"Percent yield lab" Essays and Research Papers

Sort By:
Satisfactory Essays
Good Essays
Better Essays
Powerful Essays
Best Essays
Page 22 of 50 - About 500 Essays
  • Good Essays

    Lab Reports

    • 936 Words
    • 4 Pages

    Sample Short Lab Report By Charles M Borener Jr April 24‚ 2009 Kinetic Friction Experiment #13 Joe Solution E00123456 Partner - Jane Answers PHY 221 Lab Instructor – Chuck Borener Thursday‚ 11 AM – 1 PM Lecture Instructor – Dr. Jacobs Abstract In this experiment‚ we test factors which effect friction. We pulled a wood block across a surface to determine whether the surface area of the block or the type of surface effects friction. We found that the surface area of the block did not change

    Free Force Friction Mass

    • 936 Words
    • 4 Pages
    Good Essays
  • Powerful Essays

    Osmosis Lab

    • 3205 Words
    • 13 Pages

    (dialysis tubing). The experiment will show how molecules in solution move from areas of higher concentration to areas of lower concentration in the attempt to reach homeostasis in different circumstances. Introduction: The main purpose of this lab was to observe diffusion and osmosis. This is demonstrated using dialysis tubing and a combination of monosaccharaides‚ disaccharides‚ water (H20)‚ and sodium chlorine

    Premium Osmosis Chemistry Diffusion

    • 3205 Words
    • 13 Pages
    Powerful Essays
  • Good Essays

    Determining Percent of Water Crystallization and the Chemical Formula of a Hydrate Aim: To determine the percent water of crystallization and the chemical formula of a hydrate Materials * 400 ML beaker * Glass rod * 3 to 5 grams of hydrated copper (II) sulfate CuSO4 (crushed) * Bunsen burner * Spatula * Heating pad * Clamp and stand * Electronic balance Procedures Refer to Lab sheet Observations 1. The powder seems to be very bright and shiny before any heating 2.

    Premium

    • 612 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Hydrate Lab

    • 587 Words
    • 3 Pages

    Formula of a Hydrate Lab Design: Problem: What is the chemical formula for a hydrated copper (II) sulphate compound? Controlled Variable: The mass of hydrated copper (II) sulphate. Responding Variable: The mass of dehydrated copper (II) sulphate‚ mass of H2O Materials: Ones on the handout + Hot plate. Procedure: 1. Mass 3.00g of hydrated copper (II) sulphate using electronic balance 2. Measure the mass of a thin‚ crucible dish using electronic balance 3. Gently pour hydrated

    Premium Chemistry Water Molecule

    • 587 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    Pulley Lab

    • 869 Words
    • 4 Pages

    Kristen Sierman Lab Report: Experiment #7 Group #4 October 16th‚ 2012 Forces on a Pulley System A. Statement of the Problem The purpose of this lab was to address the following questions: how does the acceleration of a pulley system depend on the mass of the driving objects? And how does the acceleration of a pulley system depend on the mass of the driven object? To achieve this‚ a dynamic track was set up with a string attached to a cart. The string was part of a pulley system (the pulley

    Premium Force Classical mechanics Mass

    • 869 Words
    • 4 Pages
    Satisfactory Essays
  • Good Essays

    Penny Lab Report

    • 674 Words
    • 3 Pages

    IB Chemistry Experiment 4 Composition of a Post-1983 Penny Lab Report Background: Through the use of percent composition one can easily find out how much of a certain element is in a compound or an item such as a post-1983 penny. The experiment will be using HCl a strong acid to dissolve all the zinc inside the outer copper shell. The reaction follows as such; Zn+2HCLZnCl2+H2‚ but there will be no reaction with copper. The portion that will be measured is the mass of copper left after all of

    Premium Copper Zinc Hydrochloric acid

    • 674 Words
    • 3 Pages
    Good Essays
  • Better Essays

    Lab report

    • 979 Words
    • 4 Pages

    Acid Base Titration Purpose: The purpose is to calculate the molarity of a NaOH solution by titrating the base with 5mL of standard HCl solution in each trial. By adding the base with unknown molarity to the acid with 0.10M the molarity of NaOH can be calculated. The base‚ NaOH‚ helps bring the pH of the acid‚ HCl‚ closer to seven‚ which neutralizes it. When using the buret the amount of NaOH used is able to be determined. Then by writing a balanced chemical equation and using the titration

    Premium Titration Sodium hydroxide Acid

    • 979 Words
    • 4 Pages
    Better Essays
  • Good Essays

    Distillation Lab

    • 758 Words
    • 4 Pages

    For this to occur‚ a heterogeneous mixture has to be placed into a distiller‚ in this experiment a solution of 1:1 water and methanol was distilled. When distilling substances there are various methods of distillation that can be used. In this lab‚ simple and fractional distillation was used. The simple distiller is composed of a 100ml round bottom flask that is attached to: a 3-way adapter‚ thermometer‚ condenser and vacuum adapter. The apparatus is heated up by placing a powermeter at the

    Premium Distillation

    • 758 Words
    • 4 Pages
    Good Essays
  • Better Essays

    Salty Lab

    • 1730 Words
    • 7 Pages

    Salinity is the measure and concentration of all the salts dissolved in water. Usually measured in parts per thousand (ppt or )‚ ocean salinity is 35ppt and the average river water salinity is 0.5ppt or less (University of Rhode Island). Many factors go into salinity‚ making water salty. To name a few‚ salinity affects the environment through sediment from rocks washes into the ocean‚ evaporation of ocean water‚ and sea ice formation are known to increase the salinity of the ocean (NASA). It

    Premium Sodium chloride

    • 1730 Words
    • 7 Pages
    Better Essays
  • Powerful Essays

    Enzyme Lab

    • 1094 Words
    • 5 Pages

    Eilisha Joy Bryson MISEP Chemistry 512 – Jacobs Enzyme Catalyst Lab - Formal Report – August 8‚ 2007 ABSTRACT This investigation examined what would happen to the rate of an enzyme-catalyzed reaction if the concentration of substrate changed. We hypothesized that if the concentration increased‚ then the reaction rate would also increase. To test our question‚ we varied a combination of substrate and buffer‚ totaling 6mL‚ with a constant amount of 2 drops of catalyst. The enzyme catalyst

    Premium Chemical reaction Enzyme Chemistry

    • 1094 Words
    • 5 Pages
    Powerful Essays
Page 1 19 20 21 22 23 24 25 26 50