Thermodynamics- Enthalpy of Reaction and Hess’s Law December 5‚ 2011 Kylie Case‚ Emma McKee‚ Rebecca Smith Purpose: In this lab‚ the purpose was to verify Hess’s Law. Theory: Four main topics were covered during this experiment including enthalpy of reaction‚ heat of formation‚ Hess’s Law‚ and calorimetry. The first being enthalpy of reaction‚ ΔHrxn‚ which is the heat or enthalpy change for a chemical reaction. The energy change is equal to the amount of heat transferred at a constant
Free Enthalpy Thermodynamics Energy
Potentiometric Titration of Sodium Carbonate Otieno O. Victor University of Detroit Mercy Quantitative Analysis Lab CHM 3880 Fall 2011 Partner: Edwin Gay Abstract The PH at each point during the titration of sodium carbonate unknown sample was determined. An Unknown sample of Na2CO3 was titrated with a standard HCL solution. In addition to titration‚ the pH at each point of titration was measured using PH meter. The % of the unknown Na2CO3 was 25.83% Introduction1 The purpose of this experiment
Premium Sodium hydroxide Chemistry Titration
corrosive condition results in dissolution. Dissolution of the carbonate minerals calcite‚ aragonite‚ and high-Mg calcite is one of the driving forces for absorption of CO2 into the ocean. Because saturations states of the carbonate system depend immensely on pH‚ minute changes in the ocean pH can drive major changes in the amount of carbonate precipitated and accreted. This change may also impact the integrity of existing carbonate sediments. Decreasing the pH affects the production of CaCO3(s)
Premium Ocean Carbon dioxide Water
Date of Experiment: 6/9/15 Report Submitted: June 10‚ 2015 Title: Observations of Chemical and Physical Changes Purpose: the purpose of this lab experiment is that I will be able to decipher the difference between a chemical and physical change. I will be about to tell whether a chemical change has occurred during the experiment or if it was a physical change and I will be able to answer why it is either one. Procedure: In the lab experiment‚ I mixed different types of chemicals
Premium Chemistry Chemical reaction Hydrochloric acid
The Determination of the Concentration of Hard Water Ions by the Titration of EDTA By Hannah Denby Lab partners: Heidi Kiziah‚ Leonie Hamel University of Central Florida‚ CHM 2046L December 3rd‚ 2015 Abstract. The “hardness” of water is a common dilemma attributed by high concentrations of metals such as calcium and magnesium. This is a result of the properties of water; because it is a good solvent‚ impurities are easily dissolved. As water moves through soil and rock‚ it dissolves minute amounts
Premium Water Chemistry Titration
Physics Lab Report Format General Remarks: Writing a lab report is the only way your TA will know what you have done during the lab and how well you have understood the process and the results. Part of your lab experience should be learning how to organize and present your work in a scientific way. There is no framework that can be used as a “one size fits all”‚ therefore this sample lab report should only be used as an example. Any lab report should have the following features:
Premium Measurement Regression analysis
Engineering Laboratory (Lab) Report Department of Engineering Faculty of Engineering and Science‚ University Tunku Abdul Rahman (UTAR) 1. Introduction Laboratory (Lab) reports are the most frequent document written by engineering student. These reports can contribute a significant amount of marks and yet little time or attention is devoted in understanding on how to write them well. The aim of this document is to provide a general guideline on writing a lab report. A lab report should not be
Premium Present tense Experiment Grammatical tense
CHEMISTRY LAB REPORTS How to Write a Lab Report Lab Reports gives the explanation of the experiment done Lab reports are an essential part of all laboratory courses and usually a significant part of your grade. If your instructor gives you an outline for how to write a lab report‚ use that. Here ’s a format for a lab report you can use if you aren ’t sure what to write or need an explanation of what to include in the different parts of the report. A lab report is how you explain what you did
Premium Theory Experiment Linguistics
The temperature of water was determined by a thermometer. 1 cm stripped ends of the wires was hooked into the input posts on the back of the impendence converter. Lab tutor module was started after. B. Baseline heart rate The top of the container was covered with foil and the animal was allowed to sit quietly for 10 min. The trace was examined by pressing start. After that the baseline or the controlled
Premium Blood Heart Artery
Discussion: The effect of wavelength of light on the rate of photosynthesis was investigated in this experiment. The results from Figure 13 suggest that white light‚ containing all wavelengths of coloured light‚ has the highest rate of photosynthesis. Purple light had the second highest efficiency‚ followed by blue‚ red‚ and yellow light. Green light was significantly less efficient‚ producing the second lowest pH reading (Figure 14). The samples exposed to no light had the lowest rate of photosynthesis
Premium Photosynthesis Light Chlorophyll