Kristen Sierman Lab Report: Experiment #7 Group #4 October 16th‚ 2012 Forces on a Pulley System A. Statement of the Problem The purpose of this lab was to address the following questions: how does the acceleration of a pulley system depend on the mass of the driving objects? And how does the acceleration of a pulley system depend on the mass of the driven object? To achieve this‚ a dynamic track was set up with a string attached to a cart. The string was part of a pulley system (the pulley
Premium Force Classical mechanics Mass
Kiley O’Toole Lab Report 3 Purpose The purpose of this lab was to uncover the number of layers of zinc atoms around a piece of galvanized iron. This was done by pouring the hydrochloric acid onto the galvanized iron‚ thus removing the zinc from the piece of metal. Laboratory Procedure 1. Measured and recorded the mass of a piece of galvanized iron using a centigram balance and a ruler 2. Measured and recorded the length and width of the galvanized iron using the ruler 3. Put the
Premium Hydrogen Zinc Length
October 1‚ 2013 Chemical Reactions of Copper Objective The objective of this lab is to convert copper (Cu0) “in a series of reactions to various compound containing copper as the Cu2+ species” (CHM111 Laboratory Manual) in order to prove the Law of the Conservation of Mass. Introduction In this experiment‚ we took a look at how copper (Cu0) reacts with different substances to get an end result where it is transformed back to its original state. There were five different reactions that involved
Premium Chemistry
In this lab we tested to see if the amount of sunlight exposed to the basil seed‚ would affect the growth. The null hypothesis for this experiment was that there would be no statistical difference between the green‚ yellow‚ and red basil seeds’ growth. Three alternate hypotheses are: If we expose the green seed to 48 hours of sunlight and the yellow seed to 24 hours of sunlight‚ then the green seed with grow more than the yellow. The opposite of this hypothesis would alternate 2. Another alternate
Premium Null hypothesis Hypothesis Statistics
Grade 11 Dynamics Lab Report Friction SPH3U1-02 Williams. C. By----James & Hao Feng & Henry Zhang Purpose: By measuring the friction and μ of a container and change different variables including mass‚ surface and gradient‚ get causes of the change of friction and μ. Materials: A container Three Pen bag in different mass A rough wood board A clean desk Rulers Thrust meter. Steps Prepare
Premium Force Classical mechanics Friction
Abstract This lab’s purpose was to test the patterns of percolation in various places. This lab tested how soil would absorb water based on different places. Distance from a group of trees‚ distance from a swamp‚ and different types of soil were tested. From the results collected‚ you can not prove‚ but you can infer that the ability to absorb increases as you go farther away from a swamp‚ and a group of trees. The ability to absorb also increases based on how much silt is in soil. Introduction
Premium Soil Surface runoff Digestion
Chart 3.1: Velocity at 3 degrees Chart 3.2: Velocity at 6.3 degrees Chart 3.3: Velocity at 8.5 degrees Chart 3.4: Velocity at 90 degrees Discussion: The results that were observed from this lab helped prove what was hypothesized. As chart 1.4‚ 2.4 and 3.4 displayed the object dropped off of the 90 degree slope was the quickest to cross 200cm‚ had the highest velocity and the highest acceleration. This was because at 90 degrees the gravitational
Premium Velocity UCI race classifications Tour de Georgia
.(n.d). How Soil Influences Water. http://www.soil.ncsu.edu/publications/Soilfacts/AG-439-01/ http://www.eng.utoledo.edu/civil/heydinger/soil%20mechanics/SMgeol.pdf http://courses.ma.org/sciences/anat_phys/Intro%20Info/Lab%20Format.htm http://courses.nres.uiuc.edu/nres201/Labs/Lab%206%20Soil%20Texture%20and%20Density.pdf
Premium Soil Sand Silt
volume‚ mass‚ and density of objects and liquids. Time Allocation: Allow 2 hours for this experiment Materials Materials Student provides Label or Box/Bag Qty 1 1 1 1 1 LabPaq provides Auxiliary Supplies BagCK1 © Hands On Labs‚ Inc. 1 1 1 1 1 1 1 1 1 1 1 LabPaq CK-1 Item Description Table salt Piece of string Isopropyl (rubbing) alcohol Tap water Paper‚ 5 cm x 5 cm for weighing chemicals Beaker‚ 100 mL‚ glass Cylinder‚ 25 mL 25-mL volumetric flask
Premium Density Volume Kilogram
Lab 3 : Techniques in Microscopy Title : Preparation of light microscope observe cell organisms. Objective : To observe and investigate the cell structure under the light microscope. Introduction A microscope is an instrument used to magnify and resolve a specimen. It is important to know several important features of microscopy which involves magnification‚ resolution and contrast. Magnification is the enlargement of a specimen while resolution is the ability to distinguish detail or the
Premium Microscope