Acid-Base Titrations February 21‚ 2013 Abstract: With the given volume measurement of KHP and NaOH‚ the students experimented to calculate the mass of unknown acid and its equivalence point using a method called titration and titration curve. The known volume of an acid solution would be titrated by slowly adding drops of solution into NaOH‚ and the volume of base needed to react with the acid is measured throughout. By using those data‚ the students are able to find what they
Free PH Sodium hydroxide Titration
Standardization of hydrochloric acid by sodium carbonate Concentrated hydrochloric acid is roughly 11 M. Pour out into a measuring cylinder about 2 cm3 of concentrated hydrochloric acid. Transfer it to a 250 cm3 flask and make up to the mark with water. Shake well. Put some pure sodium hydrogen carbonate or anhydrous sodium carbonate into an evaporating dish and heat gently over a low flame for about fifteen minutes‚ stirring continuously. Take care not to heat the mass too strongly or fusion
Premium Sodium carbonate Carbon dioxide Sodium bicarbonate
Determination of Ka for a Weak Acid Introduction In the experiment preformed the objective is to titrate a weak acid with a strong base. In a titration of a weak acid with a strong base the titrant is the strong base and the analyte is a weak acid. The reaction that will occur is the direct transfer of protons from the weak acid to the hydroxide ion. The data gathered will be represented on the titration curve‚ a graph of the volume of titrant being the strong base plotted against the pH .The
Premium Acid Base Acid dissociation constant
ACID BASE TITRATION OBJECTIVES 1. To demonstrate the basic laboratory technique of titration 2. To learn to calculate molarity based on titrations INTRODUCTION Molarity (M) or molar concentration is a common unit for expressing the concentration of solutions. It is defined as the number of moles of solute per liter of solution (or millimoles of solute per milliliter of solution). The concentration of a basic solution can be determined by titrating it with a volume of a standard acid solution (of
Premium Chemistry Sodium hydroxide Base
Block February 13‚ 2015 Titration Lab Title Abstract During this experiment the change in pH of Citric acids is measured from start to equilibrium in mL. This experiment was tested by titration it had two separate trials. Through observations it was shown that the more concentrated acids needed more drops of NaOH to reach its equilibrium then the less concentrated acids. Introduction Sodium Hydroxide (NaOH) is a strong base and when it is titrated with a strong acid the equivalence point will
Premium Base Sodium hydroxide Acid
Volumetric Analysis The Titration of Acids and Bases Purpose This experiment will allow you to gain practical experience in the preparing standard solutions‚ using a pipette and a buret‚ and performing standard titrations. You will use this experience to experimentally determine the concentration of acetic acid in an unknown solution. There are three parts to this experiment‚ they are 1. Preparation a standard solution of oxalic acid (~0.07 M) 2. Preparation a sodium hydroxide solution
Premium Titration Sodium hydroxide
malia Taylor Date: 26.02.2013 Title: titration method AIM 1. To titrate sodium hydroxide with hydrochloric acid Apparatus: * Burette (50cm3) * Pipette (10cm3) * Three (3) Conical Flasks (250cm3) * Two (2) Beakers (250cm3) * Funnel * Wash Bottle * Retort Stand * Boss and Clamp * Pipette filler Material: * 0.08 mol dm-3 hydrochloric acid * 0.1 mol dm-3 sodium hydroxide * Phenolphthalein indicator Method:
Premium Titration Sodium hydroxide
away from flames as it is flammable. Handle acids and bases carefully as they are corrosive. Rinse skin with lots of cool water if splashed with chemical and report any spills to the teacher immediately. Source: Nelson Chemistry 11 (2010) ACID BASE TITRATION Purpose: To determine the concentration of solution of sodium hydroxide by acid-base titration and analyse the shape of a titration curve. . Pre-Lab: / 11 I /8 K/U / 5 C
Premium Sodium hydroxide PH
Title: ACID BASE TITRATION. Objectives: 1. To determine the concentration of acid using titration. 2. Skills of titration techniques. Apparatus: 1. 250 volumetric flask 2. 10mL measuring cylinder 3. 25mL pipette 4. 50mL burette 5. 250mL beaker 6. 150mL conical flask 7. Retord stand 8. White tile 9. Stopwatch 10. Pipette bulb Chemicals: 1. HCl solution 2. 0.1M NaOH solution 3. H2SO4 solution 4. Distilled water 5. phenolphthalein
Premium PH indicator Titration PH
Chemistry: Acid-Base Titration Purpose: The objective of this experiment were: a) to review the concept of simple acid-base reactions; b) to review the stoichiometric calculations involved in chemical reactions; c) to review the basic lab procedure of a titration and introduce the student to the concept of a primary standard and the process of standardization; d) to review the calculations involving chemical solutions; e) to help the student improve his/her lab technique. Theory: Titration was used
Premium