determine the unknown concentration of potassium permanganate (KMnO4) solution by finding its absorbance through the use of spectrophotometer. The preparation of four known concentration of KMnO4 was done namely‚ 2.00×10-4M‚ 1.50×10-4M‚ 1.00×10-4M‚ 5.00×10-5M‚ respectively and is to be place on the spectrophotometer with the unknown and distilled water for the determination of each concentration’s absorbance. As the concentration is proportional with the absorbance of the solution‚ to determine the
Premium Spectroscopy Chemistry Light
Purpose: The purpose of this was to determine the concentration of sodium carbonate in an unknown sample by titration. The solution of hydrochloric acid was prepared and standardized using Na2CO3. Observations: Week 1: Standardizing hydrochloric acid using sodium carbonate with bromocresol green indicator Table 1: Titration of sodium carbonate using hydrochloric acid Trial | Mass of Na2CO3 (g) | Burette Reading (mL) | Final Volume of HCl (mL) | | | Initial | Final | | 1
Premium Titration Hydrochloric acid PH
Date Performed: January 10 & 15‚ 2013 Spectrophotometric Determination of the Equilibrium Constant of a Reaction R.J.V. Ortega and J.C.V. Gatdula Institute of Chemistry‚ College of Science University of the Philippines‚ Diliman‚ Quezon City‚ Philippines Received January 22‚ 2013 ------------------------------------------------- ------------------------------------------------- ------------------------------------------------- ABSTRACT -------------------------------------------------
Premium Chemical equilibrium Concentration Chemistry
Spectrophotometric Determination of Equilibrium Formal Report Matt DeLuca The Department of Chemistry‚ SUNY College at Brockport Brockport‚ NY 14420 CHM 206.04 Abstract: The main objective of this experiment was incorporating the use of spectrophotometry in an attempt to study the position of equilibrium. Furthermore‚ after the completion of this experiment‚ the formation of the equilibrium constant of the iron thiocyanate complex
Premium Mathematics Concentration Solution
EXPERIMENT 1 DETERMINATION OF ASCORBIC ACID CONTENT IN VITAMIN C TABLETS INTRODUCTION To calculate the mass of the ascorbic acid and hence the mass percentage of ascorbic acid in the vitamin C tablet. PROCEDURES (Refer to Lab Manual) 1. Accurately weight vitamin C (effervescent type) in a 50 ml beaker. Add about 30 ml of deionised water to dissolve the vitamin C tablet. Once the tablet has dissolved completely‚ transfer the solution into a 250 ml volumetric flask via a plastic filter
Free Laboratory glassware Titration Vitamin C
Titration Lab A Titration is a process of the concentration of one solution being determined by its reaction with either a standard solution or a known quantity of solid dissolved in solution. It may also be used to calculate the molar mass of an unknown acid or base. Purpose: I. Prepare a standard solution of sodium hydroxide II. Standardize a sodium hydroxide solution by using potassium hydrogen phthalate (KHP) III. When given whether the acid is monoprotic‚ diprotic‚ or triprotic ‚ determine
Premium Chemistry Sodium hydroxide Base
concentrain of sulphuric acid Aim The point of this investigation is to find out the concentration of the sulphuric acid in my experiment. I will do this by titrating the sulphuric acid with sodium carbonate. H2SO4 + Na2CO3 à Na2SO4 + H2O + CO2 Acid + Alkali à Salt + Water + Carbon dioxide Ratio of sulphuric acid to sodium carbonate: H2SO4 : Na2CO3 1 : 1 Concentration of sulphuric acid: H2SO4 is approximately 0.05 - 0.15 moldm-3 The average concentration of the sulphuric acid is: 0.05 + 0.15 =
Free Titration Laboratory glassware Sodium carbonate
SPECTROPHOTOMETRIC DETERMINATION OF EQUILIBRIUM CONSTANT OF A REACTION UNIVERSITY OF THE PHILIPPINES‚ DILIMAN QUEZON CITY‚ PHILIPPINES August 2‚ 2013 ABSTRACT The objective of this experiment is to determine the equilibrium constant‚ denoted Keq‚ for the formation of [Fe(SCN)]2+ complex which is a product of the reaction between the ions Fe3+ and SCN-. In performing this experiment‚ solutions containing FeCl3 and KSCN‚ diluted in HCl‚ were measured for their absorbance using a UV-Vis
Premium Concentration Chemical reaction Chemical equilibrium
The unknown carboxylic acid’s melting point was 108°C according to the Mel-Temp machine. The melting point is the temperature at which a solid precipitate changes into its liquid form upon heating. The melting point of benzoic acid‚ the aromatic carboxylic acid was 122°C. Thus‚ the product contained impurities which caused the solid to melt at a lower temperature than the actual temperature. Pure solids typically melt at higher temperatures while impure solids melt at lower temperatures. This is
Premium Temperature Water Liquid
Procedure: Melting point of RCO2H Before observing the melting point of the unknown sample‚ the melting apparatus had to be standardized with a standard substance having the melting point of 151°C-153°C. After placing a small sample of the standard in a capillary tube and inserting the tube into the sample tube holder‚ the plateau on the device was set to 15°C below the expected melting point. After its temperature reached the plateau‚ the temperature increment was set at 1°C per minute‚ and the
Premium PH Titration Laboratory glassware