25 April 2000 NAME 1. [10 points] What are the concentrations of HSO− ‚ SO2− ‚ and H+ in a 0.20 M KHSO4 solution? (Hint: 4 4 H2 SO4 is a strong acid; Ka = 1.3 × 10−2 for HSO− .) 4 2. [15 points] Calculate the pH of 1.00 L of the buffer 1.00 M CH3 COONa/1.00 M CH3 COOH (pKa = 4.74) before and after the addition of (a) 0.080 moles NaOH and (b) 0.12 moles HCl. (Assume there is no change in volume). 3. [10 points] The following reaction is found to be first order in A: A −→ B + C If half
Premium Acid dissociation constant Enzyme inhibitor Chemical kinetics
The rate of a chemical reaction is the measure of change in concentration of the reactants of the change in concentration of the products per time. The rate of a chemical reaction is influenced by the concentration of the reactants‚ temperature‚ and the presence or absence of a catalyst. Through finding the time and concentrations of the reactants‚ it is possible to find the rate of reaction and k. To perform this experiment‚ you need two erlenmeyer flasks‚a timer‚ a LabQuest with a temperature
Premium Chemical reaction Reaction rate Chemistry
The Effect of pH on Enzymatic Reaction Rate Abstract Enzymes are affected by changes in pH. The most favorable pH value— the point where the enzyme is most active—is known as the optimum pH. This experiment was conducted to determine the effect of pH reaction rate on an enzyme‚ catalase‚ from yeast. The experimental results indicate that the catalase worked best at a neutral pH level of seven (7). Introduction An enzyme is a protein molecule that serves as a catalyst. “The basic function of
Premium Enzyme Chemical reaction Catalysis
An investigation in to the rate of reaction Plan: I am going to investigate the rate of reaction. The reaction I will be using is: Calcium Carbonate + Hydrochloric acid ---- Calcium Chloride + water + carbon dioxide. CaCO3 + 2HCl ---- CaCl +H2O + CO2 Measurements and Variables: The variables I have chosen to change is strength of the hydrochloric acid which will be 1 mole‚ 0.7 mole‚ 0.5 mole‚ 0.3 mole and 0.1 mole some variable I will not be using are temperature‚ mass‚ density. The measurements
Premium Chemical reaction Reaction rate Chemistry
Title: Finding the Ratio of Mole of Reactants in a Chemical Reaction Purpose of Lab: To find the coefficients of two chemical reactants that appears in a balanced chemical equation using the continuous variations method. Pre Lab Questions: 1. 2AgNO3(aq) + K2CrO4(aq) → 2KNO3(aq) + Ag2CrO4(s) 2. There is enough to make a valid conclusion because‚ on the graph‚ one can clearly see that the two lines intersect. Thus‚ one can also determine the mole ratio. The mole ratio is approximately
Free Chemical reaction Ratio Stoichiometry
Erin Bolton Chemistry Lab Report April 29‚ 2015 Lab: Reaction Rates Introduction: In this experiment we studied the reaction of potassium persulfate‚ K2S2O8‚ with potassium iodide‚ KI. All chemical reactions have an energy barrier to overcome before the reaction will proceed. We will record data based on the concentration‚ temperature and catalyst for each experiment. Once this has been completed it will be graphed. Procedure: Due to the chemicals being used having hazard gloves are used
Premium Chemistry Chemical reaction
does‚ however‚ absorb energy as bonds are being broken to dissociate the weak acid. CH3COOH H+(aq) + CH3COO-(aq) approx 99% approx 1% Conductivity Any solution’s ability to conduct electricity is conditioned by the concentration of ions it contains. A strong acid has more ions than a weak one‚ and so it’s solution will be a better electrical conductor than a weak acid. The same goes for strong/weak bases. The conductivity may be measured using a power pack and two graphite
Premium Hydrogen Acid PH
relationship between the concentration of the hydrochloric acid and the rate of a reaction. To find this out I will react different concentration of hydrochloric acid and magnesium‚ from there I will monitor the gas (hydrogen) produced and analyse the results. Prediction: I predict the higher the molarity of the hydrochloric acid the faster the rate of reaction therefore the quicker the gas will be produced in the specific time interval. Overview of the experiment: In this reaction two substances
Free Chemical reaction Chlorine Hydrogen
An Investigation on the rate of reaction of the enzyme Catalase on the substrate Hydrogen peroxide. Plan Aim: To investigate the rate of the effect of Catalase on hydrogen peroxide. Introduction This investigation will be carried out to investigate the rate of reaction of the enzyme catalase on the substrate hydrogen peroxide. Enzymes are biological catalysts‚ which speed up the rate of reaction without being used up during the reaction‚ which take place in living organisms. They do this by
Premium Enzyme Catalysis
Aim: The rate at which a reaction occurs‚ or takes place‚ is affected by various factors‚ such as the temperature at which the experiment is conducted in‚ the pressure which is given‚ the surface area which is exposed‚ use of catalysts‚ and the concentration. In this investigation‚ I would be investigating the affect of surface area‚ or particle size‚ in the rate at which a reaction occurs. Background Information: The more finely divided the solid is‚ the faster the reaction happens. A powdered
Premium Chemical reaction Hydrogen Magnesium