Preview

Steel and Corrosion

Satisfactory Essays
Open Document
Open Document
1164 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Steel and Corrosion
Internet.
References
1 Delahunt, J. F. "Corrosion Control Under Thermal Insulation and Fireproofing." Proceedings: Exxon Research & Engineering Co. Internal Conference on Corrosion Under Insulation (1984): p 554. http://www.nationalboard.org/Index.aspx?pageID=184
2 Butler, G., and H. C. Ison. "Corrosion and Its Prevention in Waters." Melbourne, FL: Robert E. Krieger. (1976): Ch. VI, p lO2. http://www.kastenmarine.com/_pdf/mbqCref.pdf
3 Midwest Insulation Contractors Association. "Commercial and Industrial Insulation Standards." Omaha, NE. (1983): Plate No.1-50. http://corrosion-doctors.org/Corrosion-History/References.htm
4 National Board Inspection Code, NB-23, Rev.6. Columbus, OH: The National Board of Boiler and Pressure Vessel Inspectors. (1987). http://www.kastenmarine.com/_pdf/mbqCref.pdf
 Adie, R.: On the corrosion of metals. 10 p. 1845. (In Minutes of proceedings of the Institution of Civil Engineers, v. 4, p. 323.) Shows that saturated salt solutions are a great protection from corrosion.
 Akerman, R.: Ueber das rosten des eisens. 4,200 w. 1882. (In Stahl and eisen, v. 2, p. 417.) Considers theory of rusting, especially of protective metal coatings, and of the influence of manganese in the rusting of steel.
 Alford, H. Carroll: Corrosion of iron and its prevention. 2,200 w. 1901. (In Proceedings of the St. Louis Railway Club, v. 5, April 12, p. 9.) Theory of rust formation and preventive measures.
 American Society for Testing Materials: 1,800 w. 1906. (In Iron age, v. 77, p. 2057.) Abstracts of papers at ninth annual meeting of the society; corrosion of tube steel, corrosion of wire fencing, electrolysis in structural steel, etc.
 Andes, Louis Edgar: Der eisenrost; seine bildung, gefahren and verhutung unter besonderer berucksichtigung der verwendung des eisens als ban- and constructions material. 292 p. Ill. 1898. Treats very fully of rust formation and gives many methods of prevention, chiefly by preservative paints.
 Andrews,



References:  Adie, R.: On the corrosion of metals. 10 p. 1845. (In Minutes of proceedings of the Institution of Civil Engineers, v. 4, p. 323.) Shows that saturated salt solutions are a great protection from corrosion.  Akerman, R.: Ueber das rosten des eisens. 4,200 w. 1882. (In Stahl and eisen, v. 2, p. 417.) Considers theory of rusting, especially of protective metal coatings, and of the influence of manganese in the rusting of steel.  Alford, H. Carroll: Corrosion of iron and its prevention. 2,200 w. 1901. (In Proceedings of the St. Louis Railway Club, v. 5, April 12, p. 9.) Theory of rust formation and preventive measures.  American Society for Testing Materials: 1,800 w. 1906. (In Iron age, v. 77, p. 2057.) Abstracts of papers at ninth annual meeting of the society; corrosion of tube steel, corrosion of wire fencing, electrolysis in structural steel, etc.  Bradford, W. A.: Corrosion vs. so-called corrosion. 2,500 w. 4 ill. 1909. (In Metal Worker, v. 72, October 2, p. 45.) Effect of water and other destructive agents on various kinds of pipe.  Buchanan, J. F.: Corrosion of metals. 2,200 w. 1904. (In Foundry, v. 24, p. 160.) Briefly considers relative corrosion of the more useful metals and alloys.  Calvert, F. Crace.: Experiments on the oxidation of iron. 1,000 w. 1871. (In Chemical news, v. 23, p. 98.) Paper before the Manchester Literary and Philosophical Society  Corrosion and protection of metal surfaces: 9,500 w. 1897. (In Workshop receipts, v. 5, p. 283.) Takes up copper, iron and steel, lead, silver and zinc.  Corrosion of iron: 4,700 w  Corrosion of iron: rusting. 3,500 w. 1907. (In Engineering news, v. 58, p. 328.) See also editorial, p. 339.  The same. (In Iron and coal trades review, v. 75, p. 1566.) Consideration of paper by Cushman, with reference also to Walker 's experiments.  Crowe, Edward.: Corrosion of iron and steel. 2,600 w. Dr. 1909. (In Proceedings of the Cleveland Institution of Engineers, session of 1908-09, p. 148.)  The same, condensed  Curious case of corrosion. 200 w. Ill. 1894. (In Engineering, v. 57, p. 544.) Illustration of an iron bar in which laminations appear; certain layers badly corroded and intermediate ones bright.  Curry, B. E.: Electrolytic corrosion of the bronzes. 6,800 w. Diag. 1906. (In Journal of physical chemistry, v. 10, p. 474.) Determination of effect of corrosion in common salt solutions.  Cushman, Allerton S.: Corrosion of iron. IS p. Dr. 111. 1907. (In Proceedings of the American Society for Testing Materials, v. 7, p. 211.)  Cushman, Allerton S.: Corrosion of iron  Cushman, Allerton S.: Electrolytic theory of the corrosion of iron. 2,200 w. 1907. (In Transactions of the American Electrochemical Society, v. 12, p. 403.) Discussion, 600 w.

