"I visual difference of hydrated and anhydrous alum" Essays and Research Papers

Sort By:
Satisfactory Essays
Good Essays
Better Essays
Powerful Essays
Best Essays
Page 2 of 50 - About 500 Essays
  • Good Essays

    Potash Alum

    • 294 Words
    • 2 Pages

    PREPARATION OF POTASH ALUM [(K2SO4.Al2(SO4)3.24(H2O) Aim: To prepare a pure sample of potash alum. [K2SO4.Al2(SO4)3.24H2O] Principle: Potash alum is prepared by dissolving an equi molar mixture  of aluminum sulphate and potassium sulphate in minimum  amount of water containing a little amount of sulphuric acid  and then subjecting the solution to crystallisation; octahedral  crystals of potash alum separate out.  Apparatus required: Beaker (100 ml)  Trough  Funnel  Wire gauze  Conical

    Premium Aluminium Alum Sulfuric acid

    • 294 Words
    • 2 Pages
    Good Essays
  • Satisfactory Essays

    AP Chemistry Analysis of Alum * Purpose: * In this lab we performed several tests to determine if our crystals were actually aluminum potassium sulfate. * Procedures: * Materials: * Chemicals: * Aluminum potassium sulfate‚ 2.5 g * Equipment – Part 1: * 150 mL beaker * Bunsen burner * 2 capillary tubes * Mortar and pestle * Notched stopper to hold thermometer *

    Premium Chemistry Water Alum

    • 1639 Words
    • 7 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Alum Ap Chemistry Lab

    • 480 Words
    • 2 Pages

    AP Chemistry Lab 2: Analysis of Alum Lab Objective: In this lab we will analyze alum by two techniques in order to verify its identity. The melting point and the mole ratio of hydrated water to anhydrous aluminum potassium sulfate will be determined. Lab Procedure: 1. Use a mortar and pestle to crush alum. 2. Pack the alum in capillary tube‚ and then fasten it to the thermometer. 3. Fasten the thermometer to the ring stand. 4. Immerse the bottom of the

    Premium Chemistry Water Oxygen

    • 480 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Hydrated Crystals Lab

    • 272 Words
    • 2 Pages

    Hydrated Crystals LAB PURPOSE: The purpose of this lab was to determine the percent of water in the given hydrate. MATERIAL/EQUIPMENT LIST: Crucible and cover Clay Triangle Crucible Tongs PROCEDURE: 1. First‚ the crucible and crucible cover were cleaned and dried. 2. The crucible and crucible cover were then placed on the clay triangle and heated with the Bunsen Burner for 3 minutes. 3. After this‚ the crucible and crucible cover

    Premium Mass Laboratory equipment Water

    • 272 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Hydrated Crystals Lab Pre-Lab Questions Observations of hydrated MgSO4 | Shiny‚ clear‚ chunks of crystals‚ white | Mass of crucible and lid | 11.36 grams | Mass of crucible‚ lid‚ and hydrated MgSO4 | 14.38 grams | Mass of hydrated MgSO4 | 3.00 grams | Mass of crucible‚ lid‚ and anhydrous MgS04 | 12.82 grams | Mass of anhydrous MgSO4 | 1.45 grams | Mass of water in hydrated MgSO4 | 1.55 grams | Moles of anhydrous MgSO4 | 0.0120 moles | Moles of water in hydrated MgSO4 |

    Premium Water Mass

    • 451 Words
    • 2 Pages
    Satisfactory Essays
  • Powerful Essays

    Preparation of Potash Alum

    • 1260 Words
    • 6 Pages

    Preparation of Potash Alum A PROJECT REPORT SUBMITTED TO CHEMISTRY DEPARTMENT DIST: AMRELI GUJARAT BY:-ANURAG AGARWAL ROLL NO: XII SCI. 2009-2010 PRINCIPAL                                INTERNALEXAMINER EXTERNAL EXAMINER CERTIFICATE Certificate This is to certify that this project work is submitted by ANURAG AGARWAL to the Chemistry department‚ Aditya Birla Public School‚ Kovaya was carried out by him under the guidance & supervision during academic year 2008-2009

    Premium Aluminium Alum

    • 1260 Words
    • 6 Pages
    Powerful Essays
  • Satisfactory Essays

    Analysis of Alum 1

    • 277 Words
    • 2 Pages

    Analysis of Alum AlK(SO4)2*12H2O: Determining the Melting Point and Water Hydration PreLab Questions: 1. When measuring the melting point‚ it is best to heat up the sample slowly so that the alum sample would be the same temperature as the water. The sample also needs time to melt. 2. 0.787g Na2CO3 1.336g H2O Moles of Na2CO3 = 0.787/106 = 0.00742moles Moles of H2O = 1.336/18 = 0.0742 Molar Ratio = 10 moles of H2O‚ 1 moles of Na2CO3 Abstract: The purpose

    Premium Water Alum Chemistry

    • 277 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Analysis of a Hydrated Crystalline Compound Katie Sanders Science Block 3 February 29‚ 2012 Title: Analysis of a Hydrated Crystalline Compound Purpose: The purpose of our experiment was to determine the amount of water in copper sulfate pentahydrate expressed as a percent. Hypothesis: I think that bluestone crystals are 20% water‚ because it’s called pentahydrate (penta means five) and 1/5 of 100 (since it’s expressed as a percent)

    Premium Mass Copper Sulfuric acid

    • 592 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    How To Stay Hydrated

    • 337 Words
    • 2 Pages

    As the weather gets warmer‚ staying hydrated should be a top priority. While water is the preferred method for staying hydrated in the heat for many people‚ it is not the only option. If you or your kids do not like drinking straight water‚ or if you want to add some variety to your hydration routine‚ consider implementing some tasty alternatives. Watermelon Watermelon is over 90 percent water‚ making it a great hydration option. It can be cut into slices and eaten. It can be blended up and made

    Premium Nutrition Health Obesity

    • 337 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Analysis of Alum‚ AlK(SO₄)₂ •12H₂O Purpose The purpose of the experiment is to confirm whether the compound is Alum. Introduction Percent composition is defined as part divided by whole multiplied by 100. Water of hydrogen is defined as the amount of water produced into a molecule prepared in an aqueous solution. Molecular formula indicates the actual numbers and type of atoms in a molecule (notes). Procedure The procedure in this experiment is to determine melting point and mole ratio of

    Premium Chemistry

    • 275 Words
    • 2 Pages
    Satisfactory Essays
Page 1 2 3 4 5 6 7 8 9 50