Approximately 40 mL of the ionized water was added to the 100 mL beaker‚ then in a 10-mL graduated cylinder‚ 5-mL of HCl was measured then added to the 100-mL beaker of water. The 100 mL beaker was then placed on the assembled ring stand. Approximately 40 mL of the 0.1M NaOH was added to the 250 mL beaker. The 40-mL of NaOH was then added to the buret which was then attached to the ring stand. The LabQuest and the Vernier pH sensor was then hooked up and turned on to measure and graph the pH of the
Premium
With my test result‚ it clearly shows that the concentration of sulfuric acid is 0.05 mol/dm3 using the concentration equation‚ c= n/v. 25 cm3 of the volume with sodium hydroxide is equal to 0.025 dm3 by dividing a thousand with cm 3 and multiply it with 0.1 mol/ dm3 which is the concentration of sodium hydroxide. With the ratio between sulfuric acid and sodium hydroxide is 1 to 2 so‚ 0.0025 should be divided by 2 and 0.00125 moles of sulfuric acid is come out. Finally‚ using c = m/v‚ 0.00125 mole/0
Premium Chemistry Sulfur Chlorine
One of the wonders of this planet is water. Water makes up 65% of humans‚ and 70% of the Earth. It is also common knowledge that humans cannot survive three days without it. Water is essential. If almost three-fourths of Earth is made up of water‚ why are there still so many people in the world suffering from a lack of it? Although not all water can be used for drinking purposes‚ in many places‚ water that is drinkable- is polluted or deluded by many agricultural and industrial motives and damage
Premium Water Water resources Human
In the first week of the experiment‚ the goal was to find the moles of NaOH‚ as well as a 0.1 molarity‚ while in the second week to goal was to determine the percent KPH in the sample. The first week titrations were successful and had very similar amounts of pink‚ which shows the precision of the results. The best trials were in the sample trial and the second and third trials. The average molarity calculated for the first week was 0.1017 M. This very close to the 0.1 M that was supposed to be made
Premium Chemistry Concentration Experiment
Contents lists available at SciVerse ScienceDirect Journal of Magnetism and Magnetic Materials journal homepage: www.elsevier.com/locate/jmmm Investigation of magnetocaloric effect in La0.45Pr0.25Ca0.3MnO3 by magnetic‚ differential scanning calorimetry and thermal analysis M. Aparnadevi‚ S.K. Barik‚ R. Mahendiran n Department of Physics‚ 2 Science Drive 3‚ National University of Singapore‚ Lower Kent Ridge Road‚ Singapore-117 452‚ Singapore a r t i c l e i n f o abstract Article history:
Premium Magnetism Magnetic field Thermodynamics
NATIONAL UNIVERSITY OF RWANDA FACULTY OF APPLIED SCIENCES DEPARTMENT OF COMPUTER SCIENCE BACC IV ACADEMIC YEAR: 2012-2013 CHAPTER 1. TOPIC: DESIGN AND IMPLEMENTATION OF AN ONLINE COMPUTER LABS MONITORING SYSTEM CASE STUDY: NATIONAL UNIVERSITY OF RWANDA ICT CENTER/Helpdesk Unit
Premium Laboratory Software engineering Computer
the energy difference as heat and/or work (potential energy)‚ and this is called an exothermic reaction. An example process would be: Making ice cubes Burning sugar An example equation would be: 2H2 (g) + O2 (g) → 2H2O (g) Methods: Refer to lab manual. Data:Ice Calorimeter Data Before reaction During reaction After reaction Time (s) Pipet (mL) 360 0.681 390 0.602 420 0.528 450 0.465 480 0.413 510 0.368 540 0.325 570 0.293 600 0.258 630 0
Premium Enthalpy Energy Thermodynamics
CALORIMETRY INTRODUCTION Calorimetry is used to determine the heat released or absorbed in a chemical reaction (1).Trustees of darmouth college states that (1) is used to determine the heat released or absorbed in a chemical reaction. To determine the heat released or absorbed in a chemical reaction an instrument called calorimeter is used. A calorimeter is an instrument used for measuring the heat of a reaction during a well defined process (2). Brucat states that (2) a calorimeter is an instrument
Premium Thermodynamics Sodium Chemical reaction
Ice Calorimeter Determination with Mg June 18th 2013 Abstract: This experiment determines the amount of energy needed to melt ice. A spontaneous increase in enthalpy produce by combining 0.2036g Mg and 5.00mL H₂SO₄‚ ice was melted and readings were taken by using an ice calorimeter. Readings were taken before during and after the reaction were completed. The data taken shows a value of -405 KJ/mol while the theoretical value was -483.7 KJ/mol. Calculating the experimental
Premium Trigraph Enthalpy Calorimetry
Experiment: Calorimetry Laboratory Experiment – Heat of Solution Aim: The aim was to use calorimetric measurements to calculate the molar heat of solution of NaOH and NH4NO3. Method: 1. 50g of water was poured into a clean polystyrene calorimeter (Styrofoam cup) and the initial temperature was measured. 2. A teaspoon of 2g of the selected salt was measured and added into the water. 3. The solution was stirred and the final temperature was measured when the solution stabilised and the results
Premium Thermodynamics Measurement Chemistry