You May Also Find These Documents Helpful

  • Powerful Essays

    One hundred millilitres of water was then added into the beaker and mixed using a glass stirring rod to create a copper(II) chloride solution. The solution was observed to be light blue in colour, similar to that of the copper(II) chloride crystals. The iron nail was then placed into beaker, fully submerged in the…

    • 1905 Words
    • 9 Pages
    Powerful Essays
  • Good Essays

    Stainless steel commonly react with certain substance that probably will produce some defect whether inner or outer surface. This material contains small casting defects, mainly shrinkage cavities, due to the manufacturing process. Commonly in industries related to piping system, stainless steel pipelines and cylinder tubes are equipment or object that frequently used in our removable insulation installation. In most industrial nowadays, stainless steel pipes are frequently exposed to high temperatures and conditions, by insulating them is significant to energy savings. Although the reality that stainless steel is less corrosive than normal carbon steels, must remember that stainless steel is corrosion resistant, not corrosion proof.…

    • 417 Words
    • 2 Pages
    Good Essays
  • Good Essays

    * Rust is an oxide of iron that forms when iron structures are exposed to oxygen in the air.…

    • 4052 Words
    • 17 Pages
    Good Essays
  • Good Essays

    Covalent Bonding Lab

    • 560 Words
    • 3 Pages

    Galvanization is named after an Italian scientist named Luigi Galvani. Galvanization is the process by which zinc is coated onto corrosive metals. This process refers to any of the several electrochemical processes. During the process, zinc simply will not adhere to a steel surface that is not cleansed perfect. Galvanization protects from corrosion of various ‘soft metals’ but also adds strength of the original, uncoated…

    • 560 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Milas Shrugged Analysis

    • 992 Words
    • 4 Pages

    “If you consider that for thirteen years this Institute has had a department of metallurgical research, which has cost over twenty million dollars and has produced nothing but a new silver polish and a new anti-corrosive preparation, which, I believe, is not so good as the old ones — you can imagine what the public reaction…

    • 992 Words
    • 4 Pages
    Good Essays
  • Good Essays

    This assignment entailed the task of investigation into the a) Conditions under which corrosion is accelerated, and b) Methods of preventing corrosion. Two experiments were implemented to answer these questions and hence reach a definate conclusion.First off let's look at the background of corrosion and the way in which it occurs.The first hypothesis to answer was, 'What affect does water temperature have on the rate of corrosion of iron in sea water?' The assumed answer was that ' As temperature decreases, the rate of corrosion will decrease.' Secondly, 'Which sacraficial anode would protect and shield the Iron, resulting in a decrease in corrosion levels, within salt water?' The hypothesised answer was that the more active a metal then iron is ,the greater protection it would provide.'…

    • 366 Words
    • 2 Pages
    Good Essays
  • Good Essays

    CHEM 165

    • 567 Words
    • 4 Pages

    When iron comes in contact with water it corrodes and rust is a byproduct. (16 pts.)…

