that is derived from the breakdown of plant and animal, it is able to decay or product of decay, it must be composed of organic or carbon compounds. Kerogen and coal and other rocks are formed by diagenetic alteration that takes place during the process called diagenesis. During diagenesis, the sediments will undergo compaction and consolidation that will caused the reduction of volume of voids that are filled by fluids, and the temperature will increase. Such factors are enough for the sediments to alter or change physically and chemically.…
- 457 Words
- 2 Pages
Good Essays