of the Enthalpy of an Acid-Base Reaction Abstract The purpose of this lab was to first‚ determine the specific heat capacity of a homemade calorimeter‚ and second‚ to calculate the enthalpy of reaction for an acid-base reaction between 6M KOH and 6M HNO3. To determine the specific heat capacity of the calorimeter‚ two differing temperatures of water were measured and volume was measured and mixed within the calorimeter. The enthalpy of reaction for an acid-base reaction was found by these steps:
Free Thermodynamics Enthalpy Heat
Investigation into How the Concentration of a Reactant Can Affect the Rate of Reaction Aim To plan an investigation that allows me to measure the effect of increasing the concentration of a reactant on the rate of reaction. With the results generated‚ it is also hoped to draw accurate conclusions and explain the results using scientific knowledge. Introduction Some reactions are fast‚ for example neutralisation or burning magnesium in air to produce magnesium oxide. However‚ other reactions can be slow
Premium Chemical reaction
LAB 6. ACIDS AND BASES: PH AND BUFFERS PURPOSE: To determine the pH of common acids and bases using a pH meter‚ pH paper‚ and red cabbage indicator. To test the effect of adding an acid or base to a buffer solution. SAFETY CONCERNS: Always wear safety goggles. Wash with soap and water if skin contacts acids or bases. ACIDS: An Acid is a substance that when dissolved in water will produce hydrogen ions‚ H+‚ in the solution. An acid that does not contain carbon is called an inorganic
Premium PH Acid
Determination of the Concentration of Acetic Acid in Vinegar Lab Exercise 4 CHEM 1106 9/19/12 Purpose: Standardize a sodium hydroxide solution using a primary standard acid. Determine the molarity and the percent by mass of acetic acid in vinegar by titration with the standardized sodium hydroxide solution. Introduction: Vinegar is a dilute solution containing acetic acid. Since vinegar has a low pH‚ it can be titrated with a base. Titration is a method used in order to ascertain
Premium Acid Acetic acid PH
react with hydrochloric acid; and 1 cm3 of element X has a mass of 1.8 grams. Is element X a metal or non-metal? Give the reasons for your answer. Element X is most likely a typical non-metal. First of all‚ element X melts in boiling water; non-metals typically have low melting and boiling points. Furthermore‚ element X is unable to react with hydrochloric acid. This greatly indicates that element X is a non-metal as most non-metals fail to react with hydrochloric or dilute acids. In order
Premium Chemical element Copper Aluminium
How Acid Rain Affects Organisms in Aquatic Biomes Through the advancement of technology‚ the issue of the air surrounding the earth might have been one of the most often matters to be brought up and discussed among scientists and engineers. Acid rain is one of the more serious environmental problems and it is closely related to the air pollution. Nowadays‚ it has affected large part of US‚ Europe and Canada. People start to be concerned about acid rain since it is getting worse in the passed
Premium Acid rain PH Carbon dioxide
mass of Calcium carbonate in an egg shell Aim: is to find and work out the percentage of calcium carbonate by mass in eggshells by using acid base “back titration” Introduction: Calcium Carbonate‚ CaCO₃‚ is a compound which is polymorphic and therefore means that it can be found in a variety of different objects or organisms. For example: Rocks (limestone‚calcite)‚ sea snail shells‚ Eggshells‚ pearls and many more. This investigation will focus on finding out the percentage mass of calcium carbonate
Premium Sodium hydroxide Calcium carbonate Titration
the reaction of butanols with hydrobromic acid. Before the lab began we discussed and proposed mechanisms. (see “Mechanisms”) To begin this experiment we calculated how much of each material we were going to be using‚ and the numbers we chose to use differed from our reference text slightly. We used 6.5 mL of our assigned butanol and only 4 mL of sulfuric acid. Going back to our reaction mechanisms‚ we were looking at SN1 and SN2 reactions‚ so we of course used the hydrobromic acid as our acid catalyst
Premium Alcohol Chemistry Hydrochloric acid
Investigating Stoichiometry with Carbonic Acid Salts Problem: Testing the actual yield versus the theoretical yield of NaCl when HCl is titrated into Na2CO3 and NaHCO3. When 0.15g of both NaHCO3 and Na2CO3 are titrated with HCl‚ then 0.165g of NaCl should form from the NaHCO3‚ and 0.104g of NaCl should form from the 0.15g of Na2CO3. Procedure: Weigh 2 samples of 0.15g of dried unknown each‚ and dissolve each into 50mL of distilled water. Add 0.5 to 1mL of bromocresol green indicator until the
Premium Evaporation Water
Experiment 7 Investigating Stoichiometry with Sodium Salts of Carbonic Acid Introduction: The student will perform the experiment in order to find the percent yield by using the theoretical value found using the balanced equation for sodium carbonate as well as sodium bicarbonate. The objective is to stabilize the substances by titrations and finding the percent yield when all the data is collected. The purpose of this procedure is so that the student will get better understanding of stoichiometry
Premium Hydrochloric acid Sodium carbonate Sodium