Heat of Neutralization Lab Objective: The objective of this lab was to measure‚ using a calorimeter‚ the energy changes accompanying neutralization reactions. Background: Chemical changes are always accompanied by a change in energy‚ typically as heat. If the reaction releases heat (ΔH < 0) then the reaction is exothermic. If the reaction absorbs heat (ΔH > 0) then the reaction is endothermic. The quantity of heat is measured experimentally by having the reaction take place in an insulated container called a
Premium
Heat of Neutralization: Lab Report In part A of this lab I determined the heat capacity of a calorimeter made out of two Styrofoam cups nesting together with a cardboard top containing a hole in the middle. First I placed 50 mL of water in the calorimeter‚ waited five minutes for the water to reach equilibrium‚ and used the computer’s temperature instrument to record the final temperature of the system. Next I heated 50 mL of water in a 250 mL beaker until the water reached 43.1 C (approximately
Premium Sodium hydroxide Thermodynamics Enthalpy
Heat of Neutralization for an acid-base reaction Contents: - Abstract - Introduction - Results and Discussions - Conclusion - References Abstract: In the experimental procedure we will measure the heat of neutralization when an acid and base react to form 1 mole of water. This quantity of heat is measured experimentally by allowing the reaction to take place in a thermally insulated Styrofoam cup calorimeter. The heat liberated in the neutralization reaction will
Premium Acid Sodium hydroxide PH
PRACTICAL 15: DETERMINATION OF HEAT OF NEUTRALIZATION Data collection: |Reaction |Initial Temperature/°C (±0.25) |Final Temperature of Mixture/°C (±0.25) | | |Acid |Base | | |HNO3 + NaOH |28.00 |28.25 |34.50 | |HNO3 + KOH |28.25 |28.25 |34.00
Premium Sodium hydroxide Thermodynamics Acid
comparing the average amount of NaOH and HCl needed for Neutralization in each Condition 4. HCl + NaOH H2O + NaOH Already Balanced Conclusion: In Conclusion‚ the effect of increasing the volume of HCl‚ is that the amount of NaOH needed to neutralize HCl is the almost the initial volume of HCl. In Condition 2 Trial 2 the initial volume of HCl was 8.0 mL‚ the substance stayed pink at 16.0 mL‚ so the amount of NaOH needed for neutralization was 8.0 mL. In the other conditions and trials the
Premium Acid Sodium hydroxide Base
Measurement of the Heat of Neutralization of an Acid CHM 152IN CRN: February 5‚ 2000 I. Purpose of Experiment The purpose of this lab is to measure the heat released in the reaction of an acid and a base. This will demonstrate an enthalpy reaction‚ showing energy being released. II. Chemicals and Equipment The following chemicals and equipment will be utilized for the experiment: |Chemicals |Equipment
Premium Water Energy Chemical reaction
1- The reaction HCl + KOH KCl + H2O is a a. synthesis reaction c. neutralization reaction b. ionization reaction d. decomposition reaction 2- What is the value of the self-ionization constant of water? a. 0 c. 1.00 107 b. 1.00 1014 d. 55.4 3- Pure water contains a. water molecules only. b. hydronium ions only. c. hydroxide ions only. d. water molecules‚ hydronium ions‚ and hydroxide ions
Premium Water Oxygen Chemistry
Discussion Based on the results of the lab it can be seen that the metal in the lab can be identified as lead. The identity of the metal was determined by the heat energy calculations. The heat capacity that was found matched closely to that of the lead. There were several possible sources of error that could be found throughout the lab. Some of the main errors as seen in question 7 that could have affected the results of the lab were the amount of water transferred with the hot metal‚ the
Premium Heat Thermodynamics Specific heat capacity
Ten Minutes of Specific Heat Remi Adams East Rowan High School AP Environmental Science Abstract Specific heat and climate were the primary focus of this lab. Specific heat is defined as “the measure of the ability of a substance to change temperature”. The purpose for carrying out this lab was to determine the specific heat/rates of both soil and water‚ and then comparing them. Students also were to relate specific heat to climate. Students were to determine which substance expressed
Premium Specific heat capacity Heat Thermodynamics
In this lab‚ we will measure the heat of combustion‚ or calorimetry‚ of a candle and compare the found quantity with known values for other hydrocarbons. The calorific value is the total thermal energy released when a substance goes through complete combustion with oxygen. In order to achieve the purpose of this lab‚ we must first determine the mass of the tea candle. Then‚ we will determine our room temperature‚ measure about 100 mL of chilled water‚ and then pour the water into the given empty
Premium Water Temperature Oxygen