Preview

Wittig Reaction Lab Report

Satisfactory Essays
Open Document
Open Document
149 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Wittig Reaction Lab Report
During this experiment, the reagent phosphonium chloride was reacted with a base to yield a Wittig reagent. The Wittig reagent was reacted with an aldehyde to synthesize an alkene. The Wittig method is an inexpensive reaction that involve transforming a carbonyl to the olefin compound. This reaction is the go-to method for synthesizing alkenes. The carbonyl serve as the electrophile that get attack by a phosphorous Wittig reagent, also known as an Ylide. The reaction progress with the deprotonation of the phosphonium molecule with the reaction base, to yield a carbanion/Ylide. Proceeding the synthesis of the Ylide, the molecule attacks a carbonyl in the same manner of a nucleophile. The attack form a betaine intermediate also known as an alkoxide.

You May Also Find These Documents Helpful

  • Good Essays

    Chem 1212k Lab Report

    • 1333 Words
    • 6 Pages

    Prepare AgNO3 first: Weigh out 1.7-1.8 grams of AgNO3 and dissolve it in 50 mL deionized water. Mix in 10 drops of concentrated HNO3. Crucibles were already at a constant weight. Weighed out.24-.25 gram samples. Added 125-150 mL of deionized water and 10 drops of HNO3. Add 25 mL of AgNO3 solution to each sample. Boil gently. Collect AgX in gooch crucible. Used suction flask to dry then they were cooled and weighed.…

    • 1333 Words
    • 6 Pages
    Good Essays
  • Satisfactory Essays

    Adjust cell suspension volume with media so that between 15 to 100 L of cells are used for each well/dish. This small plating volume ensures that there is even cell distribution and that growth factors, drugs, or substrates in the medium are not diluted.…

    • 237 Words
    • 1 Page
    Satisfactory Essays
  • Satisfactory Essays

    Chem 1211K Lab Report

    • 1855 Words
    • 18 Pages

    The identification of the melting point of the organic acid was done to find another characteristic of the acid and to test the purity of the recrystallized pure acid. A 2-4 mm layer of unknown sample was placed into a capillary tube sealed on one end. Then the capillary tube was inserted into the side a Bibby Sterlin device. The plateau was set to 200°C on the melting point apparatus. Once the plateau temperature was reached, the sample was watched carefully. When the sample first began to melt and when it was fully melted was recorded. These numbers were the range of the melting point. A slow melting point of the unknown organic acid and a standard sample was completed next. A new plateau was set about 10°C lower than the observed melting point of the unknown sample. This time once the plateau was reached, the heating was no more than 1°C per minute. This gave a much more accurate read of both melting points. If the standard did not melt in the range listed on the label of the bottle, that meant the machine was not working properly. The standard sample and the unknown organic acid melted in their appropriate ranges.…

    • 1855 Words
    • 18 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Nt1310 Unit 2 Lab Report

    • 822 Words
    • 4 Pages

    How is the resulting volume different from the one you created in Exercise 2.1? Explain why.…

    • 822 Words
    • 4 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Chem Lab report

    • 452 Words
    • 2 Pages

    9) Put 4mL of stock solution and 1mL of water in a test tube to make the second solution.…

    • 452 Words
    • 2 Pages
    Satisfactory Essays
  • Better Essays

    chem lab report

    • 1425 Words
    • 7 Pages

    2. To determine the densities of water, an unknown liquid, a rubber stopper, and an unknown rectangular solid.…

    • 1425 Words
    • 7 Pages
    Better Essays
  • Powerful Essays

    Using SN1 reaction mechanism with hydrochloric acid, t-Pentyl alcohol was converted to t-Pentyl chloride in an acid catalyzed reaction. The reaction took place in a separatory funnel designed to separate immiscible liquids. The crude product was extracted by transferring a solute from one solvent to another. The process of washing the solutions by phase transfer was used in order to remove impurities from the main solvent layer. Finally, the crude product was dried with anhydrous Calcium chloride and purified once more by simple distillation technique.…

