Activity 33 PS-2826 Latent Heat of Fusion Thermodynamics: phase change‚ latent heat of fusion‚ melting Qty 1 1 1 1 1L 0.5 L 1 Equipment and Materials PASPORT Xplorer GLX Fast-Response Temperature Probe (included with GLX) Basic Calorimetry Set (1 calorimeter cup) Balance Water‚ about 15 degrees warmer than room temperature Ice‚ crushed Towel Part Number PS-2002 PS-2135 TD-8557 SE-8723 Purpose The purpose of this activity is to determine the amount of thermal energy needed to change a specific
Premium Energy Thermodynamics Heat
Department of Chemistry Extraction and Sublimation Experiment #4 10/02/13 Introduction Caffeine is a stimulant found in tea‚ coffee‚ cocoa‚ OTC medication‚ and cola drinks.It stimulates the brain and the central nervous system‚ so that a person feels less tired and more alert. The purpose of this lab is to determine the amount of caffeine in tea. The major component of tea is cellulose which is a polymer of glucose. Materials Lab coat Goggles Graduated cylinder 1 tea
Premium Chemistry Caffeine Tea
In the lab testing the heat of a reaction to understand changes in enthalpy in an exothermic reaction‚ the group hypothesized that if the amount of reactant is changed then the amount of heat produced (exothermic) will increase. This hypothesis was supported through the data as each of the six trials produced heat and the larger the piece of magnesium the larger the change in heat was. In the first trial the group had .085 grams of Mg and after being placed in 3 ml of 21.8℃ HCl the temperature of
Premium Thermodynamics Chemical reaction Energy
Analysis of a Chemical Reaction Purpose: To observe a chemical reaction and to use qualitative and quantitative evidence to identify this reaction from among four possibilities. Hypothesis: I think the result is going to produce water. I think this is going to happen because there is hydrogen and oxygen inNaHCO3. Materials: -Test tube clamp - 150 mm test tubes (2) - burner - retort stand - clay triangle - iron ring - crucible Procedure: Part A: 1. Add 0.5 g of NaHCO3
Premium Chemistry Chemical reaction Chlorine
Honors Chemistry Period 2 September 22‚ 2013 PRE-LAB Title: Density of Metals – Shot Lab Purpose: The purpose of this lab is to find out the density of different metals using their mass and volume. If the volume and mass for the metals Nickel and Copper are found‚ then we can figure out the density. Materials: Metal shot Plastic rinse bin Electric Balances Calculator Graduated Cylinders Water Wire Gauze Weigh Boats Pre-lab Questions: 1) The volume of the water is 43.0 mL
Premium Metal Volume Copper
College Department of Chemistry Chem 180 Lab 5: Ionic Reactions Submitted by Abstract: The purpose of this experiment is to work with aqueous solutions of ionic substances. Aqueous solutions are those solutions in which water is the solvent. When ionic substances are dissolved in water‚ the ions separate and become surrounded by water molecules. The focus of this experiment is on precipitates. The goal of this experiment is to study the nature of ionic reactions‚ write balanced equations
Premium Solubility
Abstract: Theoretically‚ this experiment is used to address the Newton’s Second Law of Motion which is the net force is product of the mass and the acceleration of the object. However‚ the performance’s result would be measured acceleration instead the net force. During this experiment‚ the objects are two weight hangers with a same origin mass which is 5g and later have total mass is around 2000g. The experiment is performed by transferring mass from one to another hanger and calculates the
Free Newton's laws of motion Force Mass
Erin Bolton Chemistry Lab Report April 29‚ 2015 Lab: Reaction Rates Introduction: In this experiment we studied the reaction of potassium persulfate‚ K2S2O8‚ with potassium iodide‚ KI. All chemical reactions have an energy barrier to overcome before the reaction will proceed. We will record data based on the concentration‚ temperature and catalyst for each experiment. Once this has been completed it will be graphed. Procedure: Due to the chemicals being used having hazard gloves are used
Premium Chemistry Chemical reaction
Classifying Chemical Reactions Purpose: The purpose of this experiment is to observe a variety of chemical reactions and to identify patterns in the conversion of reactants into products. Apparatus: • Bunsen or lab burner -Test tube clamp • Butane safety lighter - Test tube rack • Evaporating dish - Wash bottle • Forceps or crucible tongs - Wood Splints • Heat resistant pad • Litmus paper • Pipets • Spatula • Test tubes Materials: Ammonium carbonate‚
Premium Chemical reaction Sodium hydroxide Chlorine
This experiment was performed to demonstrate a cycle of chemical reactions involving copper. This lab will start with copper as a reactant in the first reaction through a series of five chemical forms of aqueous phase reactions and ending to calculate the percentage of recovered solid copper as a product in the last reaction of the experiment. The experiment resulted in a percent recovery from the cycle of copper reactions of an increase to 139%. . Introduction: The purpose of this experiment is
Premium Chemical reaction Chemistry Hydrogen