Date Performed: September 9 ‚2011 SPECTROPHOTOMETRIC DETERMINATION OF THE ACID DISSOCIATION CONSTANT OF METHYL RED M.C. Caligagan ‚M.N.Q. Tolentino and M.Q. Clores Institute of Chemistry‚ College of Science University of the Philippines‚ Diliman‚ Quezon City‚ Philippines Received :September 21‚2011 ABSTRACT This experiment aims to determine the acid dissociation constant value of Methyl Red by means of spectrophotometry. Ten samples were spectrophotometrically analyzed under a UV-Vis
Premium Acid dissociation constant
In this experiment‚ we used methyl benzoate from the last experiment with HNO3 and H2SO4 to synthesize methyl 3-nitrobenzoate. First we added methyl benzoate to 12 mL cooled conc. Sulfuric acid in a flask. In a separate flask‚ we made a solution of 4 mL conc. Sulfuric acid and 4 mL nitric acid and then added dropwise to the solution of methyl benzoate in an ice bath on a stir plate while maintaining the temperature of reaction between 5-15 °C. After the addition was complete we took the flask out
Premium Water Chemistry Acetic acid
began by weighing 4.0ml of methyl salicylate into a flask—a stir bar was added. While stirring‚ 40ml of 6M sodium hydroxide was added and the solution was heated and boiled for about 15 minutes. After the 15 minutes‚ a bit of water was used to wash down the sides of the flask and the solution was cooled. It was boiled for another 15 minutes‚ after this the solution was cooled for 5 minutes in an ice water bath. While the flaks was in the ice bath‚ 50ml of 6M hydrochloric acid was added in 5ml increments
Premium Chemistry Water Acetic acid
Unit 4 Assessment 2-Benzoic Acid Synthesis Synthesis and Investigation of Benzoic Acid Our aims: Create benzoic acid using benzaldehyde and hydrogen peroxide. Then remove some impurities from the benzoic acid crystals. Apparatus: Titration Pipette (25 cm3) Burette (50 cm3) Retort stand Clamp Conical flask (250 cm3) Volumetric flask (250 cm3) and stopper White tile Beakers (250 cm3) Dropping pipette Filter funnel Deionised water Phenolphthalein indicator Volumetric flask
Premium Chemistry Water Sodium hydroxide
family‚ a group of compounds that possess antibacterial and antifungal properties. These agents are esters of para-hydroxybenzoic acid‚ which is why they are collectively called parabens. However‚ in contrast to its cousins‚ ethylparaben‚ butylparaben‚ and propylparaben‚ methylparaben receives its specific name owing to the fact that its chemical structure contains the methyl alkyl group. Methylparaben is found in several fruits‚ in particular blueberries‚ where it acts as an antimicrobial agent. Methylparaben
Premium
Glen Huang Period 9 Synthesis of Isopentyl Acetate Purpose: To prepare isopentyl acetate from isopentyl alcohol and acetic acid by the Fischer esterification reaction. Materials: West condenser‚ 250 mL round bottomed flask‚ two 250 mL flasks‚ heating mantle‚ boiling chips‚ graduated cylinder‚ sodium bicarbonate‚ isopentyl alcohol‚ glacial acetic acid‚ concentrated sulfuric acid‚ separatory funnel Procedure: 1. Place 50 mL of isopentyl alcohol in a 250 mL round bottom flask and add 60 mL
Premium Ester Acetic acid Oxygen
In this experiment the initial mass of the sodium carbonate used was 2.69g. In each titration‚ 3 drops of methyl orange was added to the sodium carbonate solution. With this information the titration can begin‚ and the results obtained are shown below: Titration readings Titration Rough 1 2 3 4 5 Initial 0.00 4.30 22.00 21.00 15.00 25.90 Final 4.30 22.00 38.60 37.60 32.60 42.20 Titre (cm3) 4.30 17.70 16.60 16.60 17.60 16.30 Therefore‚ the average titre would be calculated as follows;
Premium Titration Chemistry Mole
Hydrocinnamic acid underwent bromination using N-bromosuccinimide and AIBN. As one lab partner set up the reflux apparatus‚ the other measured the chemicals used in the lab experiment. 2.10 g of hydrocinnamic acid was used. It was observed as white and had a slight cinnamon smell. The amount of NBS was 2.49g and was measured in the fume hood. AIBN was measured at .030 g. 10 mL of acetic acid was also obtained. The reflux apparatus consisted of a 25 mL flask with a stir bar in a water bath. The chemicals
Premium Chemistry Water Sodium hydroxide
This solution served as the source of ionic Iron for the remainder of the lab and was labeled “stock ionic Iron solution.” Next‚ a 50-mL aqueous ionic Iron and FerroZine® complex solution was prepared by adding 5.00mL stock ionic Iron‚ 3-mL of acetic acid buffer‚ 2-mL of 5% hydroxylamine hydrochloride‚ allowing five minutes for hydroxylamine to reduce Fe3+ to Fe2+‚ adding 2.5-mL of 0.01 M FerroZine® solution‚ and mixing well. A single beam Agilent technologies CARY60-UV-Vis Spectrophotometer was then
Premium Chemistry Titration Water
which both prove the erythro-2‚3-dibromo-3-phenylpropanoic. Determination of the Stereochemistry of 2‚3-dibromo-3-phenylpropanoic acid. Introduction The purpose of this experiment was to determine the mechanism of the reaction of trans-cinnamic acid with the addition of bromines to 2‚3-dibromo-3-phenylpropanoic acid. An addition of bromine was added to trans-cinnamic acid and it is necessary to determine whether the intermediates were syn or anti addition or a mixture of them both to find the stereochemistry
Premium Chemistry Chemical reaction Temperature