"Pins acceptable" Essays and Research Papers

Sort By:
Satisfactory Essays
Good Essays
Better Essays
Powerful Essays
Best Essays
Page 32 of 50 - About 500 Essays
  • Powerful Essays

    Sms Based Notice Bored

    • 1860 Words
    • 8 Pages

    International Journal of Emerging Technology and Advanced Engineering Website: www.ijetae.com (ISSN 2250-2459‚ ISO 9001:2008 Certified Journal‚ Volume 3‚ Issue 3‚ March 2013) SMS Based Wireless E-Notice Board Smt.M.Baby1‚ P.Harini2‚ Y.Eleena Slesser3‚ Y.Tejaswi4‚ K.Ramajyothi5‚ M.Sailaja6‚ K.Annie Sumantha7 1 Assistant professor‚ Dept of electronic &communications Engineering‚ BWEC‚ AP‚ India. 2‚3‚4‚5‚6‚7 Student‚ Dept of electronic &communications Engineering‚ BWEC‚ AP‚ India. 2. By interfacing

    Premium GSM Subscriber Identity Module Mobile phone

    • 1860 Words
    • 8 Pages
    Powerful Essays
  • Powerful Essays

    Investmnet Casting

    • 1852 Words
    • 8 Pages

    Failure of Knuckle Joint in Tractor with Trolley‚ Design and Make Better Knuckle Joint A SEMINAR REPORT Submitted by SORATHIYA GHANSHYAM D. In fulfilment for the award of the degree of BACHELOR OF ENGINEERING in MECHANICAL ENGINEERING GOVERNMENT ENGINEERING COLLEGE‚ BHAVNAGAR‚ GUJARAT TECHNOLOGICAL UNIVERSITY‚ AHMEDABAD December‚ 2011 GOVERNMENT ENGINEERING COLLEGE‚ BHAVNAGAR‚ MECHANICAL ENGINEERING 2011 CERTIFICATE Date: 13-12-2011 This is to certify

    Premium Tensile strength Force Mechanical engineering

    • 1852 Words
    • 8 Pages
    Powerful Essays
  • Satisfactory Essays

    Robotics

    • 1135 Words
    • 5 Pages

    Goal of Project To develop an automated vehicle that would follow black electrical tape lines placed on the Austin lab floor. Features of Controller I am using the clocks‚ I/O pins‚ and ADC10 on the MSP430G2231 Chip. This chip is attached to the Launchpad board. The MSP430G2231 chip can be powered from 1.8V to 3.6V‚ has a 16-Bit RISC Architecture‚ and can handle clock rates of to 16MHz. It also has a 16 bit timer‚ and a 10-Bit 200ksps A/D converter. Hardware Design Schematic: OPB742 Emitter

    Premium Electric motor Sensor Microcontroller

    • 1135 Words
    • 5 Pages
    Satisfactory Essays
  • Good Essays

    Voting Machine

    • 1534 Words
    • 7 Pages

    (Department of electronics engineering) RIZVI COLLEGE OF ENGINEERING BANDRA (WEST)‚ MUMBAI-400050 UNIVERSITY OF MUMBAI ACADEMIC YEAR 2012-13 FOR THE FULFILLMENT OF THE PROJECT (TE) ELECTRONIC WORKSHOP (EWS) LCD BASED VOTING MACHINE USING 8051 AND VENDING MACHINE A project report Submitted by NIKITA MUDRAS TRUPTI LIMBAD SABERA YASMIN UNDER THE GUIDANCE OF PROF. PRASAD DHURI PROF. SOHAIL SIDDIQUI RIZVI COLLEGE OF ENGINEERING‚ RIZVI

    Premium Liquid crystal display Pixel Display resolution

    • 1534 Words
    • 7 Pages
    Good Essays
  • Powerful Essays

    Personality Theories

    • 1637 Words
    • 7 Pages

    Personality Theories – Ch. 12 Assigned Readings: pg. 20‚ “Social Psychology & Cross-Cultural Psychology”; 383‚ “Revealing Who We Really Are”; pg. 398‚ “Murray’s Personological Approach”; pg. 407‚ “Can Personality Change”; pgs. 414 – 415‚ “The Type A/ Type B Behavior Pattern” I. Personality (pgs. 384) - an individual’s unique and relatively _______________ patterns of behavior‚ thoughts‚ and emotions; consistent behavioral traits; general style of interacting with the world A. Urich

