Calorimetry Lab Problem: Which foods have the most calories? Hypothesis: If we burn the food then the heating released will be measured as calories because the energy stored inside is released as heat and light. Parts of the experiment Control Group-water Experimental Group- different foods Independent variable- Type of food Dependent Variable- temperature of water Controlled variables- water temperature of unheated water Materials Stirring Rod‚ Beaker‚ ring clamp‚ evaporating disk‚
Premium Energy Heat Temperature
sulphate solution Safety: 1. Be careful with copper (II) sulphate solution it is poisonous and corrosive. handle with care 2. Do NOT BREATH in any gases produced 3. If you touch any of the metals‚ you MUST wash your hands at the end of the lab Procedure: 1. Collect the materials and put on safety equipment. 2. Observe the metals and record your observations. 3. Into separate test tubes‚ place each metal inside. Label accordingly to metal. 4. Measure 5mL of the copper (II)
Premium Copper Chemical element Chemistry
mass of the beans Dependent variable: the different types of beans Control: The beans Purpose: The purpose of the lab is to find equal measurement of each type of bean. After you find the mass of each bean you need to find the relative mass of each bean. The navy bean will have the smallest relative mass. You will need to wear safety goggles and a lab apron and wash hands after the lab is finished. If you drop any beans pick them up immediately to prevent anyone from slipping. Materials Safety goggles
Premium Common bean Phaseolus Periodic table
Lab 4-B Purpose The purpose of this lab is to test these solutions and see what type of reaction occurs and see if a precipitate or gas forms between any of these reactions. Research 1. Table A Reactants in Aqueous Solutions Predictions (1) MgCl₂(aq) + 2NaOH(aq) Mg(OH)₂(s) + 2NaCl(aq) (2) FeCl₃(aq) + 3NaOH(aq) Fe(OH)₃(s) + 3NaCl(aq) (3) 2KCl(aq) + Na₂SO₄(aq) K₂SO₄(s) + 2NaCl(aq) (4) CaCl₂(aq) + 2AgNO₃(aq) Ca(NO₃)₂(s) + Ag₂Cl(aq) (5) CuSO₄(aq) + Na₃PO₄(aq) Cu₃PO₄(aq) + Na₂SO₄(s) 2. Table B
Premium Chemistry Chemical reaction Chlorine
Purpose Name Due Date Clothespin Lab / Muscle Fatigue What are the affects of anaerobic respiration on you muscles? Background Normally‚ muscles use oxygen through a process known as cellular/aerobic respiration to make energy (or ATP) from sugar (glucose). This process is very efficient and produces 38 ATPs for each molecule of glucose. Carbon dioxide and water are the results of this reaction. When muscles undergo rigorous exercise they require more oxygen to make ATP than the
Premium Oxygen Muscle Cellular respiration
Student’s Name Date of Experiment- 11/27/12 Date Report Submitted 11/27/12 Title: Caloric Content of Food Purpose: to be able to measure the energy content of foods Procedure: We are going to take food items and burn them to heat water to be able to determine the amount of “energy” a food source can emit. Data Tables: |Data Table 1: Food Item - Observations
Premium Heat Thermodynamics Energy
The Osmosis Lab SHS Lacrosse Monster #2 Dates performed: 10/10/11 and 10/11/11 Introduction: The purpose of the laboratory investigation was to observe the diffusion of water across a semi-permeable membrane. In this lab‚ dialysis tubing was used to represent the semi-permeable cell membrane. Three dialysis tubes were prepared with 5% sucrose solution and were soaked in solutions of different concentrations. The diffusion of water across a semi-permeable membrane is called osmosis. When
Premium Concentration Semipermeable membrane Osmosis
PROBABILITY and MENDELIAN GENETICS LAB Hypothesis: If we toss the coin(s) for many times‚ then we will have more chances to reach the prediction that we expect based on the principle of probability. Results: As for part 1: probability of the occurrence of a single event‚ the deviation of heads and tails of 20 tosses is zero‚ which means that the possibility of heads and tails is ten to ten‚ which means equally chances. The deviation of heads and tails of 30 tosses is 4‚ which means that the
Premium Gregor Mendel Genetics Allele
Alexis Becker Pre-Lab Experiment 7 Avinash Pallagani Investigating Stoichiometry with sodium salts of carbonic acid 4/2/14 A summary of the concepts: The purpose of this lab is to better understand “stoichiometry”. We will be reacting sodium carbonate (NaHCO)3 and sodium carbonate (Na2CO3) with hydrochloric acid to produce sodium chloride‚ water‚ and carbon dioxide. The balanced chemical reaction looks like this: NaHCO3 + HCl = NaCl + H2O + CO2 CAUTION: Be especially
Premium Hydrochloric acid Sodium bicarbonate Sodium
Lab Report Janice Chisholm SCI207: Dependence of Man on the Environment Instructor: Lee Ott April 28‚ 2013 1. What patterns do you observe on the information table 4? While observing the information in table 4‚ it appears that the number of fish changes from time to time and the oxygen increases and / or decreases when this occurs. 2. Develop a hypothesis relating to the amount of dissolved oxygen measured in the water sample and the number of fish observed in the body of water?
Free Observation Scientific method Hypothesis