ABSTRACT The purpose if the experiment was to extract the Trimyristan from ground nutmeg using extraction‚ distillation and recrystallization procedures. This experiment involves extraction and separation techniques that yield a purified product. The product was extracted and a distillation process was used to remove any remaining solvent. The recrystallization of the sample in turn produced a pure sample‚ which was proven using the known melting points of the isolated product. Our outcome
Premium Distillation Solvent Temperature
nutmeg with the organic substance‚ diethyl ether‚ to evidently produce trimyristin with a small portion of myristicin (solid-liquid extraction). Also‚ it is good to know that due to impurity the best way purify the product of trimyristin is by recrystallization through hot acetone. NATURE OF REACTION: Power state Trimyristin Myristic acid (tetradecanoic acid) NATURE/MECHANISM OF REACTION: The temperature range should be between 56-57 °C. The organic
Premium Solvent Ethanol Diethyl ether
October 17 & October 24‚ 2012 How is Aspirin Made? This lab is about synthesizing aspirin using a hotplate to heat the reaction. It involved vacuum filtration‚ recrystallization‚ and comparing the properties of aspirin with salicylic aspirin. The first thing we did in this lab was make a hot-water bath by putting a beaker with water on a hot plate. After measuring out 2.1 grams of salicylic acid and 3 ml of acetic anhydride‚ we mixed the two together‚ along with 3 drops of sulfuric acid. We
Premium Chemical reaction Acetic acid Chemistry
objective of this experiment was to illustrate electrophilic aromatic substitution by synthesizing p-nitroanilide (as well as ortho) from acetanilide by nitration. The para form was separated from the ortho form based on solubility properties using recrystallization techniques. Synthetic equations: Physical Properties & Hazards of Reagents/Products: (all taken from Sigma-Aldrich website) Acetanilide MM = 135.16 g/mol Melting point = 113-115°C Hazards: acute toxicity Sulfuric acid MM = 98
Premium Electrophilic aromatic substitution Benzene Sulfuric acid
product was 69.03%. Following recrystallization of the product using xylene and vacuum filtration‚ a percent yield of 37.42% for the recrystallized product was collected. This was low due to the fact that some of the crude product was not recrystallized and was instead used to take a melting point of the crude product. It was also low due to several of the crystals being stuck inside the flask and not going into the funnel. The percent recovery from recrystallization was 54.21%. The melting point
Premium Infrared spectroscopy Erlenmeyer flask Infrared
Recrystallization of Methyl 3-nitrobenzoate Santiago Horta‚ Daniella I School of Chemistry and Biochemistry‚ Georgia Institute of Technology Atlanta‚ GA 30332 Submitted: 18 February 2015 In this experiment‚ the product of a nitration will be purified by recrystallization using a selected solvent. Methyl benzoate is treated with nitric acid and sulfuric acid to obtain methyl 3-benzoate‚ which will be mixed with a solvent that will dissolve the product at its boiling temperature but not at
Premium Chemistry Solid Water
The precipitate was allowed to dry for recrystallization. The product was removed from the filter paper and weighed. The weight of the product was 1.445g. NMR was conducted by mixing the dry product (0.35mg) with duderated chloroform (0.50ml) and mixing until the precipitate dissolved. The sample was then placed into the NMR. The NMR spectrum confirmed the product was benzocaine. The remainder of the sample was placed into a 250ml beaker for recrystallization. Methanol and deionized water were added
Premium Water Distillation Ethanol
C6H5NHCOCH3 + CH3COOH (http://www.mendelset.com/articles/680/preparation-recrystallization-acetanilide) (regensburg.de/Fakultaeten/nat_Fak_IV/Organische_Chemie/Didaktik/Keusch/Grafik/box_brom_ar1.gif) The second figure illustrates the process used in the laboratory to form bromoacetanilide. Recrystallization is of key importance in the experiment because this method is used to obtain the crystals. Recrystallization is a purification technique that removes impurities from a sample. An impure
Premium Acetic acid Oxygen Ethanol
Synthesis of Dulcin Objective: The main objective of this lab is to gain experience at a typical synthesis and semi-microscale recrystallization. Discussion Questions: 1) How fast should the temperature be raised when determining a melting point? When can the temperature be raised more quickly? 2) If there is an Impurity present in a sample‚ what is the effect on the melting point? 3) Explain why a) salt‚ spread on roads in the winter‚ helps prevent icing in‚ for instance‚ southern
Premium Temperature Melting point Water
HEAT TREATMENT OF COPPER AND COPPER ALLOYS COPPER AND COPPER ALLOYS: Copper and its alloys are widely used in many products that are used in our everyday life. They have excellent properties such as electrical and thermal conductivity good strength. They have high corrosion resistance and fatigue resistance. Copper is a non-magnetic material. Pure Copper is soft and used widely in wires and cables and is extensively used for passage of electricity. Copper is used in the building construction.
Premium Bronze Copper Brass