    Premium Psychology Maslow's hierarchy of needs Sigmund Freud

    • 1637 Words
    • 7 Pages
    Powerful Essays
  • Powerful Essays

    carrier using an RF or an IR transmission medium. They compare the serial input data three times continuously with their local addresses. If no error or unmatched codes are found‚ the input data codes are decoded and then transferred to the output pins. The 212 decoders are capable of decoding information that consists of N bits of addresses and 12-N bits of data. For a valid transmission‚ the address bits of both encoder and decoder must be same. 434 MHz TX-RX modules: These 434MHz transmitter (TX)

    Premium Control theory Decoder Remote control

    • 1320 Words
    • 6 Pages
    Powerful Essays
  • Powerful Essays

    SMS Based Wireless E-Notice Board Abstract – In this technical paper sms based wireless e-notice board explains how to establish an effective and reliable communication between a mobile phone and a microcontroller using GSM modem. This GSM based e-notice board has various applications used in several domains including banks‚ stoke exchanges‚ traffic control‚ public advertisements‚ educational sector i.e.‚ in schools and colleges etc. In all the above mentioned applications we will use a GSM

    Premium GSM Subscriber Identity Module Mobile phone

    • 1486 Words
    • 6 Pages
    Powerful Essays
  • Good Essays

    cellphone base voting

    • 9154 Words
    • 37 Pages

    A MAJOR PROJECT ON CELL PHONE BASED VOTING MACHINE SUBMITTED IN THE PARTIAL FULFILLMENT OF REQUIRMENT FOR THE AWARD OF THE DEGREE OF BACHELOR OF TECHNOLOGY IN ELECTRONICS & COMMUNICATION ENGG. FROM KURUKSHETRA UNIVERSITY‚KURUKSHETRA SUBMITTED BY: GUIDED BY: NIKHIL (1705429) Prof. G.C. Lall HEMANT KUMAR (1705433) CO-GUIDED BY: PRIYANSHU CHAUHAN (1705439) Asstt. Prof. Vijay Lamba DEPTT. OF ELECTRONICS & COMMUNICATION ENGINEERING HARYANA COLLEGE OF TECHNOLOGY

    Premium Microcontroller Mobile phone Electronic voting

    • 9154 Words
    • 37 Pages
    Good Essays
  • Good Essays

    Pulse Monitor

    • 2157 Words
    • 9 Pages

    to the flow of blood. The photo-current is converted into voltage and amplified by operational amplifier IC LM358 (IC1). The detected signal is given to the non-inverting input (pin 3) and its output is fed to another non-inverting input (pin 5) for squaring and amplification. Output pin 7 provides detected heartbeats to pin 12 of the microcontroller. Preset VR1 is used for sensitivity and preset VR2 for trigger level settings. Microcontroller IC AT89C2051 (IC2) is at the heart of the circuit. It is

    Premium Heart rate

    • 2157 Words
    • 9 Pages
    Good Essays
  • Good Essays

    Clap switch project file

    • 327 Words
    • 2 Pages

    clap‚ output pin 3 of IC1 goes high and remains in this standby position for the preset time. Also‚ LED1 glows for this period. The output of IC1 provides supply voltage to IC2 at its pins 8 and 4. On second clap‚ a negative pulse triggers IC2 and its output pin 3 goes high for a time period depending on R9 and C5. This provides a positive pulse at clock pin 14 of decade counter IC 4017 (IC3). Decade counter IC3 is wired here as a bistable. Each pulse applied at clock pin 14 changes the

    Premium Timer Periodization Electronics

    • 327 Words
    • 2 Pages
    Good Essays
Page 1 29 30 31 32 33 34 35 36 50