Financial Management SBB Fundamentals COURSE GUIDE Leiden University Faculty of Mathematics and Natural Sciences Science Based Business Program March 2011 © 2011 All rights reserved Centre for Business Studies (CBW) Leiden University Except as allowed under Dutch Copyright Law (1912)‚ no part of this material may be reproduced or transmitted in any form‚ by any means‚ electronic or mechanical‚ including photocopying‚ recording‚ or any information storage and retrieval system
Premium Corporate finance Net present value Working capital
between conductors by using the configurations and conductor values given for each line segment. These results provide the information needed to create the primitive impedance matrix‚ Zprim. Using the matrix operation known as Kron reduction‚ shown in Equation (1) below‚ these primitive matrices can be converted into Zabc impedance matrices. Z=A-BC^(-1) D (1) Each matrix can then be multiplied by its respective segment length to convert to actual ohmic values of line resistance. These matrices
Premium Voltage Alternating current Direct current
INSTRUCTIONAL MANUAL IN ALTERNATING CURRENT CIRCUITS An Instructional Manual Presented to the Faculty of the Graduate School Western Institute of Technology La Paz‚ Iloilo City In partial fulfillment of the Requirements for the Course EGC 600 – RESEARCH by Engr. boysie t. tejada March 2012 INSTRUCTIONAL MANUAL IN ALTERNATING CURRENT CIRCUITS An Instructional Manual Presented to the Faculty of the Graduate School Western Institute of Technology La Paz
Premium Alternating current Electrical engineering Electricity
Refractive index measurement is actually a measurement of the speed of light in a medium. The speed of light (usually denoted by c) is 299 792 458 m/s in vacuum. In other media the speed of light is lower than this value‚ and the refractive index‚ R.I.‚ of a medium is a measure of how much the speed of light is reduced in the medium. The refractive index (n) of a medium is defined as the ratio of speed of light in vacuum (c) in to that in the medium (v) The speed of light in a medium depends on
Premium Total internal reflection Refractive index Optics
Earth Faults in Extensive Cable Networks Electric Distribution Systems Anna Guldbrand Licentiate Thesis Department of Measurement Technology and Industrial Electrical Engineering 2009 Department of Measurement Technology and Industrial Electrical Engineering Faculty of Engineering Lund University Box 118 221 00 LUND SWEDEN http://www.iea.lth.se ISBN:978-91-88934-49-9 CODEN: LUTEDX/(TEIE-1057)/1-129/(2009) © Anna Guldbrand‚ 2009 Printed in Sweden by Media-Tryck‚ Lund University Lund
Premium Electricity distribution Electric power transmission Electrical resistance
Kirchhoff’s Law Kirchhoff’s current law (KCL) imposes constraints on the currents in the branches that are attached to each node of a circuit. In simplest terms‚ KCL states that the sum of the currents that are entering a given node must equal the sum of the currents that are leaving the node. Thus‚ the set of currents in branches attached to a given node can be partitioned into two groups whose orientation is away from (into) the node. The two groups must contain the same net current. In general
Premium
General Electrical Medical Systems Prepared by Mohamed Tarek Esmat Student ID 091076 Q1: What is the underlying logic behind the global product company idea? Global Product Company (GPC) philosophy is mainly aiming at producing products that fit global markets with lowest cost and highest profit. This philosophy has mechanisms that have been applied to different phases of product lifecycle: Manufacturing phase: In manufacturing phase‚ cutting costs was achieved by moving manufacturing
Premium Marketing Product management Health care
Chapmans Electrical is a business in West Midlands that has been around for 90 years; Chapman Electrical serves their customers electrical goods; Chapmans Electrical offer their customers a service (such as a Television Repair)‚ products (like Home Appliances) and an installation service (such as Wi-Fi Home & Networking). Also‚ Chapmans Electrical sells their service‚ products and installation serve to their customers to the public; anyone can take part on what Chapmans Electrical has to offer for
Premium Customer Good Customer service
Why use regulated power supplies? The ideal voltage-regulated power supply would have the following features: 1. Zero output impedance at DC and at all frequencies 2. Zero regulation (constant DC output voltage) for a wide range of AC line voltages and over the entire range of load currents that are required by the powered circuitry. 3. Zero power dissipation. 4. Instantaneous recover from changes in line voltage and load current. 5. Overload protection so that normal operation is automatically
Premium Alternating current Direct current Electrical engineering
MEDTRONIC CONFIDENTIAL AND PROPRIETARY – FOR INTERNAL USE ONLY DF-4 System Description • A new industry standard at the point of lead-pin to device-port connection • four poles of electrical contact on an inline connector‚ • reduces bifurcated and trifurcated lead-device connectors into a single connection • single pin-to-port connection for a high power lead instead of two or three connections. CRT-D DR MEDTRONIC CONFIDENTIAL AND PROPRIETARY – FOR INTERNAL USE ONLY DF-4 Key Clinical
Premium Electrical engineering Electricity