Preview

Unit 10 Chemistry Lab

Good Essays
Open Document
Open Document
837 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Unit 10 Chemistry Lab
Sample Questions
1. In the chemical formula for ammonia, NH3, what does the subscript 3 represent? (a) the number of ammonia molecules that will bond together (b) the number of nitrogen atoms in each molecule of ammonia (c) the number of nitrogen and hydrogen atoms in each molecule of ammonia (d) The number of hydrogen atoms in each molecule of ammonia 2. The diagram above shows a block from the periodic table. The number six represents the following consumers eats only producers?

(a) atomic mass of the element carbon (b) atomic number of the element carbon (c) number of neutrons in the element carbon (d) number of valence electrons in the element carbon 3. Insulation materials reduce heat loss because they (a) promote convection (b) block out the sun (c) reduce evaporation (c) are poor conductors In the food web shown, which of the 5.

(a) Mouse (b) Owl (c) Fox (d) Hawk Which system shows a transformation from chemical to electrical and light energy? (a) A display of fireworks in the night sky. (b) An avalanche rolls down a steep mountain (c) A car battery causes the headlights to shine (d) A candle burns and lights up the room 6. This experiment was set up to test the

4.

Eduheal Foundation
…show more content…
What are the current benefits of having foods made from genetically modified crops? (b) (a) They improve farm profitability and make some farmers’ jobs easier. (b) They allow farmers to greatly increase the amount of crops produced. (c) They improve convenience for consumers, e.g. by creating foods with longer shelf lives. (d) They improve the nutritional quality of foods. 19. Most foods derived from genetically modified crops contain: (a) The same number of genes as food produced from conventional crops. (b) The same number of genes as foods produced from hybrid crops. (c) One or two additional genes. (d) (d) Hundreds of additional genes. 20. How long does it take to develop a new genetically modified crop? (a) Twenty years (b) Ten years (c) Five years (d) One

You May Also Find These Documents Helpful

  • Good Essays

    Ap Chemistry Lab Report

    • 678 Words
    • 3 Pages

    A 125 mL flask was obtained. The square of aluminum was fashioned over the flask by laying the foil over the mouth and folding the sides down. A pin was then obtained and was used to poke a tiny hole in the center of the aluminum cap.…

    • 678 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Lab for Chemistry 221

    • 612 Words
    • 3 Pages

    Abstract: A 50mL (we used 100mL) volumetric flask was used to determine the amount of sugar in a can of Coke per mL in 5 different solutions. Using the calibration curve we determine the amount of sugar per mL in a can of coke. This experiment concluded that there is 43.83g of sugar in a 12oz can of Coke.…

    • 612 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    Alum Ap Chemistry Lab

    • 480 Words
    • 2 Pages

    6. Set up the Bunsen burner, adjust ring clamp to 1 cm above the burner.…

    • 480 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    1.) 2 KMnO4 + 5 K2C2O4 + 8 H2SO4 = 2 MnSO4 + 10 CO2 + 8 H2O + 6 K2SO4…

    • 315 Words
    • 3 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Year 11 Chemistry Lab

    • 531 Words
    • 3 Pages

    If an air bag has a volume of 36 L and is to be filled with nitrogen gas at a pressure of 1.15 atm at a temperature of 26.0°C, how many grams of NaN3 must be decomposed?…

    • 531 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    Chem Lab

    • 721 Words
    • 3 Pages

    Carbon copies of data tables have been attached to the back of this lap report.…

    • 721 Words
    • 3 Pages
    Good Essays
  • Powerful Essays

    Chem Lab

    • 570 Words
    • 3 Pages

    Purpose: To determine which mole ratio of Zinc and Copper II Sulfate produces the greatest temperature change in degrees celsius.…

    • 570 Words
    • 3 Pages
    Powerful Essays
  • Satisfactory Essays

    Eosc 114 Quizzes

    • 10492 Words
    • 42 Pages

    A. sensible heat B. latent heat C. work D. kinetic energy E. potential energy Score: 1/1 7…

    • 10492 Words
    • 42 Pages
    Satisfactory Essays
  • Good Essays

    Chemistry Lab 4-4

    • 1627 Words
    • 7 Pages

    100 mL of water is already in the calorimeter. Use the density of water at 25°C (0.998 g/mL) to…

    • 1627 Words
    • 7 Pages
    Good Essays
  • Better Essays

    Ap chem lab

    • 909 Words
    • 4 Pages

    Introduction: According to the Bohr atomic model, electrons orbit the nucleus in fixed paths with specific energies. Each path is therefore often referred to as an “energy level”. Electrons possessing the lowest energy are found in the levels closest to the nucleus. Electrons of higher energy are located in progressively more distant energy levels.…

    • 909 Words
    • 4 Pages
    Better Essays
  • Satisfactory Essays

    In the images below, what are the energy transfers that are occuring? Radiation to kinetic and heat. chemical to electrical to light. 11.…

    • 494 Words
    • 3 Pages
    Satisfactory Essays
  • Satisfactory Essays

    chemistry lab

    • 3757 Words
    • 34 Pages

    Regents Chemistry Quarter 1 Midterm Review 1. The percent by mass of oxygen in Na2SO4 (formula mass = 142) is closest to 1) 11% 3) 45% 2) 22% 4) 64% 2. Given the unbalanced equation: __Al(s) + __O2(g) → __Al2O3(s) 3. 4.…

    • 3757 Words
    • 34 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Flinders Island

    • 439 Words
    • 2 Pages

    The table below lists the specific thermal capabilities of a number of materials. This unit is the number of joules of energy that is needed to raise the temperature of 1 kg of this substance by 1° Celsius.…

    • 439 Words
    • 2 Pages
    Satisfactory Essays
  • Powerful Essays

    The purpose of this project is to identify an unknown organic acid (X) by conducting various experiments to determine the acid’s unique properties. By determining selected constant properties of the unknown and then comparing these properties to the constant properties of known substances, it is possible to identify an unknown substance. The properties used to identify the unknown must be intensive, or independent of amount. Both chemical properties and physical properties are intensive properties used in determining the identity of an unknown (Maserton, p. 15).…

    • 1577 Words
    • 7 Pages
    Powerful Essays
  • Good Essays

    Chem Pre-Lab

    • 635 Words
    • 3 Pages

    We know that that the end point of the titration is reached when, after drop after careful drop of NaOH, the solution in the flask retains its pale pink color while swirling for about 30 seconds (as opposed to the pink color simply disappearing as the base mixes into the solution).…

    • 635 Words
    • 3 Pages
    Good Essays