Solute Concentration of Potatoes Lab #1 Purpose: To find the molarity/concentration of potato cytoplasm. Materials: As on page 1 in the lab handout. Procedure: As on page 1 in the lab handout. Data and Observations: Test Tube # | Concentration of sucrose solution (mol/L) | Initial Mass (g) | Final Mass | Percentage change in mass | 1 | 1.0 mol/L | 3.00g | 2.25g | -25.0% | 2 | 0.9 mol/L | 2.70g | 2.07g | -23.3% | 3 | 0.8 mol/L | 2.92g | 2.25g | -22.9% | 4 | 0.7 mol/L | 2.60g
Premium Concentration Osmosis Chemistry
Acid Base Titration Purpose: The purpose is to calculate the molarity of a NaOH solution by titrating the base with 5mL of standard HCl solution in each trial. By adding the base with unknown molarity to the acid with 0.10M the molarity of NaOH can be calculated. The base‚ NaOH‚ helps bring the pH of the acid‚ HCl‚ closer to seven‚ which neutralizes it. When using the buret the amount of NaOH used is able to be determined. Then by writing a balanced chemical equation and using the titration
Premium Titration Sodium hydroxide Acid
Bubble Inside a Bubble Materials • • • • • • • • Granulated sugar (we had our best results using Imperial Sugar and Dixie Crystals) Dish soap Water Tablespoon Scissors Pipette Cup Adult supervision Bubbles form because of a combination of water’s hydrogen bonds and the oily film you can see shimmer in the light. The oily film you see is actually two separate layers of soap attached to‚ and surrounding‚ hydrogen-bonded water. Solar Oven S’mores Materials • Pizza box • Two clear sheet protectors
Premium Oxygen Thermodynamics Water
:___________ Chemistry Laboratory 101__ Date Submitted[1] :___________ Members[2]: Instructor’s Initials[3] :___________ 1. _____________________ 2. _____________________ 3. _____________________ 4. _____________________ Laboratory Report Sheet The Bunsen Burner Activity 1 Objectives:4 1. ________________________________________________________ 2. ________________________________________________________ 3. ________________________________________________________
Premium Laboratory equipment Question Knowledge
Abstract This lab’s purpose was to test the patterns of percolation in various places. This lab tested how soil would absorb water based on different places. Distance from a group of trees‚ distance from a swamp‚ and different types of soil were tested. From the results collected‚ you can not prove‚ but you can infer that the ability to absorb increases as you go farther away from a swamp‚ and a group of trees. The ability to absorb also increases based on how much silt is in soil. Introduction
Premium Soil Surface runoff Digestion
Introduction: Experiments 1 and 2 main aims are as follows: • To able to use the Beer-Lambert law to explain the relationship linking concentration and absorbance of the coloured solutions methyl orange and bromophenol blue. • To be able to rightly operate a spectrophotometer to assess the absorbance at various wavelengths • To be able to identify the main component parts of a spectrophotometer • To be able to draw a ‘Standard Curve’ from the data collected
Premium Stanford prison experiment Experiment Spectroscopy
CHM151LL Laboratory Report Form Fall 2011 Title: Project 5: SPECTROPHOTOMETRIC ANALYSIS OF A PENNY Date Run: 04/03/2012 Date Submitted: 04/15/2012 Grade: _____________________ Objectives: The purpose of this experiment is to use spectrophotometry to determine the percentage of copper in a copper-clad penny‚ and to determine the thickness of copper layer on the copper-clad penny. Introduction: In the spectrophotometric analysis of a penny lab‚ we will be conducting three
Premium Chemistry Chemical reaction Experiment
Tori Suchy Physical Science Honors 1st block October 4‚ 2012 Balloon Powered Car Problem: In order to create a race car that can travel a minimum of eight meters powered by a nine inch balloon. We need incorporate Newton ’s Law of Motion including speed‚ velocity‚ and acceleration. Hypothesis: If a car were to be made out of homemade materials‚ then it would be possible for it to travel 8 meters powered by a nine inch balloon. Independent Variable: building the car from homemade materials
Free Newton's laws of motion Force Classical mechanics
FOOD NUTRITION BASICS LABORATORY REPORT LAB 3 PROTEINS DUE DATE Next FNB Practical NAME (CAPITALS) ______________________________GROUP LETTER___________ This work is the product of my own efforts and has not been copied from any other sources except where full acknowledgement has been given. Signed________________________________________ Student No._____________ Introduction The principle involved in this experiment is denaturation. It involves loss of ordered structure and can be caused by changes
Premium Protein Egg white Milk
Hess’s Law and the Molar Enthalpy of Combustion for Magnesium Purpose: The purpose of the lab ultimately is to find the molar enthalpy of magnesium. This is done by finding the enthalpy changes of reactions (2) and (3). The enthalpy changes of reactions (2) and (3) along with the enthalpy change given for reaction (4) can be used to arrive at a value of the molar enthalpy of combustion of magnesium by using Hess’s Law. Hypothesis: By using Hess’s law to calculate the molar enthalpy of combustion
Premium Chemistry Chemical reaction Magnesium