    • 1041 Words
    • 5 Pages
    Powerful Essays
  • Good Essays

    Nt1310 Unit 9 Lab Report

    • 2198 Words
    • 9 Pages

    Suppose that a lone asteroid happens to be passing Jupiter on a unbound orbit ( well above Jupiter's atmosphere and far from all of Jupiter moons.) Which of the following statements would be true?…

    • 2198 Words
    • 9 Pages
    Good Essays
  • Satisfactory Essays

    NETW410 Week 2 Lab Report

    • 349 Words
    • 3 Pages

    The technical goals are to build a new IT section onto the admin building to make sure all the servers are centralized. Connect all buildings to the new IT section. Make sure to provide wireless access for all the students in classrooms. Provide high speed wired internet to all faculty offices. Make sure there is a centralized back up of all data. Replace the old phone system with VIOP.…

    • 349 Words
    • 3 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Keq Reaction Lab Report

    • 181 Words
    • 1 Page

    The Keq, ratio of the concentrations of product to reactant, reveals the amount of product formed depending on the number of reactant accessible. The first reaction A+B↔C+D(Keq= 3.9X10-12) favored reactant because Keq is less than 1, meaning more reactants than product is present. Thus, the reaction displays reactant(blue).This is an extreme case where the reaction does not proceed forward readily. For second reaction I+J↔K+L(Keq=8.7x10-1), reactant(blue) is favored, but shows adequate amount of product(yellow) because its Keq is closer to 1. In S+T↔U+V(Keq=5.2x1018), another extreme case, Keq is greater than 1, so less reactant is present. Consequently, the reaction is mostly complete, favoring product(yellow) side. If a reaction either reach…

    • 181 Words
    • 1 Page
    Satisfactory Essays
  • Satisfactory Essays

    Lab work—If either party has had previous sexual relationships, each should be tested for HIV and other sexually transmitted diseases. Undiagnosed sexually transmitted diseases can lead to infertility in both men and women. Testing for hepatitis is also advisable.…

    • 81 Words
    • 1 Page
    Satisfactory Essays
  • Satisfactory Essays

    LAB 3 Report

    • 737 Words
    • 5 Pages

    A. Create a solubility curve for NH4Cl by plotting g NH4Cl/100 mL H20 on the y-axis, and crystallization temperature on the x-axis. Make sure to label each axis. On the same graph as the solubility curve for NH4Cl, add the solubility curve for NaCl using the data provided in Data Table 3.…

    • 737 Words
    • 5 Pages
    Satisfactory Essays
  • Powerful Essays

    Chem Lab Report

    • 1164 Words
    • 5 Pages

    .2400 grams of the unknown compound. This is done in duplicate and purple-tinted precipitates are placed in Gooch crucibles. The precipitates are suction dried using ethyl alcohol then acetone to…

    • 1164 Words
    • 5 Pages
    Powerful Essays
  • Better Essays

    Sci/207 Week 3 Lab Report

    • 891 Words
    • 4 Pages

    Hypothesis: If certain species are missing from the ecosystem except humans (blue), then all other species will feel the effects.…

    • 891 Words
    • 4 Pages
    Better Essays
  • Powerful Essays

    The purpose of this experiment was to perform a wittig reaction, the horner-emmons wittig specifically, reacting an aldehyde with an ylide to make an alkene. This particular variation of the wittig reaction has several advantages: It gives only the trans product; it uses a much milder base that is easier to handle; and it gives a water soluble byproduct which is easy to separate from the product. The reason that these advantages occur is a change in the structure of the ylide. Instead of a tripheylphosphine ylide, we use a diethylphosphonate ylide. The protons are much more acidic and its byproduct is negatively charged.…

    • 980 Words
    • 4 Pages
    Powerful Essays