"Unknown lab report on staph aureus" Essays and Research Papers

Sort By:
Satisfactory Essays
Good Essays
Better Essays
Powerful Essays
Best Essays
Page 20 of 50 - About 500 Essays
  • Good Essays

    Unknown Organism Report Unknown Organism # 4 Klebsiella pneumonia Klebsiella pneumonia has a rod gram stain with the agar slant cultural characteristics being slimy‚ white‚ somewhat translucent‚ raised growth. It is small gram-negative coccobacilli that can cause lobar pneumonia. The litmus milk reaction is acid‚ gas‚ and curd with a variable reaction. Klebsiella can grow either in the presence or absence of oxygen because of its nature of being a facultative anaerobe. Oxygen is a preferred energy

    Premium Bacteria Microbiology Gram staining

    • 595 Words
    • 3 Pages
    Good Essays
  • Powerful Essays

    Guidelines for Lab Report

    • 913 Words
    • 4 Pages

    Engineering Laboratory (Lab) Report Department of Engineering Faculty of Engineering and Science‚ University Tunku Abdul Rahman (UTAR) 1. Introduction Laboratory (Lab) reports are the most frequent document written by engineering student. These reports can contribute a significant amount of marks and yet little time or attention is devoted in understanding on how to write them well. The aim of this document is to provide a general guideline on writing a lab report. A lab report should not be

    Premium Present tense Experiment Grammatical tense

    • 913 Words
    • 4 Pages
    Powerful Essays
  • Good Essays

    Lab Report

    • 5790 Words
    • 24 Pages

    EXPERIMENT NO. 1 INTRODUCTION TO LAB INSTRUMENTS. 1. BREADBOARD We should be familiar to the following things about a breadboard: * What is a breadboard and what is it used for? * How does it work? * Setting Up. * Limitations. What is a breadboard and what is it used for? A breadboard (or protoboard) is usually a construction base for prototyping of electronics. The term "breadboard" is commonly used to refer to a solderless breadboard (plugboard). It was designed by

    Premium Voltage Direct current Alternating current

    • 5790 Words
    • 24 Pages
    Good Essays
  • Good Essays

    The identification of an unknown bacterial environmental isolate through a series of morphological‚ physiological and differential exercises. The purpose of the environmental isolate report is to learn what is necessary in order to take an unknown environmental isolate (EI) and identify it. This was achieved through a series of exercises that provided information on the morphological‚ physiological and biochemical traits of the EI which were then compiled and interpreted in order to make a presumptive

    Premium Bacteria Microbiology Gram staining

    • 1295 Words
    • 6 Pages
    Good Essays
  • Better Essays

    Antimicrobial Lab Report

    • 1105 Words
    • 5 Pages

    purpose of antimicrobial drugs is either to inhibit virus replication‚ without harming host tissues or to interrupt the cell processes or structures of bacteria‚ fungi‚ and protozoa. This lab has brought great interest to me because this is the way physicians’ control/treat infectious disease within our bodies. In this lab‚ chemotherapeutic agents were evaluated by the disk-diffusion method. Chemotherapeutic agents are placed on the surface of a Petri plate containing Mueller-Hinton agar‚ which allows

    Premium Management Marketing German language

    • 1105 Words
    • 5 Pages
    Better Essays
  • Good Essays

    and Melting Points Organic Chemistry 2423 Lab Report: Recrystallization Abstract: The purpose of this lab was to purify an unknown compound by recrystallization. Taking an unknown compound and identifying it by purifying it from its impurities through the use of hot gravity filtration. Then to determine the unknown you were to take the melting point. An unknown compound was recrystallized from hot water to produce 0.99 grams (67% recovery). The pure unknown compound had a melting point of 127.0-128

    Premium Temperature Solubility Solid

    • 1030 Words
    • 4 Pages
    Good Essays
  • Good Essays

    Lab Report Enzyme Lab

    • 743 Words
    • 3 Pages

    Abstract: The Enzyme Lab results where when the liver was frozen‚ its reaction was fast‚ and when it was hot‚ it was slow‚ and the liver that was at room temperature reacted slowly to medium. Introduction: The Enzyme Lab is to conduct investigations to determine the most favorable conditions for the most efficient enzyme activity. Variables to be used testing include temperature‚ pH values and surface area. Enzymes are proteins that speed up the rate of chemical reactions‚ which would otherwise

    Premium Enzyme Chemical reaction Chemistry

    • 743 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Micro Lab Report

    • 1156 Words
    • 5 Pages

    Lab Report Microbiology Introduction Bacteria can be found almost anywhere. For human life‚ some help us‚ some hurt us‚ and others are neutral. It is now known that good bacteria‚ or normal microflora‚ can reach 1014 microbial cells. This is far more than the 1013 cells that make up the human body (Tannock‚ 1995). The total number of bacteria on Earth is estimated to be around 4-6 x 1030 (Horner-Devine‚ 2004). It is important to know the extent of bacteria‚ how they live‚ and how they are

    Premium Bacteria Microbiology Immune system

    • 1156 Words
    • 5 Pages
    Good Essays
  • Satisfactory Essays

    Lab Report Info

    • 327 Words
    • 2 Pages

    Lab Report Procedure 6.1: Perform Benedict’s test for reducing sugars. Introduction: Benedict’s tests allows for the detection of the presence of reducing sugars. All monosaccharides are reducing sugars since all of them have active carbonyl group. Some disaccharides that are exposed to a carbonyl group are also reducing sugars but less reactive than monosaccharides. By mixing the sugar solution with Benedict’s solution and heating them‚ a redox reaction will occur. The copper (II) sulphate

    Free Glucose Carbohydrate Sucrose

    • 327 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Lab Report

    • 1635 Words
    • 7 Pages

    City University of Hong Kong Dept. of Physics & Materials Science AP2104 Mechanics of Solids Laboratory Manual Experiment 1 Pure Bending of a Beam Experiment 2 Torsional Deformations Experiment 3 Yield Criteria for Ductile Materials under Plane Stresses Experiment 1 Pure Bending of a Beam Objective 1. To examine the stresses at various positions of the beam under a constant load of pure bending. 2. To determine the curvature of deflection of the beam. Introduction

    Premium Force Torque Shear stress

    • 1635 Words
    • 7 Pages
    Satisfactory Essays
Page 1 17 18 19 20 21 22 23 24 50