larity------------------------------------------------- Names: Benjamin Fischmann ------------------------------------------------- ------------------------------------------------- ------------------------------------------------- What is the Molar Concentration (Solute concentration) of a Potato? ------------------------------------------------- ------------------------------------------------- ------------------------------------------------- Design -------------------------------------------------
Premium Management Cost Marketing
Angela Pierre Chem 112 Lab Due: 03/05/2015 Lab Report 14 Questions 1. Part A.3. Some of the cyclohexane solvent vaporized during the temperature versus time measurement. Will this loss of cyclohexane result in its freezing point being recorded as too high‚ too low‚ or unaffected? Explain. -The freezing point will be higher because the loss of solvent means that the molarity of solute is too high. The melting point will be lower than expected. 5. Part B.2. The solute dissociates slightly in the
Free Melting point Chemistry Solution
Title: Physical and Chemical Properties Purpose: To investigate the physical and chemical properties of pure substances as distinguishing characteristics. Procedure: 1. Set up a well plate with 24 pieces and fill two with either Dilute HCl or Dilute NaOH. 2. Set up four test tubes with any single substance in each one. 3. Observe and record original color and odor of substance. 4. Light flame with matches. -Hold test tube with substance in it over flame with clamps -Observe and record
Premium Chemistry Sodium hydroxide Base
CHEMICAL CHANGES IN THE LARGE INTESTINE AND DETOXICATION • After digestion and absorption in the small intestines‚ the semi liquid residue is passed into the large intestines. • There are no enzymes to act on the residues in the large intestines. • Only a very small amount of viscous‚ slightly alkaline fluid containing large amount of mucin is contributed by the mucosal cells of the colon. • There are normal intestinal microorganisms which disintegrate the organic residues into
Premium Carboxylic acid Amino acid Acetic acid
Chemistry 1110 Molar Mass of Butane Materials * Butane Lighter * Plastic Tube * 100 ml Graduated Cylinder * 2 Thermometers * Barometer * Sink Full of Water Purpose The purpose of this experiment is to determine the molar mass of butane using Dalton’s Law of Partial Pressures and the ideal gas law. Hypothesis My hypothesis is that as we complete the experiment‚ we will be able to correctly use the air and water temperatures‚ volume of gas‚ and barometric
Premium Pressure Gas
Chemical Formulas and Chemical Compounds MIXED REVIEW SHORT ANSWER Answer the following questions in the space provided. 1. Write formulas for the following compounds: CuCO3 a. copper(II) carbonate Na2SO3 b. sodium sulfite (NH4)3PO4 c. ammonium phosphate SnS2 d. tin(IV) sulfide HNO2 e. nitrous acid 2. Write the Stock names for the following compounds: magnesium perchlorate a. Mg(ClO4)2 iron(II) nitrate b. Fe(NO3)2 iron(III) nitrite c. Fe(NO2)3 cobalt(II) oxide d. CoO nitrogen(V) oxide
Free Oxygen Nitrogen Carbon dioxide
Introduction: The purpose of this lab was to differentiate chemical changes from physical changes. During the separation lab we were given a test tube with Styrofoam‚ sand‚ salt‚ and Iron fillings in it‚ our goal was to issolate each component from the other. We were given certain tools and materials to help us figure out how to divide the components‚ therefore creating our lab. Doing this lab helped us figure out what component used physical change and which used chemical change‚ it also showed us which
Premium Water Chemistry Solubility
December 12‚ 2014 Determination of the Molar Mass of Volatile Liquids Theory: Molar masses‚ can be seen and used daily in chemistry. In this lab‚ the ideal gas law helps determine and evaluate the molar mass of gases and volatile liquids. The ideal gas law compares four properties of a gas which include pressure‚ volume‚ moles‚ and temperature. During this experiment‚ the moles would be unknown‚ in effect the student must use a substance mass divided by its molar mass. With this‚ the ideal gas law can
Premium Gas Water Ethanol
The overall purpose of the experiment is to observe the change of pressure as three different gases; N2‚ He‚ and an unknown gas effuses through a pinhole into a vacuum environment. Each gas has a different pattern of changing the pressure depending on its molecular mass‚ which is related to the kinetic theory of gases‚ where heavier gases (N2) effuse slower than lighter gases (He). The experiment setup was prepared‚ measurement of change of pressure as a function of time were recorded. After performing
Premium Pressure Chemistry Gas
on the test tube rack to observe the next day. A chemical reaction did occur in the lab. There were a color change and an odor change that was observed on Day 2 of the lab. On Day 1‚ the liquid was clear and the smell was very strong. On Day 2 of the lab‚ most of the liquid was gone but the color was a muddy color and the smell got milder‚ it wasn’t as strong as Day 1. Not only was there a color and odor change‚ there was also an energy change in temperature. After Day 1‚ the temperature increased
Premium Chemistry Chemical reaction Water