Introduction The study of chemical reactions‚ isomerizations and physical behavior that may occur under the influence of visible and/or ultraviolet light is called Photochemistry. The fundamental principles for understanding photochemical transformations are that light must be absorbed by a compound in order for a photochemical reaction to take place‚ and that for each photon of light absorbed by a chemical system only one molecule is activated for subsequent reaction. This "photo equivalence law" was
Premium Oxygen Sunlight Electromagnetic radiation
Tittle : Investigation of the Enzymatic Effects of Materials on Hydrogen Peroxide Solution Objective: To investigates the enzymatic effect of various materials in the hydrogen peroxide solution. Table 1 Test Tube Contents with 5 cm3 hydrogen peroxide Observations before and after using wood splint Observation of after Observation of after adding hydrogen using wooden glowing peroxide splinter 1 Fresh liver Moderate
Premium Oxygen Hydrogen peroxide Catalase
Limiting Reagent and Percent Yield Aim To determine the limiting reagent between the reaction of lead (II) nitrate and potassium iodide. To determine the percent yield of lead (II) iodide. Date Started: 13/4/12. Finished: 19/4/12. Data collection and processing Measurements: * Amount of distilled water: 75.0ml ± 0.5ml. * Mass of watch glass: 31.65g ± 0.01g. * Mass of watch glass + potassium iodide: 32.45g ± 0.01g. * Mass of potassium iodide: 0.8g ± 0.02g. * Mass of watch
Premium Stoichiometry Yield Molecule
transfer 0.8 ml of this solution and the reaction was allowed to proceed until the solution turns brown and cloudy. The conical vial was then rinsed with 2 ml of anhydrous ether to get any remaining solution into the reaction vessel. Simultaneously‚ 1.09 g of benzophenone and 2ml of anhydrous ether were added to a 3ml conical vial and gently stirred. The reaction vessel was taken off of the hot plate and allowed to cool. The benzophenone was then added to the reaction mixture while stirring vigorously.
Premium Chemistry Water Solvent
Experiment 4: Qualitative Analysis of Cations and Precipitation Reactions The overall goal of experiment four was to determine the identity of unknown cations presented to the student. But in order to know the identity of these unknowns‚ in part 1‚ Ag+‚ Pb+‚ and Hg22+ were presented to the student in aqueous solutions and then precipitated through experimentation. In part 2‚ the same procedure was enacted to determine which substances precipitated through qualitative analysis. Solubility rules
Free Solubility Solid Precipitation
The Effect of Temperature on The Viscosity of Glycerol Research Question: What is the effect of increasing the independent variable of the temperature of glycerol (30ºC‚ 40ºC‚ 50ºC‚ 60ºC and 70ºC) (+ 0.5ºC) using a hotplate and measured using a thermometer (+ 0.05º)‚ on the dependent variable of time (secs + 0.2) taken for 50mL (+ 0.05ml) of glycerol to flow through a 50cm3 burette (+ 0.05cm3) into a 250 mL beaker (+ 12.5 mL) measured by a digital stopwatch (+ 0.2secs)‚ therefore indicating the
Premium Temperature Heat Viscosity
II. LEARNING OBJECTIVES - To perform different types of chemical reactions including acid-base‚ precipitation‚ gas forming‚ complex compound forming and oxidation-reduction reactions. - To identify some of the products in these reactions and describe the chemical changes. - To write and balance the chemical equations for the reactions observed. III. EQUIPMENT AND REAGENTS 1. EQUIPMENTThirty test tubes One test tube rack Two test tube holders Two spatulas Three 250 mL beakers One stirring rodOne
Premium Chemical reaction Chemistry Solubility
Purpose To check whether mass is gained or lost during a Chemical reaction. Hypothesis Equipments and Materials • Eye protection • Test tube • 250 ml Erlenmeyer flask and stopper • Weight Balance • Antacid tablet • Dilute solutions of o Sodium Hydroxide‚ NaOH(aq) o Iron(III) Nitrate‚ Fe(NO3)3 • Funnel • Cylinder Procedures 1. Put eye protection on for safety purposes. Part A: Reaction between Iron(III) Nitrate and Sodium Hydroxide. 2. Take two cylinders and fill one (full)
Free Sodium hydroxide Chemistry Sodium
Organic Chemistry II Lab 9 Fermentation of a Carbohydrate: Ethanol from Sucrose * Introduction Ethanol is one of the oldest alcohols and also the least toxic one. Industrially‚ ethanol is made most economically by hydration of ethylene. However‚ ethanol that is intended for human consumption must‚ by law‚ be prepared by fermentation. By either method‚ ethanol‚ of course‚ has the same formula‚ structure‚ and properties. The fermentation takes place with the assistance of enzymes from yeast
Premium Ethanol Glucose Carbon dioxide
This reaction is carried out by adding benzaldehyde and acetone into a flask. The product created is a 1‚5-diphenyl-1‚4-pentdiene-3-one‚ which includes two double bonds‚ and two benzyl ring functional groups. This is a dehydration reaction that occurs twice in order to form the diene. After obtaining the product‚ via vacuum filtration‚ it will be recrystallized and then analyzed for purity by determining both products’ melting point. The two products will be compared. Chemical Reactions:
Premium Chemical reaction Aldehyde Acetic acid