Candy Au Introduction The reaction between zinc and copper (II) sulphate is endothermic. If an excess of zinc powder is added to a measured amount of aqueous copper (II) sulphate in a calorimeter and the temperature change is recorded over a period of time‚ the enthalpy change of the reaction can be experimentally determined. Assumption 1. Mass of H2O in 100cm3 of CuSO4 solution is 100g 2. Specific heat of solution is 4.18 kJ kg-1 K-1 which is the same as the specific heat of water
Premium
Bonding • Redox‚ Group 2 and Group 7 Unit 1 Exam – January 2013 – 1 hour – 90 UMS – 30% of total Unit 2 – Spring Term 2013 • Basic Concepts in Organic Chemistry • Alkanes and Alkenes • Haloalkanes and Alcohols • Enthalpy Changes • Rates and Equilibrium • Modern Analytical Techniques • Chemistry of the Air • Sustainability Unit 2 Exam – May 2013 – 1 hr 45 mins – 150 UMS – 50% of total Unit 3 – Autumn Term 2012 and Spring
Premium Mole Avogadro constant Amount of substance
Purpose: This laboratory was performed to find the temperature change‚ heat of reaction‚ and enthalpy change for neutralization reactions. The temperature change was found by subtracting the initial temperature from the final temperature obtained. Heat of reaction is negative heat of solution. Heat of solution was found by using the formula qsolution = mCsΔT (m= mass; Cs= 4.184 J/g°C; and ΔT = change in temperature). The enthalpy change was found by dividing the heat of reaction by the number of moles
Premium Thermodynamics Chemistry Chemical reaction
Experiment ENTHALPY AND ENTROPY OF ZINC WITH COPPER SULFATE The CCLI Initiative Computers in Chemistry Laboratory Instruction LEARNING OBJECTIVES The learning objectives of this experiment are to. . . ! ! determine changes in enthalpy and entropy of the reaction of zinc with copper sulfate using two methods: electrochemistry and calorimetry. compare the enthalpy values obtained by the two methods. BACKGROUND Thermodynamics is concerned with energy changes that occur in chemical and physical process
Premium Electrochemistry Enthalpy Thermodynamics
used and extracted‚ we could run out of oil in 50 years. We need to conserve what fuels we have left and stop using them in our cars. Another big problem with burning fossil fuels‚ especially gasoline‚ is the damage it causes to the environment. Combustion of fuels in cars has been identified as the largest contributor to air pollution in the world.
Premium Oxygen Carbon dioxide Petroleum
Heats of Combustion of Alkanols Aim: To perform a first-hand investigation to determine the heats of combustion of selected alkanols. Hypothesis: It was predicted that methanol would have the highest molar heat of combustion‚ decreasing as the chains become longer. Equipment: • Three spirit burners containing methanol‚ ethanol and propan-1-ol respectively • Electronic scales • Water • 100ml measuring cylinder • Retort stand and boss-head clamp • Copper beaker • Thermometer Method:
Premium Oxygen Thermodynamics Gas
DELHI PUBLIC SCHOOL‚RANIPUR‚HARIDWAR LESSON 6:COMBUSTION AND FLAME DATED:24.07.14 1 COMBUSTION: When a substance combines readily with oxygen to give heat and (light) it is called combustion. 2 COMBUSTILE SUBSTANCE: A substance which burns easily to give heat it is said to be combustible. For ex. Wood ‚paper 3 FUEL: A substance that is burnt for obtaining heat and light is called a fuel. Carbon based fuel: wood ‚coal‚wax ‚petrol etc. Non carbon based fuel: hydrogen 4 CHARACTERISTICS OF AN
Premium Combustion Oxygen Carbon dioxide
Professor Department of Aerospace Engineering IIT Kanpur 13th July‚ 2012 ABSTRACT Numerical Studies of Microcombustion in a Micro-channel There are a lot of methods that converts chemical energy to thermal energy like fuel cells. But combustion is the most important one to obtain thermal energy from various fuels including hydrogen‚ natural gas‚ fuel oils because of its more energy output. Microcombustion is a potential energy source for small devices like unmanned vehicles and micro
Premium Thermodynamics Chemical reaction Hydrogen
Heat of Combustion Questions 1. When bonds are broken‚ energy is required. When bond are formed‚ energy is released. All combustion reactions are exothermic. Suggest a reason for this in terms of the bonds broken and bonds formed. The energy required to break the bonds is greater than the energy required to form. 2. Explain why the heat of combustion of alkanols increases as the length of the carbon chain increases. The heat of combustion of alkanol increases as the length of carbon chain
Premium Heat Thermodynamics Hydrogen
Addition of carbon Combustion is the rapid burning of fossil fuels. Stored carbon in coal‚ oil and natural gas returns to the atmosphere when these fossil fuels are burnt and during natural combustion occurrences such as volcanic eruptions. Fossil Fuels such as coal are constructed when a living organism dies and decomposers‚ ie Fungi and microbes are unable to decompose it. After the organic material is untouched for millions of years‚ it eventually turns into fossil fuels. Petroleum‚ coal and
Premium Carbon dioxide Oxygen