Quiz Top of Form Previous PageNext PagePage 1 of 4 Note: It is recommended that you save your response as you complete each question. Question 1 (2.7 points) The combustion of butane‚ C4H10(g)‚ produces carbon dioxide and water vapor. In the balanced equation for this reaction‚ what are the coefficients of butane‚ oxygen‚ carbon dioxide‚ and water‚ respectively? Question 1 options: 2‚ 13‚ 4‚ 10 1‚ 6‚ 4‚ 5 1‚ 6‚ 8‚ 10 1‚ 13‚ 4‚ 5 2‚ 13‚ 8‚ 10 Save Question 2 (2.7
Premium Oxygen Hydrogen Nitrogen
Get all the equipment’s ready and put them on a table. Take a pair of goggles and put them on and make sure hair is tied up‚ if long‚ using any sort of hair band. Take the 100ml glass beaker and place it under the water tap’s opening‚ the place where the water comes out from‚ then turn the tap on. Do not turn the tap off until the water inside the beaker reaches the 50ml mark‚ to ensure that there is only 50ml of water in the 100ml beaker. Then take the beaker and place it somewhere safe on the table
Premium Water Chemistry Oxygen
The progress of the reaction was monitored in my case using two TLC plate. It first started off with the spotting of Standard benzoin and benzil which were provided in the lab and followed by the addition of the reaction mixture at once it starts changing colour/boiling‚ then at 10 and 20 mins into the reflux. Once all the necessary steps were spotted‚ the TLC plate was placed in in a beaker containing CH₂Cl₂(methylene chloride)‚ which was used as the developing solvent in this experiment. To check
Premium Chemistry Chemical reaction Thin layer chromatography
Using Stoichiometry to Determine Gases Produced in a Reaction Introduction Magnesium is a metal and is the third most commonly used metal by chemists. Some would say it is the least dense structural metal. Its lightness is often alloyed with aluminum. Magnesium is also used in racing car wheels called MAG wheels. Many car-manufacturing companies will use magnesium and aluminum because of the lightness of the metal. Both of these metals are reactive with acids. The most common acid in they
Premium Pressure Gas Hydrogen
Investigating Stoichiometry with Sodium Salts of Carbonic Acid Introduction: The student will perform the experiment in order to find the percent yield by using the theoretical value found using the balanced equation for sodium carbonate as well as sodium bicarbonate. The objective is to stabilize the substances by titrations and finding the percent yield when all the data is collected. The purpose of this procedure is so that the student will get better understanding of stoichiometry. The student
Premium Hydrochloric acid Sodium carbonate Sodium
Lab #18 Stoichiometry In this lab‚ we reacted aluminum foil with a copper chloride solution‚ and determined the amount of metal that should be produced‚ given the amount of aluminum used. First‚ we obtained a piece of aluminum with a mass of 0.809 g‚ and reacted it with 100 mL of Copper II Chloride‚ after heating the solution. Then‚ we filtered out the copper separated in the reaction using filter paper‚ massing 0.751 g. Once all the solution was filtered‚ we massed the new filter paper filled with
Premium Chemistry Chemical reaction Hydrogen
something + 2Fe+2 Equation 2: 8H+ + 5Fe+2 + MnO4- --> 5Fe+3 + Mn+2 + 4H2O Equation 3: 6H+ + 2MnO4- + 5H2C2O4 --> 2Mn+2 + 10CO2 + 8H2O Conclusion: Therefore the concluded reaction would be: NH3OH+ + 2Fe+3 --> N2O + 2Fe+2 This was obtained by using stoichiometry half reactions the product of that reaction was determined to be N2O. Some systematic errors could be if the wrong molarity was determined for the permanganate because then that would though off the calculations for the Fe+2 and the rest of the
Free Manganese Mole Potassium permanganate
1. What is the molarity of a solution of ammonium chloride prepared by diluting 50.00 mL of a 3.79 M NH4Cl solution to 2.00 L? 2. A student takes a sample of KOH stock solution and dilutes it with 100.0 mLof water. The student determines that the diluted solution is 0.046 M KOH‚ but has forgotten to record the volume of the original stock solution sample. The concentration of the stock solution is 2.09 M. What was the volume of the original sample of stock solution? 3. A chemist wants to prepare
Premium Ammonia Concentration Sulfuric acid
Stoichiometry 04/09/12 Chemistry I B Ms. Norton Introduction/Pre-laboratory Assignment: 1. Write out and balance each of the following equations. A. CuSO4 + Fe Cu + FeSO4 B. 3CuSO4 + 2Fe 3Cu + Fe(SO4)3 2. If Iron (III) Sulfate were formed‚ what mass of Copper would be expected and what is the limiting reagent? C. 2.26 g Cu D. Fe 3. If Iron (II) Sulfate were formed‚ what mass of Copper would be expected and what is the limiting reagent?
Premium
Experiment 7 INVESTIGATING STOICHIOMETRY WITH SODIUM SALTS OF CARBONIC ACID Introduction In this experiment we are going to get a better understanding of chemical stoichiometry. We are going to be reacting sodium bicarbonate (NaHCO3) and sodium carbonate (Na2CO3) with hydrochloric acid (HCl). To start off the mass of two unknown substances (being the sodium bicarbonate and sodium carbonate) will be taken. We will need to construct balanced equations for both of the reactants with the HCl and
Premium Hydrochloric acid Sodium chloride Chlorine