Engineering Laboratory (Lab) Report Department of Engineering Faculty of Engineering and Science‚ University Tunku Abdul Rahman (UTAR) 1. Introduction Laboratory (Lab) reports are the most frequent document written by engineering student. These reports can contribute a significant amount of marks and yet little time or attention is devoted in understanding on how to write them well. The aim of this document is to provide a general guideline on writing a lab report. A lab report should not be
Premium Present tense Experiment Grammatical tense
Name: Danielle Title: Unknown Lab Report Introduction: There are many reasons for identifying an unknown bacterium. The reasons range from medical purposes‚ such as determining if the unknown could cause ailments in living things or knowing what microorganisms are needed to make antibiotics. The experiment was done by applying methods in order to identify an unknown bacterium. An unknown bacterium was handed out by Dr. Honer. The appropriate tests were prepared and applied. The
Premium Bacteria Escherichia coli Microbiology
[Name] [Teacher] [Course] [Date] Catalase Lab Report An enzyme is something that helps to speed up a chemical reaction. The enzyme changes from reaction to reaction‚ but it always has the same impact. However‚ certain variables may cause the enzyme to have a more or less significant impact on the speed of each reaction. One of these variables that changes the effectiveness of an enzyme is temperature. There is an optimal functioning temperature for each enzyme in each reaction‚ depending on
Premium Chemical reaction Oxygen Water
CO2 Lab Report Intro Alka-Seltzer tablets are used to treat cold/flu symptoms as it produces CO2 when dissolved in water. The goal of this lab is to calculate the amount of NaHCO3 is needed to produce enough CO2 gas to fill the room. Experimental One Alka-Seltzer tablet was weighed on the analytical balance. Then a piece was measured out to be between 0.21 and 0.28 grams. 500mL of distilled water was added to a 600mL beaker. 80mL of water was mixed with 20mL of 6M HCl in a 150mL beaker. A
Premium Tablet Laboratory glassware
Hugh Kim Lab Report: Stoichiometry Lab 1. Prelab Part1. 1) Create no waste = The principle that encourages chemists to not create waste at the first place rather than cleaning it up afterwards effectively shifts the chemistry more environmentally conscious‚ as creating no waste would make the experiment efficient; the reactants will be reduced to only the essential ones and the product will be maximized‚ a change that would make the experiment economic. Also‚ if chemists aim to
Premium Chemistry Chemical reaction Hydrogen
Abstract This lab is performed in order to determine the total energy in a reaction between zinc and hydrochloric acid. The reaction is done twice‚ once to measure the heat of the reaction and again to determine the work done in the system. This is because Enthalpy equals heat plus work (∆H= ∆E+W). Heat and work can be broken down further into separate components so the equation used in lab is ∆H=mc∆T + PV. Many calculations are used in the lab to find out what cannot be measured directly (ex:
Premium Thermodynamics Energy Temperature
Introduction In unit 7.3 the experiment tested the ability of lactase to specifically bind and interact with lactose compared to maltose. In unit 7.4 the experiment tested the role‚ if any‚ that metal ions have on the activity of lactase. My hypothesis for unit 7.3 was knowing that lactase is specific for lactose‚ lactose will separate into galactose and glucose‚ as maltose will not change (153-155). Lactase should like lactose. For unit 7.4 my hypothesis was that EDTA will remove the ions‚ and
Premium Null hypothesis Enzyme Disaccharide
Limiting Reagent and Percent Yield Aim To determine the limiting reagent between the reaction of lead (II) nitrate and potassium iodide. To determine the percent yield of lead (II) iodide. Date Started: 13/4/12. Finished: 19/4/12. Data collection and processing Measurements: * Amount of distilled water: 75.0ml ± 0.5ml. * Mass of watch glass: 31.65g ± 0.01g. * Mass of watch glass + potassium iodide: 32.45g ± 0.01g. * Mass of potassium iodide: 0.8g ± 0.02g. * Mass of watch
Premium Stoichiometry Yield Molecule
TABLE OF CONTENT NO. | CONTENT | PAGE | 1. | Title | 2 | 2. | Theory | 2 | 3. | Introduction | 2 | 4. | Objective | 3 | 5. | Apparatus | 3 | 6. | Procedure | 4 | 7. | Result | 6 | 8. | Calculation | 10 | 9. | Discussion | 13 | 10. | Conclusion | 14 | 11. | References | 14 | TITLE: H1 – Osborne Reynolds Demonstration INTRODUCTION: Osborne Reynold’s Demonstration has been designed for students experiment on the laminar‚ transition and turbulent flow. It consists of a transparent
Free Fluid dynamics Reynolds number Viscosity
Inorganic Chemistry 1. A subatomic particle with a single positive electrical charge is protons. 2. A subatomic particle with a single negative electrical charge is electrons. 3. A subatomic particle which is electrically neutral is neutrons. 4. The nucleus of an atom is made up of _protons_ and _neutrons. 5. The number of electrons forming a charge cloud around the nucleus is (pick one of the following) greater than; equal to; smaller than the number of protons in the nucleus of the atom.
Premium Atom Electron