In the first week of the experiment‚ the goal was to find the moles of NaOH‚ as well as a 0.1 molarity‚ while in the second week to goal was to determine the percent KPH in the sample. The first week titrations were successful and had very similar amounts of pink‚ which shows the precision of the results. The best trials were in the sample trial and the second and third trials. The average molarity calculated for the first week was 0.1017 M. This very close to the 0.1 M that was supposed to be made
Premium Chemistry Concentration Experiment
The experiment was done twice in trial 1 and 2. First‚ in the first trial‚ the crucible with lid was measured on a balance and the mass of them was recorded in grams which is m of clean crucible = 22.89g . This was followed by weighing the crucible with 0.3 g of Magnesium on a balance. The total mass of mg with the crucible was recorded which was m total mass mg + Crucible = 23.19g. Then the magnesium was heated using a Bunsen burner‚ and we put the crucible with Mg on a clay triangle using tongs
Premium Magnesium Oxide Magnesium oxide
CALORIMETRY INTRODUCTION Calorimetry is used to determine the heat released or absorbed in a chemical reaction (1).Trustees of darmouth college states that (1) is used to determine the heat released or absorbed in a chemical reaction. To determine the heat released or absorbed in a chemical reaction an instrument called calorimeter is used. A calorimeter is an instrument used for measuring the heat of a reaction during a well defined process (2). Brucat states that (2) a calorimeter is an instrument
Premium Thermodynamics Sodium Chemical reaction
Experiment: Calorimetry Laboratory Experiment – Heat of Solution Aim: The aim was to use calorimetric measurements to calculate the molar heat of solution of NaOH and NH4NO3. Method: 1. 50g of water was poured into a clean polystyrene calorimeter (Styrofoam cup) and the initial temperature was measured. 2. A teaspoon of 2g of the selected salt was measured and added into the water. 3. The solution was stirred and the final temperature was measured when the solution stabilised and the results
Premium Thermodynamics Measurement Chemistry
CALORIMETRY Abstract: During the experiment‚ the group were able to perform the following objectives; to compute the heat capacity of a Styrofoam-cup calorimeter‚ and also to compute the heat of neutralization of 1.0 M hydrochloric acid and 1.0 M sodium hydroxide‚ the heat of dilution of concentrated sulfuric acid‚ and the heat of solution of solid ammonium chloride The sixth experiment was named "Calorimetry" wherein it is the measurement of how much heat is gained or released by a system
Premium Energy Enthalpy Hydrochloric acid
Chem 17 ▪ General Chemistry Laboratory II Experiment 1 Calorimetry INTRODUCTION Chemical reactions are usually accompanied by the evolution (exothermic reaction) or absorption (endothermic reaction) of heat energy. When measured at constant pressure‚ the heat evolved (qp < 0) or absorbed (qp > 0) is equal to the enthalpy change‚ symbolized by ΔH. ΔH is positive for an endothermic process and negative for an exothermic one. If H f is the enthalpy of the final state and Hi of the initial state
Premium Chemical reaction Thermodynamics Enthalpy
Experiment 1: Calorimetry INTRODUCTION In the calibration of the calorimeter‚ the net ionic equation used is H+(aq) + OH-(aq) H2O(l). The reaction released heat and is said to be exothermic. HCl is the limiting reactant of the reaction and o.oo5 moles of it was used. The heat generated by the reaction is 55.8 kJ. The sign of T of the reaction used for calibration is opposite to that of H. In the determination of heats of reaction‚ the reaction of 15 mL 1 M CuSO4 + 0.05 g Zn produced a
Premium Enthalpy Chemical reaction Thermodynamics
Aim: The aim of this experiment is to convert copper metal through a series of intermediate copper compounds back into copper metal. By weighing the copper at the beginning and at the end of the experiment the percentage yield can be determined. Method: The experiment was carried out as outlined in the practical manual. Results: Table: showing masses: Mass copper wire 0.2510 Mass crucible 28.9257 Mass watch glass 19.6213 Mass watch glass + copper 19.7890 Mass copper
Premium Chemistry Copper Chemical reaction
In the data table above‚ the mass of penny‚ copper‚ and zinc was needed in order to determine the percent composition of copper and zinc. The mass of penny was taken on the scale in the beginning of the procedure before anything was done to the penny‚ and it was 2.51 grams. After the reaction with the hydrochloric acid and drying the copper‚ the mass is 0.35 grams. To get the mass of zinc‚ the mass of the penny was subtracted by the mass of copper. The mass of zinc is 2.16 grams. The penny is 14%
Premium Water Chemistry Oxygen
Student’s Name Date of Experiment- 11/27/12 Date Report Submitted 11/27/12 Title: Caloric Content of Food Purpose: to be able to measure the energy content of foods Procedure: We are going to take food items and burn them to heat water to be able to determine the amount of “energy” a food source can emit. Data Tables: |Data Table 1: Food Item - Observations
Premium Heat Thermodynamics Energy