Lab 3: Reaction Order and Rate Laws Name: Student Lab Partners: None Date of Experiment: 16 March 2014 Location: My House Course Number: CHE112 Abstract: When combining compounds‚ there are always two roles considered in the reaction. These are reactants and products. Reactants are the initial compounds before mixing. The products are synonymous with the term byproduct‚ or what remains when the reaction occurs. For example‚ Sodium (Na+) and Chlorine (Cl-)
Premium Rate equation Chemical reaction Reaction rate
Melissa Carrithers AP Chemistry 12/17/14 Rate Law Determination Pre-Lab Purpose: The purpose of this lab is to observe the reaction between sodium hydroxide and crystal violet so that the order of the reaction could be determined along with the rate constant‚ k‚ and the half-life for this reaction. Hypothesis: If the reaction between crystal violet and sodium hydroxide reacts appropriately‚ then the order will be first order. Procedure: Mix 10 mL of sodium hydroxide and crystal violet solution
Premium Chemistry Rate equation
Decomposing Copper Carbonate Mass of Crucible (g) Mass of CuCo3 added (g) Mass of Crucible + Copper Oxide (g) Mass of CuO produced (g) 0.00 0.25 0.50 0.75 1.00 1.25 What happens to the mass of the copper carbonate when it is heated? Give a conclusion‚ which describes why the mass of copper carbonate may have changed during your experiment. When the copper carbonate is heated it decomposes forming copper oxide and carbon dioxide. The copper carbonate turns into a bright
Premium Copper Oxygen Water
Rates of Chemical Reaction II Pre-Lab Summary: First we will set up the experiment as shown in Figure 2‚ and then we will fill the trough with room temperature water and record the temperature and we will also add the room temperature water to the buret until it is about 10ml from the top. If there are no leaks in the apparatus‚ we will add 10ml of KI to 15ml of distilled water in a 125ml flask. We will swirl the flask so that it achieves room temperature‚ then we will add 5ml of H2O2 and quickly
Premium Chemical reaction
first discovered in England during the year 1808 by Sir Humphry Davy. He was able to separate calcium into a pure metal by doing an electrolysis process on a mixture of lime HgO‚ which is mercuric oxide. However‚ Sir Humphry Davy was not able to do this until after he found out Berzelius and Pontin electrolysed lime into mercury which constructed calcium amalgam. Although he discovered calcium in 1808‚ calcium metal was not available in large amounts until the beginning of the twentieth century. Before
Premium Atom Chemistry Chemical element
2.5 10-5 M 4.9 10-5 M 7.0 10-3 M 3.7 10-2 M 5. What is the pH of the buffer that results when 12.5 g of NaH2PO4 and 22.0 g Na2HPO4 are mixed and diluted with water to 0.500 L? (The acid dissociation constants for phosphoric acid are Ka1 = 7.5 10-3‚ Ka2 = 6.2 10-8‚ and Ka3 = 3.6 10-13) (Points : 10) 2.30 7.04 7.38 12.27 12.62 6. Which of the following combinations would be the best to buffer an aqueous
Premium Acid dissociation constant
area on the Rate of Reaction? By : 22/10/2013 The effect of changing the surface area on the rate of reaction? Unit Question: Should we speed things up or slow them down? Hypothesis: According to collision theory‚ should the surface area increase the amount of collisions increase increasing the rate of reaction. Therefore‚ my hypothesis is that when the surface area increases the rate of reaction increases
Premium Chemical reaction Reaction rate
factors affecting the rate of a chemical reaction. Introduction: In my coursework I will be mainly concentrating on the reaction between dilute hydrochloric acid with marble chips (calcium carbonate). Calcium carbonate (marble chips) + hydrochloric acid ==> calcium chloride + water + carbon dioxide CaCO3(s) + 2HCl (aq) ==> CaCl2 (aq) + H2O (l) + CO2 (g) Aim: The aim of the experiment is to investigate how the concentration of hydrochloric acid affects the rate of reaction with marble chips‚
Premium
Atausch July 28‚ 2014 Bio 102 Lab Final Exam: Acids and Enzymatic Reaction Purpose: To examine how an acidic fluid will modify the outcome of an enzymatic reaction. Introduction: Enzymes are “specialized proteins made by living cells that serve as biological catalysts.” (eScience Labs‚ LLC‚ 2013) These enzymes “allow certain industrial processes to be carried out at normal temperatures and pressures‚ thereby reducing the amount of energy and expensive equipment needed.”(BBC‚ 2012) Enzymatic
Premium PH Enzyme
The solubility of calcium hydroxide Aim: to find out the solubility of a substance that only partially dissolves in water. Method: place about 100cm3 of distilled water in a flask and add about one spatula of solid calcium hydroxide. Stopper the flask and shake well for one minute. Leave to stand for at least 24 hours. Titrate 10cm3 samples against 0.05 mol dm-3 hydrochloric acid solution using methyl orange as an indicator. Obtain enough results to calculate an accurate average‚ and then
Premium Calcium carbonate PH indicator Base