Preview

Investigating How the Relative Molecular Mass Changes in Heat Combustion of an Alcohol: Essay Example

Powerful Essays
Open Document
Open Document
3233 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Investigating How the Relative Molecular Mass Changes in Heat Combustion of an Alcohol: Essay Example
Investigating How the Relative Molecular Mass Changes in Heat Combustion of an Alcohol

Planning

Introduction
============

As alcohol burns in air it gives out energy as heat and light. I am going to investigate how the energy output of an alcohol in combustion changes, with increased relative molecular mass, or RMM. RMM is the sum of the atomic masses of every atom in the molecule. Using the alcohols: Methanol, Ethanol, Propan-1-ol, Butan-1-ol and Pentan-1-ol,
I will plan, and complete an experiment that tests the prediction below. ======================================================================

Prediction And Theory
=====================

In the combustion of alcohols in air, the alcohol reacts with oxygen molecules, to create carbon dioxide and water. Many bonds are broken in the process using up energy. At the same time, the atoms reforming into the new molecules of carbon dioxide and water give out energy. In the combustion of alcohols, the energy created, when forming bonds will always be more that what is lost, when breaking bonds, this gives us excess energy. This energy is given out primarily as heat, but also as light and sound. As energy is given out it is called an exothermic reaction. If the opposite were true, it would be an endothermic reaction. It is never possible to calculate exact energy change by experimentation due to inaccuracies and energy waste, so we use bond energy calculations give the exact theoretical energy change.

Bond energy calculations show that the higher the RMM the more energy will be produced for the same weight of fuel (RMM is the sum of the atomic masses of every atom in the molecule). This is because as the
RMM increases there are more atoms and therefore, more bonds to be broken and then made. As, when burning alcohols, this process gives out energy, the more bonds go through this process, ie as the RMM increases the more energy should be

You May Also Find These Documents Helpful

  • Good Essays

    9. What is the nominal air to fuel ratio (by weight) supplied to an engine?…

    • 3538 Words
    • 16 Pages
    Good Essays
  • Good Essays

    Observations: The hottest temperature reached was Zinc at 34.8°C & Copper was the heaviest metal…

    • 749 Words
    • 3 Pages
    Good Essays
  • Good Essays

    In order to compare the two reactors used in our experiment, a simplified global kinetic model was used to describe the DRM reaction behavior in different plasma reactor. This model was already used by authors in the field of pollutant removal by using a plasma reactor [15, 21–23]. It is generally accepted that free radical processes are the main mechanisms in non-equilibrium plasma reaction [21, 24-25].…

    • 675 Words
    • 3 Pages
    Good Essays
  • Good Essays

    From the results recorded it was identified that activity A and C had exothermic reactions, whilst activity B had an endothermic reaction. Each of the activities had initially begun with 23.4/8/9oC, however, within one minute of adding the 2nd reactants, the results began showing, as seen from the graph. Activity A and C had risen in temperature, with A gaining 4oC and in total of 2 minutes having the temperature of 27.9oC along with C increasing by 2.2oC and within 2 minutes of the experiment having the temperature of 26oC. Activity B however was the anomaly in the test, as the temperature went lower, by 1.9oC as within 2 minutes, the Ammonium Chloride and water had the temperature of 21oC. Furthermore the line graph shows Activity A and C rising to its highest peak, although it eventually reduces. Activity A for example, was rising until it reached 27.9oC and it continuously decreased, until the 10 minute mark had reached having the final temperature similar to the initial temperature. A similar thing occurred to Activity C however, as its highest peak was 26oC (2 minutes in the test), and the final temperature having a 0.1oC difference from the initial temperature.…

    • 500 Words
    • 2 Pages
    Good Essays
  • Powerful Essays

    Relate results to the law of conservation of mass and the law of multiple proportions.…

    • 971 Words
    • 4 Pages
    Powerful Essays
  • Good Essays

    Note: calculation method is not different in examples 1 - 3, just the unit of measure (mg, units, mEq, etc.). BE SURE AVAILABLE AND HAVE ARE THE SAME UNIT OF MEASURE.…

    • 609 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Chem notes

    • 503 Words
    • 3 Pages

    When a 15.1 g sample of ethanol is burned, how much energy is released as heat?…

    • 503 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    The accepted molar enthalpy of neutralization of sodium hydroxide is - 57 kJ/mol. Calculate the % difference of the value you obtained from your experiment with this accepted value.…

    • 700 Words
    • 6 Pages
    Satisfactory Essays
  • Good Essays

    The purpose of the lab was to determine the molecular mass of Butane, and this was done by using the ideal gas law (PV=nRT). The materials used were: match, funnel, bucket, cylinder, thermometer, lighter, scale, and a wooden flynt. These materials are used to help collect and test the Butane gas. Butane gas was used because it is ideal at standard temperature and pressure.…

    • 418 Words
    • 2 Pages
    Good Essays
  • Powerful Essays

    Being a Soldier in the Army comes will obstacles and challenges at every turn. These complications can be self-imposed, environment, work, or the mission itself. Booker T. Washington once said, “Success is to be measured not so much by the position that one has reached in life as by the obstacles which he has overcome.” You can be the highest ranking in the room, but if you cannot lead or come up with the solutions you might as well excuse yourself. The military decision-making process (MDMP) is a single, established, and proven analytical process. (FM 101-5) Once a mission has been created and issued, the MDMP is in effect and does not stop. After the mission has been accomplished, the mission is reviewed for improvements and sustains.…

    • 1663 Words
    • 7 Pages
    Powerful Essays
  • Good Essays

    • Same fuel load / same cargo / further range -OR• Same fuel load / more cargo / same range -OR• Less fuel load / same cargo / same range…

    • 814 Words
    • 7 Pages
    Good Essays
  • Good Essays

    Examples of LPP

    • 709 Words
    • 4 Pages

    The manager of an oil refinery must decide on the optimal mix of two possible blending processes of which the inputs and outputs per production run are as follows:…

    • 709 Words
    • 4 Pages
    Good Essays
  • Satisfactory Essays

    Adiabatic

    • 471 Words
    • 2 Pages

    m = 4,59•10-3 kg; V = 1,14•10-3 m3; PL = 99,56•103 kg/ms2; r= 5,95•10-3 m…

    • 471 Words
    • 2 Pages
    Satisfactory Essays
  • Powerful Essays

    Example Technical Writing

    • 1359 Words
    • 6 Pages

    Data have been reported from nonflow reactors, flow reactors, diffusion flames, and laminar premixed flames experiments by several researchers [2-5]. Detailed chemical kinetics models to describe the gas-phase oxidation of ethanol in air are available in literature [6]. Apart from that a global single step mechanism for ethanol oxidation is also available [7]. Experimental studies have been reported on extinction and autoignition of methanol and ethanol flames in laminar, non uniform flows for both non premixed and premixed flames in counter-flow configuration by Seiser et al. [8].…

    • 1359 Words
    • 6 Pages
    Powerful Essays
  • Satisfactory Essays

    Operations Research

    • 1892 Words
    • 8 Pages

    all the amounts produced are consumed in the market. Formulate the problem as LPP in…

    • 1892 Words
    • 8 Pages
    Satisfactory Essays