Observations of Chemical Changes Purpose: The purpose of this experiment is to observe chemical changes in common consumer products to determine if the chemicals are basic‚ acidic‚ or remain neutral when mixed with other chemicals. Procedure: In this experiment‚ various chemicals were mixed together‚ to determine a reaction. Using two drops from chemical 1 and two drops of chemical two‚ unless otherwise stated‚ then recording the type of physical reaction or color changes that occurred. Well#/questions
Premium PH Acid Chlorine
Plan: Aim: The enthalpy change of combustion of a fuel is a measure of the energy transferred when one mole of fuel burns completely. A value for the enthalpy change can be obtained by using the burning fuel to heat water and using fact that 4.2j of energy are required to raise the temperature of 1g of water by 1oC. In this investigation my aim is to find the enthalpy change of combustion of a number of alcohols so that I can investigate how and why the enthalpy change is affected by the molecular
Premium Ethanol Enthalpy Energy
this experiment is to differentiate between a physical change and a chemical change. A physical change includes a change in the material without affecting its composition‚ such as the physical state change. However‚ a chemical change includes the change in the composition of the substance. The change in color‚ formation of a gas or a solid product‚ and the production of energy are the evidences of a chemical reaction‚ thus‚ of a chemical change. Materials Crucible tongs Evaporating dish
Premium Hydrochloric acid Chemistry Chemical reaction
I am going to investigate the enthalpy change of combustion for the alcohol homologous series. I will investigate how alcohols with increasing number of carbons affect the enthalpy change when an alcohol goes under combustion. The energy that alcohols release when being used is called the enthalpy change of combustion. This is defined as "Standard enthalpy change of combustion‚ is the enthalpy change when one mole of a substance burns completely in oxygen under standard conditions (298K‚ 100 KPa
Premium Enthalpy Thermodynamics Energy
Acid Base Titration Purpose: The purpose is to calculate the molarity of a NaOH solution by titrating the base with 5mL of standard HCl solution in each trial. By adding the base with unknown molarity to the acid with 0.10M the molarity of NaOH can be calculated. The base‚ NaOH‚ helps bring the pH of the acid‚ HCl‚ closer to seven‚ which neutralizes it. When using the buret the amount of NaOH used is able to be determined. Then by writing a balanced chemical equation and using the titration
Premium Titration Sodium hydroxide Acid
The solubility of calcium hydroxide Aim: to find out the solubility of a substance that only partially dissolves in water. Method: place about 100cm3 of distilled water in a flask and add about one spatula of solid calcium hydroxide. Stopper the flask and shake well for one minute. Leave to stand for at least 24 hours. Titrate 10cm3 samples against 0.05 mol dm-3 hydrochloric acid solution using methyl orange as an indicator. Obtain enough results to calculate an accurate average‚ and then
Premium Calcium carbonate PH indicator Base
amount of unknown acid X measured in grams (±0.001g) Table 2: Table of reading of the burette initially filled with 25mL of 0.201moldm-3 sodium hydroxide (NaOH) to titrate 25mL (±0.03mL) of unknown acid X in mL (±0.05mL) after each titre. Reading on the burette initially filled with 25mL of 0.201moldm-3 NaOH (±0.05mL) First titre 21.3 Second titre 18.2 Third titre 15.2 Fourth titre 12.0 Qualitative data Observations: When dissolving the acid X in the water‚ most of it did not
Premium Acid Sodium hydroxide Solubility
The identification of acids and bases using a natural indicator Purpose: The purpose of this lab practice is to identify the pH of certain solutions and if they are acids or bases. Introduction: In chemistry‚ pH is a measure of the activity of the (solvated) hydrogen ion. p[H]‚ which measures the hydrogen ion concentration‚ is closely related to‚ and is often written as‚ pH. Depending on the pH solutions will be acids or bases. An acid is a chemical compound that dissociates in solution‚ releasing
Premium PH Acid PH indicator
Discussion The purpose of this lab is to display the influence of retronasal olfaction when it comes to flavor. Humans have two different types of olfaction. Olfaction is the detection of chemicals in the air. These chemicals which are meant to activate odor receptors‚ are called odorants. Humans have approximately 20 million olfactory receptors‚ which is only a fraction compared to bloodhounds who have 4 billion. The first type of olfaction is called orthonasal olfaction which is inhaling. Here
Premium Olfaction Taste Sense
Analysis of Soda Ash and Volumetric Analysis of a Carbonate-Bicarbonate Mixture Buti‚ Mary Daphne A. Department of Chemical Engineering‚ Faculty of Engineering University of Santo Tomas España‚ Manila Abstract Sodium carbonate (Na2CO3)‚ commonly known by trade name soda ash‚ is a white‚ anhydrous‚ powdered or granular material that is an essential raw material used in the manufacturing of glass‚ detergents‚ chemicals‚ and other industrial products. In this experiment‚ the percent alkalinity
Premium Hydrochloric acid Sodium hydroxide Chlorine