Chemistry Write-Up The Thermal Decomposition of Sodium Hydrogen Carbonate Aim: When Sodium Hydrogen Carbonate (NaHCO3) is heated‚ Carbon dioxide and water are given off to leave a white powder. The aim is to find the equations for this reaction. Hypothesis: The experiment will prove which of the equations below is true. It will tell us whether Sodium Carbonate is produced or Sodium Oxide. 2NaHCO3 Na2CO3 + CO2 + H2O 2NaHCO3 Na2O + 2CO2 + H2O Variables: Independent: Original
Premium Carbon dioxide Sodium hydroxide Sodium
and the sodium hydroxide. When using glassware in experiments‚ it must be flushed out to make sure that cross contamination does not happen and that the only thing that would then be coating the beaker is the distilled water. When all of the glassware has been cleaned‚ some sodium hydroxide should be placed in a plastic weighing boat next to the scales and place the second weighing boat on the scales and weigh it then click the on tare button to set it back to zero and weigh out 1g of sodium hydroxide
Premium Water Laboratory glassware Sodium
activity of sodium butyldithiocarbamate pentahydrate‚ C5H20NNaO5S2 Ayodele T. Odularu a‚ Peter A. Ajibade a‚ Bolhuis‚ A. b a. Department of Chemistry‚ University of Fort Hare‚ Private Bag X1314‚ Alice 5700‚ South Africa. b. Department of Pharmacy and Pharmacology‚ University of Bath‚ United Kingdom. Abstract Synthesis of sodium butyldithiocarbamate pentahydrate‚ C5H20NNaO5S2‚ entailed a one-pot synthesis. The process of synthesis involved the use of butyl amine‚ carbon(IV) sulfide and sodium hydroxide
Premium Chemistry Acetic acid Oxygen
Stephanie Thao Chemistry 1151 Laboratory Analysis of acid by titration with sodium hydroxide Ms. Hoang November 2012 Introduction: The purpose of this experiment is to demonstrate an example of how to determine the unknown molarity of hydrochloric acid by titration with a base (sodium hydroxide). Titration is a common laboratory method of quantitative chemical analysis that is used to determine the unknown concentration of an identified analyte (wekipedia). The first step will be measuring
Premium PH PH indicator Chemistry
Enclosures: (1) Data Record (2) Data Treatment (3) Environment Impact Research After hours of vigorous examination‚ we have come to the conclusion that calcium chloride (CaCl2) would be the best deicer to use on a naval base over sodium chloride (NaCl) and ethylene glycol (C2H6O2). In order to melt ice‚ deicers lower the freezing point so that the ice melts at lower temperatures. CaCl2 has a freezing point depression of 5°C‚ whereas NaCl has only a 3°C depression‚ and ethylene
Premium Sodium chloride Water Salt
To investigate the results of the different amounts of sodium bicarbonate (2g‚4‚8g)‚when put in the baking process to produce cupcakes‚obtained by the change of height of a cupcake measured by a ruler‚when baked at 180 degrees celsius for 20 minutes when measured with a ruler. Research question: What will be the result of adding different amounts sodium bicarbonate (2g‚4g‚8g) in a standard (vanilla) cupcake ‚when they are baked at 180 degrees celsius over a period of 20 minutes using an oven thermometer
Premium Chemistry Carbon dioxide Sodium
The Effects Sodium Chloride has on pond water Introduction Ponds are depressions in the ground that fill with water from either run offs or melting snow or rain fall from many different weather changes. There are two types of ponds permanent and temporary. Ponds tend to be much smaller in size and are usually only six to ten feet in depth. This differs from a lake because the size of a lake is much larger and is much deeper. The temperature of a pond is usually the same from top to bottom and
Premium Salt Water Sodium chloride
The rate of reaction between sodium thiosulphate and hydrochloric acid Candidate name: Yeo Jin Kim (Kimberly Kim) Candidate number: 000791-021 Teacher: Yitao Duan 1.0 Aim The aim of this experiment is to investigate the changing of concentration effect the rate of reaction between sodium thiosulphate and hydrochloride. 2.1 Chemical Equation 2.0 Raw data 3.2 Qualitative Data 2.1.1 Before the experiment Substance | Color | State | Smell | Hydrochloride (HCl) | Colorless
Premium Chemical reaction Sodium Chemistry
Title: Preparation and Standardization of a Sodium Hydroxide Solution Objective/Purpose: The objective of this experiment will be the standardization of sodium hydroxide using potassium hydrogen phthalate by the titration method. Introduction: The concentration of solutions can be reported in terms of molarity and normality. Molarity is equal to: HCL‚ HBR‚ H2SO4‚ HNO3 M = mol Solute (mol) (Monoprotic) (Diprotic) _______________ V(L)g solutions (L)
Premium Sodium hydroxide Acid Titration
covalent compound because both hydrogen and iodine are nonmetals. 6) Why would the bulb light up when placed in an aqueous solution of sodium chloride but not in a solid sample of sodium chloride? In a solid sample of sodium chloride‚ sodium and chloride are bonded together ionic and so there aren’t any free electrons to support the flow of electricity. When sodium
Premium Ionic bond Chemistry Sodium chloride