"Introduction for molar solubility and common ion effect" Essays and Research Papers

Sort By:
Satisfactory Essays
Good Essays
Better Essays
Powerful Essays
Best Essays
Page 9 of 50 - About 500 Essays
  • Good Essays

    larity------------------------------------------------- Names: Benjamin Fischmann ------------------------------------------------- ------------------------------------------------- ------------------------------------------------- What is the Molar Concentration (Solute concentration) of a Potato? ------------------------------------------------- ------------------------------------------------- ------------------------------------------------- Design -------------------------------------------------

    Premium Management Cost Marketing

    • 1061 Words
    • 5 Pages
    Good Essays
  • Satisfactory Essays

    Molar Mass Lab

    • 478 Words
    • 2 Pages

    09/17/13 Che 102L Lab # 4 Molar Mass by Freezing Point in Anti-Freeze. Objective: to determine the freezing point of pure naphthalene‚ determine the molar mass of an unknown by measuring the freezing point depression of a solution of the unknown in naphthalene. Materials: Beakers 600 mL‚ 2-250 mL‚Crystal Ice‚20 g of NaCl‚Stirring Rod‚Thermometer‚Foil‚ Water‚ 10 mL‚ Cylinder‚ 25 mL 100 mL Dropper‚ 2 Test Tubes. Procedure: Filled 600 mL beaker with ice‚ took temperature until it got

    Premium Chemistry Liquid Water

    • 478 Words
    • 2 Pages
    Satisfactory Essays
  • Better Essays

    Kno3 Solubility Lab

    • 1194 Words
    • 5 Pages

    the effect of the addition of increasing concentrations of a miscible liquid (ethanol) on the solubility of KNO3 in water. The results of the investigation support the hypothesis that water‚ which exhibits greater polarity‚ is able to dissolve a greater mass of KNO3 at lower temperatures compared to tested concentrations of Ethanol ranging from 12.5% to 30%. Furthermore‚ the results of the graph 1 show correspondence to the dielectric constant of each solvent as both the starting solubility of the

    Premium Chemistry Water Solubility

    • 1194 Words
    • 5 Pages
    Better Essays
  • Good Essays

    1 Solutions and Solubility Chapters 4+13 2 The Solution Process • A solution is a homogeneous mixture of solute (present in the smallest amount) and solvent (present in the largest amount) State of Solution State of Solvent State of Solute Example Gas Gas Gas Air Liquid Liquid Gas O2 in water Liquid Liquid Liquid Alcohol in water Liquid Liquid Solid Salt in water Solid Solid Gas H2 in Pd Solid Solid Liquid Hg in Ag Solid Solid Solid Ag in Au 3 The Solution Process

    Premium Solubility Solvent

    • 717 Words
    • 8 Pages
    Good Essays
  • Better Essays

    DETERMINATION OF THE SOLUBILITY PRODUCT CONSTANT OF CALCIUM HYDROXIDE ABSTRACT This experiment aimed to determine the solubility product constant (Ksp) of Ca(OH)2 as well as to evaluate the effects of common and non-common ions on its solubility. Ca(OH)2 solids were dissolved in eight various media: distilled water‚ 1.0 M KCl‚ 0.5 M KCl‚ 0.1 M KCl‚ 0.05 M KCl‚ 0.005 M KCl‚ 0.001 M KCl‚ and 0.1 M Ca(NO3)2. The concentration of dissociated OH- concentrations was determined by means of titrimetric

    Premium Solubility Chemical equilibrium Chemistry

    • 2848 Words
    • 12 Pages
    Better Essays
  • Good Essays

    Solubility Lab Report

    • 401 Words
    • 2 Pages

    In part 1 the results of the solubility do not agree with the with rules of solubility most likely because we put too much solid in the test tubes and not enough water to dissolve it. They should have dissolved because the anything with nitrate should be soluble. With the pH‚ when the mixture where compared with the chart all of them except NaCl where a shade of blue which means that they have a pH of 8-14‚ depending on the darkness of the shade‚ meaning that they are a basic solution. When reacting

    Premium Chemistry Water Acid

    • 401 Words
    • 2 Pages
    Good Essays
  • Good Essays

    Solubility and Test Tube

    • 1362 Words
    • 6 Pages

    082 g/mL | Irritant (eyes/skin). Toxic by inhilation‚ Flammable (fp 49 ºC). | Discussion: Recrystallization is a widely-used technique to purify a solid mixture. The desired product is isolated from its impurities by differences in solubility. Insoluble impurities and colored impurities can be removed from hot solvent through the use of activated carbon and filtration. Soluble impurities remain in the cold solvent after recrystallization. The desired product should be as soluble as

    Premium Solubility Acetic acid Solvent

    • 1362 Words
    • 6 Pages
    Good Essays
  • Good Essays

    dissolved. Water is the most common liquid solution. Many things can be dissolved in it. Table salt is an example of a solid dissolved in a liquid. A liquid and a gas can also be dissolved in a liquid solution. c. Solid Solution- is a mixture of solids spread equally throughout one another. Metal is an example of a solid solution at room temperature. 3. Solubility is the ability of one compound to dissolve in another compound. 4. a. Temperature - Basically‚ solubility increases with temperature

    Premium Solution Solubility Solvent

    • 435 Words
    • 2 Pages
    Good Essays
  • Good Essays

    Important Ions in the Body and the Roles They Play Everyday Functions of the Human Body The human body uses many forms of energy to conduct daily activities. These activities can be ones that we are doing physically or they can be as basic as the breakdown of enzymes within our body or the digestion of food. Chemical energy‚ electrical energy‚ mechanical energy‚ and electromagnetic energy are a few but important forms of the type of energy utilized by the human body. Ions play an important

    Premium Electric charge Ion Electron

    • 781 Words
    • 4 Pages
    Good Essays
  • Good Essays

    Aims The aims of this investigation are: 1. To find the rate equation of the reaction of hydrogen peroxide and iodide ions. This will be achieved by using an iodine clock method and colorimetric analysis. 2. Draw a graph of rate against concentration for each reactant (Hydrogen peroxide‚ potassium iodide and H+ ions). 3. Finding the order for each reactant 4. Finding the rate-determining step. 5. Proposing a mechanism for the reaction. 6. Using Arrhenius’ equation to find the activation

    Free Chemical reaction Chemical kinetics

    • 1987 Words
    • 8 Pages
    Good Essays
Page 1 6 7 8 9 10 11 12 13 50