LS Separation of Mixtures and Solids Purpose: To become familiar with the separation of mixtures of solids Hypothesis: I will be able to separate the materials using a variety of different methods. First‚ separate the iron fillings using a magnet. Second‚ I will put the rest of the solution into water and separate the insoluble sand from the soluble salt and benzoic acid. Third‚ I will filter out the benzoic acid when crystalized. Lastly‚ I will evaporate the water away leaving crystallized
Premium Water Sodium chloride
Ocean county college | SEPERATION OF A MIXTURE OF SOLIDS | DEPARTMENT OF CHEMISTRY | | John Curran | 2/23/2013 | COURSE INSTRUCTOR DR. NANCY MARASHI. | Background: During this experiment students will take a mixture and separate it into its’ pure substances. A mixture is a combination of two or more substance. These substances cannot be combined chemically but more physically. The pure substances are substances that cannot be separated any more by physical means. The students
Premium Water
Separation of a Mixture of Solids I really enjoyed this lab. After reading the introduction I started by making my own flow sheet of how I thought this lab would work. I was reminded about solubility which is defined as the amount of the solute that will dissolve in a given amount of solvent and that the extent to which a substance dissolves depends mainly upon the physical properties of the solvent and of the solute and to some extent upon the solvent’s temperature. With that being said I came
Premium Solubility Oxygen Solvent
Title: Separation of a Mixture of Solids Purpose: Learn and demonstrate how to separate different ingredients from a mixture of solids using different methods based on the properties of each ingredient. Procedure: I weighed mixture and tools‚ and proceeded to begin separating each ingredient. I used a magnet to separate the iron from the mixture. Then I heated the mixture in water to get the non-soluble sand out. Then I filtered out the benzoic acid after cooling it into a crystal form
Premium Water Evaporation
Lab 2 “Separation of a Mixture of Solids Lab Report Assistant (10 points) Data Table 1: Experimental Data Grams Percent of mixture Iron (Fe) fillings 0.9 g 20 % Sand 1.2 g 25 % Table salt 1.6 g 25 % Benzoic acid .8 g 16 % Total 4.5 g 86 & Questions A. How did your proposed Procedures or flow charts at the beginning of this experiment compare to the actual Procedures of this lab exercise? (2 points) I proposed a magnet would be the used to remove the iron from
Premium Water Separation process Distillation
experiment introduces magnetism‚ evaporation and filtration as ways to separate mixtures. Temperature when soluble Sand N/A Iron N/A Sodium Chloride 400F Benzoic Acid 100F Experiment and Observation After gathering all the material needed to conduct these experiments‚ the first experiment was initiated. The mixture of solids was weighed out as well as the 10cm square piece of paper and the weighing dish. The mixture was spread out in a very thin layer on a piece of paper‚ the magnet was
Premium Water Salt Filter paper
Title: Lab #3 Separation of a Mixture of Solids Purpose: To understand the different separation methods and techniques that depend on the chemical properties of a specific substance. Also to become more comfortable with performing those actions of separation so I have them in the future. For this experiment‚ I will separate a mixture of four distinct substances: sodium chloride‚ benzoic acid‚ silicon dioxide‚ and iron fillings into pure beings. Procedure: Materials: distilled water coffee
Premium Water Mass Weight
Separation of the Components of a Mixture Purpose: To become familiar with the methods of separating substances from one another using decantation‚ extraction‚ and sublimation techniques. Apparatis and Chemicals: balance‚ Bunsen burner‚ rubber hose‚ tongs‚ 2 evaporating dishes‚ 2 watch glasses‚ 100-mL graduated cylinder‚ clay triangles‚ 2 ring stands‚ 2 iron rings‚ 2 glass stirring rods‚ unknown mixture of NaCl‚ NH4Cl‚ SiO2. Discussion: Mixtures are composed of two or more substances
Premium Mixture Separation process Chemical substance
Separation Techniques If one component of the mixture has magnetic properties‚ you can use a magnet to separate the mixture. Cobalt‚ iron and nickel all have magnetic properties. Note that not all metals are magnetic and magnetism is not a method to separate metals from non-metals. Gold‚ silver and mercury are examples of non-metal substances. Magnetism is however a way to separate magnetic substances from non-magnetic substances is. Magnetism as a separation method is done by taking any magnetic
Premium Evaporation Distillation Magnetism
Samantha Smith Organic Chem 255 Lab M/W 12:30-4:30 Hyejin Cho 12 June 2013 Separation of a Mixture Abstract: In this experiment‚ the three processes of extraction‚ sublimation and recrystallization will be used to separate a mixture of salicylic acid and naphthalene. The first part of extraction will be to separate the salicylic acid from the naphthalene using diethyl ether and aqueous sodium bicarbonate. The naphthalene will reside in the ether and be the top layer‚ while the
Premium Separation process Chemistry Chemical substance