    • 567 Words
    • 4 Pages
    Good Essays
  • Satisfactory Essays

    Attachment of inhibitor molecules to the corroding surface so as to interfere with either the oxidation or reduction reaction; and the formation of a very thin and protective coating on the corroding surface.…

    • 321 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Corrosion is the returning of metals back into their natural constituents when exposed to an atmosphere with which it can react. Both metals and non-metals are able to undergo redox reactions as well as other ceramics and polymers which are known to undergo a similar process which is referred to as degradation. This investigation aims to outline and assess the factors affecting corrosion and explore in depth how redox reactions work. Reduction and oxidization reactions (redox reactions) are responsible for corrosion. Half reaction equations will be playing a major role in this investigation. (Corrosion technology Australia. 2009) Redox reactions are an exchange of electrons between materials. In a redox reaction there is always an anode (electron donor) and a cathode (electron recipient). The exchange of the electrons can be either in a direct process or can be an indirect transfer of electrons along a conductor from the anode to the cathode. Either direct or indirect, the corrosion will always occur at the anode. My experiment is aimed at testing the corrosion of 2 different types of nails in a certain molar solution of salt water in anticipation of determining which of the two would be more suitable for beachside residencies. I hypothesized that the iron nails would almost double in content of rust as the molarity of the solution they’re soaked in increases. The galvanized nails hopefully will end up with limited amounts of rust in all solutions.…

    • 970 Words
    • 4 Pages
    Good Essays
  • Powerful Essays

    The corrosion-retarding effect of the protective layer is produced by the particular distribution and concentration of alloying elements in it. The layer protecting the surface develops and regenerates continuously when subjected to the influence of the weather. In other words, the steel is allowed to rust in order to form the 'protective' coating.…

    • 609 Words
    • 3 Pages
    Powerful Essays
  • Good Essays

    Music Censorship

    • 331 Words
    • 2 Pages

    In this paragraph I will give the history of metal as well as a definition and a modern discription. I will also give the milestones that it has gone through. I will give the history starting point.…

    • 331 Words
    • 2 Pages
    Good Essays
  • Powerful Essays

    Have you ever wondered what drove modern humans to abandon bronze for iron? In this paper I will present the reasons for and the techniques used to develop iron into a useable metal that is far superior to bronze. Topics will include, when iron was first used, the accidental discovery of steel, and why bronze was replaced by iron. First though, let us look at the origins of iron.…

    • 1778 Words
    • 8 Pages
    Powerful Essays
  • Good Essays

    aircraft corrosion

    • 392 Words
    • 2 Pages

    After aircraft metal is manufactured, it is immediately protected with corrosion resistant alloy and coated with various metals, paints, and chemical conversions so that it is protected from the detremental effects of the environment that surrounds it. While in use, additional moisture barriers, such as viscous lubricants and protectants may be added to the surface of the metal to prevent corrosion on aircrafts. However, the job is not finished and it will take inspections and preventative maintenance to keep the aircraft metal from corroding and needing to be replaced. Chipped paint needs to be…

    • 392 Words
    • 2 Pages
    Good Essays
  • Powerful Essays

    DOT Pipeline Corrosion

    • 1600 Words
    • 16 Pages

    ABC Chemical Complex 4 Corrosion Control & Monitoring  Minimum requirements for corrosion control (Continued): – Above Ground External Corrosion Control » Coat with an approved system with resistance to the soil and internal fluid temperature ABC Chemical Complex 5 Corrosion Control & Monitoring  REFERENCES – NACE RP 0169-92 – Surface Preparation: » NACE No. 1, SSPC-SP 5, White Metal Blast Cleaning » NACE No. 2, SSPC-SP 10, Near White Metal Blast » NACE No. 3, SSPC-SP6, Commercial Blast » NACE No. 4, SSPC-SP 7, Brush-Off Blast…

    • 1600 Words
    • 16 Pages
    Powerful Essays
  • Good Essays

    Corrosion Control

    • 4543 Words
    • 19 Pages

    Regardless of the type of corrosion or the metal involved, corrosion treatment requires three basic steps:…

    • 4543 Words
    • 19 Pages
    Good Essays