Evelyn Ramos CHEM LAB 201-003 Professor Ruddock Experiment #4 - Chemical Reactions Performed: 3/6/13 DUE: 3/13/13 Pre Lab Questions: 1. Before you can write a chemical equation‚ what must you know? You have to know what the products and reactants are. 2. What observations might you make that suggest that a chemical reaction has occurred? If a gas is produced or precipitates are formed that indicates chemical reaction. Also‚ if color changes occur or
Free Solubility Chemical substance Chemical reaction
Laboratory 6: Energy Changes in Chemical Reactions Note: Lab reports are to be completed by each student individually and in their own words Observations: (This part is to be completed in class) Part 1: Physical Change- Heat of Solution for Sodium hydroxide (NaOH) 3.2 grams NaOH Result: Temperature of DI water = ____22.8 °C Temperature after addition of NaOH = ______31.8 °C Part 2: Chemical Change- Reaction between acid and base Result: Temperature of HCl = ___21.4 °C Temperature after addition
Premium Thermodynamics Chemical reaction Energy
(Ba(OH)2). Through the conductivity‚ the equivalence point can be determined; from there‚ the concentration of the Ba(OH)2 solution can be found. The final product of the reaction between sulfuric acid and barium hydroxide is insoluble. According to the lab manual‚ during the reaction‚ the total number of dissociated ions in solution is greatly reduced as a precipitate is formed. With the Conductivity Probe‚ the changes in conductivity of the solution will be analyzed. The collection of Ba(OH)2 precipitate
Premium Chemistry Solubility
Although I love science‚ I encountered more problems in this subject than any other. Recently‚ I was assigned a lab. The purpose was to let Copper Sulfate react with Aluminum and obtain Copper. Before the experiment‚ I set up the stoichiometric equation carefully‚ predicting the production of Copper using my assigned mass of Copper Sulfate. Additionally‚ I intentionally made Copper Sulfate an excess in my equation‚ since it would be dissolved in water and I would only have to collect Copper at the
Premium Aluminium Nitrogen Iron
Objective: The purpose of the lab is to learn filtering techniques. Specifically‚ to form and filter a calcium carbonate precipitate using a Buchner funnel. Procedure: a.) Prepared a mixture of .5 M calcium nitrate (45 mL) and .01 M sodium carbonate by combining and stirring the two liquids in a beaker. Allow the mixture to stand. b.) Prepare the filtration assembly. The assembly consists of a tapered flask with a buchner funnel inserted in the top. The funnel has a rubber stopper attached
Premium Laboratory glassware Water Solid
Experiment 12: Calorimetry and Hess’s Law Purpose: The purpose of this lab is to determine the enthalpy of reaction for the burning of one mole of magnesium in oxygen. Although the reaction is exothermic‚ the ∆HRXN will be determined by using calorimetry and then using Hess’s Law to manipulate the data collected to yield the answer needed. Procedures: Dillon‚ Stephanie. “ Calorimetry and Hess’s Law.” Laboratory Manual. Pearson Publishing‚ 2012‚ pp.168-177. Data and Results Part A
Free Enthalpy Thermodynamics
properties of standard AA1199-O4‚ with minor deviations. The deviations could be attributed to the processing conditions and/or purity level. To have a justified comparison‚ the processing conditions were kept same for the fabrication of Al-CNT composites. In Al-CNT composites’ specimens‚ the yield and tensile strengths increased from 29 MPa and 56 MPa to 97 MPa and 109 MPa‚ respectively. However‚ a decrease in elongation from 22.6 % to 7.4 % was observed. It is believed that the amelioration of
Premium Force Mass Tensile strength
Writing an Organic Chemistry Lab Report Components of a Laboratory Notebook The following components should be contained for each experiment‚ along with any additional material required by your instructor. • Title and date • Introduction (purpose‚ reaction) • Physical data (including calculations) • Procedure outline • Data and observations • Discussion of results (conclusions) Prelab Title and Date Give the title of the experiment and the date on which
Premium Chemistry
Chemistry Review (mid-term) 1. Use the equation for atomic mass to answer the following questions. (http://johnheilchem10.escuelacampoalegre.wikispaces.net/file/view/average+atomic+mass+calculations+-+3.pdf) 1. Argon has three naturally occurring isotopes: argon-36‚ argon-38‚ and argon-40. Based on argon’sreported atomic mass‚ which isotope do you think is the most abundant in nature? Explain. 2. Copper is made of two isotopes. Copper-63 is 69.17% abundant and it has a mass of 62.9296 amu.
Premium Atom Chemistry Chemical reaction
METALS Reacting Gas Volumes AIM: to investigate the relationship between the volumes of gases involved in a reaction. HYPOTHESIS: A new gas will form when two gases will react together. BACKGROUND INFORMATION: Nitric oxide and oxygen are both colourless gases which do not dissolve in water. However‚ when they mix they form a different gas called nitrogen dioxide which is brown‚ soluble in water and has a particular odour. This is an example of two gases reacting together to produce
Premium Chemical reaction Hydrogen Chemistry