Title: Liquid Chromatography Author: Gloria Contreras Lab Partner: Jose Montanez Instructor: Teresa Potter Date Work Performed: January 13‚ 2015 Date Submitted: January 20‚ 2015 Abstract: In this lab‚ liquid chromatography is used to separate the Red 40 and Blue 1 dyes inside of grape flavored Kool-Aid. It was determined that the 5% isopropanol will remove the Red 40 dye from the stationary phase. The 28% isopropanol will remove the Blue 1 dye from the stationary phase. The more
Premium Chromatography Solubility Chemical polarity
The purpose of this lab is to identify the physical and chemical properties of four liquids: acetone‚ vinegar‚ hydrogen peroxide‚ and oil. By using our knowledge about the four liquids we needed to identify the components of an unknown mixture. Theoretical Background The liquids commonly found around the house such as acetone‚ vinegar‚ hydrogen peroxide‚ and oil was tested to identify the physical and chemical properties of these liquids. Acetone usually used as nail polish remover dissolves plastic
Premium
2:05 P.M. Purpose: The purpose of the experiment is to measure the densities of liquids. Specifically‚ the two liquids that were used and measured in the research were deionized water (H2O) and alcohol (C2H5OH). Methods: Density is an intensive quantity that cannot be visually identified. Therefore‚ the most straightforward approach to this problem was to record the measurements of mass and volume. For volume of each liquid‚ the instruments used were a 50ml burette‚ a 50ml graduated cylinder and a 10ml
Premium Water Volume Density
Experiment 5 Liquids and Solids Chemistry 1211 Fall 2012 Section 1: Abstract‚ Experiment and Observation Abstract: The purpose of this experiment is to determine the boiling point of a liquid and the melting point of a solid. We also were able to observe the difference between boiling and melting point Experiment and Observation: We used isopropyl alcohol and set up an experiment to observe the boiling point. We set up a second experiment using acetamide to determine
Premium Temperature Gas Liquid
FE 106 GENERAL CHEMISTRY EXPERIMENT-1 DENSITY OF LIQUIDS PREPARED BY BURAK COBAN PURPOSE: In this experiment we will learn how can we find the density of liquids and liquids of density how change effect of temperature‚ pressure‚ mass‚ volume and concentration. For this reason we will take NaCI solutions with different concentrations and we will measure their densities‚ so we will find out the effects of concentration on density of solutions. THEORY:
Premium Density Liquid Volume
A safety audit for the gas-solid fluidization experiment was conducted. The following safety concerns were found when performing the audit: operating beyond the operating limits‚ spillage of the beads‚ risk of head injury from bending over to change the beads in the apparatus or from the low bar‚ and congestion of the workspace. One of the biggest safety concerns with this lab involved the small glass beads that acted as the solid in the experiment. If the gas flow rate goes below 50 standard cubic
Premium Glass Risk Causality
between specific limits moisture contents. Below these levels they have a solid consistency and above a liquid consistency. Therefore‚ the soil has two important properties to be analyzed‚ the Liquid Limit (LL) and the Plastic Limit (PL). The Liquid Limit is the moisture content that makes the soil has a liquid behavior. The Plastic Limit is the moisture content below which the soil becomes from the plastic state to the semi-solid state‚ which means it loses the ability to be shaped and starts to become
Premium Soil Water Aquifer
Liquid Chromatography – Laboratory #18 Introduction: We are using liquid chromatography to separate the colored substances in grape-flavored drinks. We separate the component dyes‚ and then we separate the flavorings and citric acids. Background: Chromatography is a process that is used to separate a substance into its component parts. The separation occurs between the stationary and moving phase of the lab. The moving phase consists of a fluid and the stationary phase consists of a solid
Premium Chromatography Gas chromatography Analytical chemistry
Laboratory #16: Analysis of Grease in Water by Solvent Extraction Experiment Date: 2/19/10 Due Date: 2/26/10 II. Objective The goal of this lab was to determine the amount of impurity‚ in the form of oil‚ in water using the method of solvent extraction‚ also known as liquid-liquid extraction‚ a method of separating two materials with different physical and/or chemical properties. Two methods of evaporation will be used to finally determine the concentration of impurity- one using an explosion-proof
Premium Water Distillation Solvent
Look at these pictures. Label them as solid‚ liquid or gas. Use them to help you cross out the wrong information in the table below so you are left with only the correct information. solid liquid gas Extension: Using your table above‚ explain the following a) Why does a solid have a fixed shape? A solid has a fixed shape because the particles are very close together and arranged in strong regular lines although they vibrate the particles are so packed together
Premium Gas Liquid Solid