"Volt" Essays and Research Papers

Sort By:
Satisfactory Essays
Good Essays
Better Essays
Powerful Essays
Best Essays
Page 22 of 50 - About 500 Essays
  • Satisfactory Essays

    Transformers

    • 1622 Words
    • 7 Pages

    voltages at the secondary terminals. Standard tap arrangements are at two-and-one-half and five percent of the rated primary voltage for both high and low voltage conditions. For example: if the transformer has a 480 volt primary and the available line voltage is running at 504 volts‚ the primary should be connected to the 5% tap above normal in order that the secondary voltage be maintained at the proper rating. Ques-3: What is the difference between “Insulating”‚ “Isolating” and “Shielded Winding”

    Premium Transformer Alternating current

    • 1622 Words
    • 7 Pages
    Satisfactory Essays
  • Good Essays

    Circuits Circuit Analysis

    • 2706 Words
    • 17 Pages

    Name: Period: Circuits-Circuit Analysis Base your answers to questions 1 through 3 on the information and diagram below. 4. A 9-volt battery is connected to a 4-ohm resistor and a 5-ohm resistor as shown in the diagram below. A 3.0-ohm resistor‚ an unknown resistor‚ R‚ and two ammeters‚ A1 and A2‚ are connected as shown with a 12-volt source. Ammeter A2 reads a current of 5.0 amperes. What is the current in the 5-ohm resistor? 1. 1.0 A 2. 1.8 A 3. 2.3 A 4. 4.0 A 1. Determine the equivalent

    Premium Circuit diagram Electric current Resistor

    • 2706 Words
    • 17 Pages
    Good Essays
  • Good Essays

    Milgram Experiment

    • 414 Words
    • 2 Pages

    assigned to be a learner and a teacher. Milgram created an electric ’shock generator’; it ranged from 15-450 volts. The teachers were given a task to teach and then test the learner on a list of word pairs. For the first wrong answer‚ the teacher will flip the switch labeled "15 volts". If the learner continues making mistakes‚ he will moved to the next higher level‚ with the maximum of 450 volts. If the teacher obey‚ he will hear the learner shriek in apparent agony as you continue to raise the shock

    Premium Stanford prison experiment Psychology Milgram experiment

    • 414 Words
    • 2 Pages
    Good Essays
  • Good Essays

    supply chain

    • 1052 Words
    • 4 Pages

    Bread-board 6- Connection Wires and coaxial cable Probes PART A – Using Oscilloscope and Function Generator 1- Turn on the Oscilloscope‚ choose CH1 from the Vertical Mode (to display only channel 1 signal). Set the Oscilloscope’s “Volts/Division” knob for “channel 1” to 2V/DIV‚ and set the sweep “Seconds/Division” knob to 0.2 ms/DIV. 2- Set the coupling switch (AC/DC/GND) to GND and move the trace to the middle of the screen. When you finish set the coupling switch to AC again.

    Premium Voltage Alternating current

    • 1052 Words
    • 4 Pages
    Good Essays
  • Good Essays

    Potato Battery

    • 797 Words
    • 4 Pages

    many potatoes does it take to light a 0.70-volt bulb or three (3) 0.24-volt bulbs?  Is it possible for potatoes to be utilized to sustain the electricity we have today? II. Hypothesis a. Null Hypothesis ( H0) Potatoes are ineffective sources of electricity as it cannot produce enough voltage to light a 0.70-volt bulb. b. Alternative Hypothesis (Ha) Potatoes are effective sources of electricity as it can produce enough voltage to light a 0.70-volt bulb. III. Materials And Procedure

    Premium Copper Incandescent light bulb Renewable energy

    • 797 Words
    • 4 Pages
    Good Essays
  • Satisfactory Essays

    highest concentration (1.5 mol dm-3 ) was the lowest out of the 3 trials at 1.68 volts‚ thus proving that the higher concentration the lower the voltage. When the concentration of the product decreases‚ it will drive the equilibrium to the right to minimize the impact. Although‚ the lowest calculation (0.5 mol dm-3) is not necessarily the highest out of all 3 trials‚ it is not far off from 1 molar solution‚ only 0.2 Volts. The system’s attempt to remain at equilibrium by minimizing the impact‚ refers

    Premium

    • 344 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Milgram Study

    • 532 Words
    • 3 Pages

    violations found in the original experiment (1962) included participants (teacher) giving other participants (learner) dangerous electrical shocks at a very high voltage increasing all the way up to 450 volts. The experimenter (authority) informed both the teacher and the learner participants that although the volts may be painful‚ they are not dangerous. Even though the “teacher” could hear the “learner” yell and scream as they got shocked each time‚ the “teacher” continued with the experiment because the

    Premium Experiment Psychology Stanford prison experiment

    • 532 Words
    • 3 Pages
    Good Essays
  • Good Essays

    instructed by Milgram‚ then the experimenter would tell the participant to administer electric volts‚ starting at 15 volts‚ eventually reaching 450. None of the volts were real‚ but the learner acted as if they were so the participant believed they were shooting electric volts through the learner. Milgram carried out this study to see how far someone would go when given instructions by an authority figure. At 150 volts the learner demanded to be released his heart’s starting to bother him now‚ at 180 the

    Premium Sociology Psychology Social psychology

    • 900 Words
    • 4 Pages
    Good Essays
  • Better Essays

    Stanley Milgram carried out one of the most famous studies of obedience in psychology. He was a psychologist at Yale University‚ conducting an experiment that focused on the conflict between obedience and morality. It showed that people have a strong tendency to obey with authority figures. Milgram was interested in researching how far people would go in obeying an order even if it involved harming another individual. He was fascinated on how easily ordinary people could be influenced in committing

    Premium Milgram experiment Stanford prison experiment Stanley Milgram

    • 954 Words
    • 4 Pages
    Better Essays
  • Satisfactory Essays

    ECG MONITORING

    • 331 Words
    • 2 Pages

    0-5v volt. The output of sensors in terms of milli volts‚ then the milli volt output will be amplified with the help of the suitable amplifier. Then the amplified signal will be in the range of 0 to 5 volts. Then it will be given to the ADC (analog to digital converter)‚ this will convert the analog voltage into digital data. The ADC‚ which we are going to use is ADC0809‚ it is an eight channel eight bit ADC. This will produce 00H (00000000B) for 0 voltage and FFH (11111111B) for 5 volts.

    Premium Digital

    • 331 Words
    • 2 Pages
    Satisfactory Essays
Page 1 19 20 21 22 23 24 25 26 50